in Techline cases with a complaint related
to “A/T up-shifting hard” in most gears.
Further investigation has revealed that
most of these occurred after performing
TSB TRA 058 / SA 208 using Manual
Mode and possibly having, inadvertently,
entered an incorrect PCM/TCM part
number. In some cases, transaxles have
already been replaced without condition
improvement.
Prior to replacing a transaxle for a similar
customer concern, check current ROM ID
number using GDS/KDS.
NOTE: pay close attention to the wheel
size reference information associated
with PCM/TCM Part numbers.
If the ROM ID is not correct, reference the
ROM ID information table (at right), the
PCM/TCM can be corrected by performing
another Manual Mode reflash. However,
please ensure the correct PCM/TCM
part number is selected to prevent any
further drivability concerns and verify
that the correct ROM ID is loaded after
the reflash has been completed.
NOTE: TSB TRA 058/SA 208 will be
updated with additional information.

Fig. 1. Wheel size reference indicated within red border.

Model

SYS

Sedona
(YP)
TCM
3.3 GDI
A/T

TCM P/N

Wheel Size

39110 3CYN2
39111 3CYN2
39100 3CYN2
39101 3CYN2
39110 3CYN2
39111 3CYN2
39100 3CYN2
39101 3CYN2

Please refer to PitStop PS 441. n

PITSTOP

ROM ID
Previous

New

17" or 18"

TYPOZ33N******S0

TYP0Z33N******S1

19"

TYPAZ33N******S0

TYPAZ33N******S1

ROM ID information table.

FRONT SEAT HEATER INOPERATIVE (2016MY SORENTO)

When diagnosing a customer concern of an inoperative seat
heater, first, identify the type of system the vehicle is equipped
with — Seat Heater Only, or Seat Heater with Ventilation. Then,
follow steps below:
1. Start by function testing the system until the seat is warm to
the touch.
2. If during the test, the indicator lamp on the switch turns off
and will not illuminate again until cycling the ignition, inspect all
associated wiring harness connections for poor pin tension, and
for any loose, bent, or backed out pins, prior to replacing ANY
components.

NOTE: The control module associated with BOTH front seat
heaters (regardless of type of system installed) is located
under the PASSENGER seat. To prevent a misdiagnosis, ensure
connections are inspected at this location, even if the customer’s
concern is related to the driver’s seat.
3. If no abnormal condition is found, proceed with a resistance test
of each branch of the circuit associated with the malfunctioning
circuit. If no abnormal condition is found, inspect the resistance
of the seat heater elements (cushion and seat back), as well as
the thermostat (thermistor). Resistance specifications can be
found in the shop manual, under Body
Electrical > Seat Electrical > Seat Heater
Repair Procedures.
Please refer to PitStop PS 444. n

12

TECH TIMES • Vol 19, No. 1•2016

PITSTOP

USE OF AFTERMARKET USB CHARGING CABLES (ALL MODELS)

Use of Aftermarket Charging Cables in USB/12V Ports (All
Models) — This article provides information regarding the use
of USB ports and 12V power outlets to connect/charge mobile
phones. Customers may experience issues with their head units
that may be related to the use of aftermarket USB charging
cables, including;
• Electrical interference and limited or no functionality when
attempting to play music, or when charging a device through
the USB port
• Excessive static or noise when listening to the audio source
• Malfunctions and screen freeze of the head unit screen
• Slow down of the system response while device is plugged in
• Music will not play from iPhone 5 or 6 with Kia iPod cable and
aftermarket adapter
• No or limited functionality when trying to play music from an
Apple device

The following three topics are covered in this article:
1. Using phone USB cables to charge and connect devices to
play music or for use with features such as Android Auto:
2. Using 12V chargers to charge mobile devices
3. Recommendations for using USB port to play music from
iPhone 5 or 6 in older model/year Kia Vehicles.

1. Using phone USB cables to charge and connect devices to
play music or for use with features such as Android Auto:
• Recommendation is to always use the USB charging cable
that was provided with the phone or a replacement cable
from the phone manufacturer.
• Use of aftermarket USB cables is NOT recommended.
• Plugging in larger devices, such as iPads and other tablets, is
NOT recommended as they may draw a higher current when
charging (refer to PitStop PS 276).
NOTE: USB devices should always be connected only after
turning the engine ON and disconnected prior to turning the
engine OFF.

2. Using 12V chargers through the power outlet to charge
devices:
• The use of aftermarket 12V chargers (fig. 1) is NOT
recommended.
NOTE: use of some 12V-to-USB adapter chargers has been
confirmed to cause issues in some vehicles.
• The Recommendation is to ALWAYS use the USB charging
cable supplied by the phone manufacturer (e.g. Apple,
Samsung, etc.) or an approved carrier supplied 12V charging
cable (for instance a Verizon branded charger for iPhone
products)
• ONL Y plug in battery equipped electronic devices with
reverse current protection or current from the battery
may flow into the vehicle’s electrical system and cause a
system malfunction
• Any devices plugged in to the 12V charging cable should draw
less than 10 amps from the system, when the engine is
running
3. Recommendations for using USB port to play music from
iPhone 5 or 6 in older MY Kia Vehicles:
• For certain older MY vehicles, Kia offers an accessory OEM
iPod cable (P/N: P8620 00000) that is recommended for
with some models/head unit platforms.
NOTE: reference TSB General 054 for specific application.
• Based on testing of some AVN platforms, it is possible to
use the official Apple lightning adapter with the Kia OEM
iPod cable to obtain functionality in older MY vehicles.
However, compatibility is NOT guaranteed as those vehicles
were designed and manufactured prior to Apple’s release
of these new phones and Apple continues to release new
software for these phones.
• Based on limited testing, use of aftermarket Lightning
adapters resulted in no, or limited, functionality in the older
models and is NOT recommended.
Please refer to
PitStop PS 443. n

Fig. 2: Kia OEM
iPod cable

Fig. 1: Aftermarket USB adapter

Fig. 3: Apple
Lightning Adapter

13

TECH TIMES • Vol 19, No. 1•2016

KDS

TIPS TO INCREASE BATTERY LIFE
TURN “LOCATION” OFF

This article provides suggestions that may help to extend battery life
of the KDS tablet under normal usage. Any unnecessary functions
running in the background depletes battery power. Follow the topics
below to maximize battery range. These include:
•
•
•
•
•
•
•

The tablet will no longer search for the location which will increase
battery life.
1.

Turn the KDS tablet OFF when not in use
Remove Un-needed applications
Turn VCI Search OFF
Turn “Vibrate” mode OFF
Turn “Location” OFF
Turn “Power Saving” ON
Turn down display brightness

2. Select “Location”

To turn the tablet OFF, press and hold the Start button
for about 1 second.

As the brightness increases the display uses more power.

1

1.

3

Deselect “Auto”

6

.

2. Adjust the brightness 7 as low as possible while you can still
comfortably see the screen.

2

3. Press the Start button

to turn OFF this function.

TURN DOWN DISPLAY BRIGHTNESS

The KDS will continue to use power when left in sleep mode.

2. Select “Power Off”

5

5

TURN THE KDS TABLET OFF WHEN NOT IN USE
1.

Slide down from the top of the screen to access settings.

to restart the KDS.
1

3

2
7

6

REMOVE UNNEEDED APPLICATIONS
4

TURN VCI SEARCH OFF

Some applications on the home screen constantly ping for information
which uses power.

By turning OFF the VCI search function, when
the VCI is not needed, battery power is saved.
1.

1.

Select the “VCI” soft key 4 to turn
the VCI Search Function OFF.

Press/hold unneeded app 8 , and
a trashcan will appear at the top 9 .

8

9

2. Drag the app to the trashcan.

TURN “VIBRATE” MODE OFF (SAMSUNG NOTE 10.1 ONL Y)
Haptic feedback will cause a vibration when softkeys are tapped and for certain software actions.
1.

Open “Settings”

1

2. Select “Device” tab
at the top 2
3. Select “Sounds and
notifications” 3

2

4. Select “Sound Mode”
5. De-select “Vibrate”

4
5
3

5
1
4

(Continued next page)

Answers:
1. Quicklinks
2. Publications
3. Emailed
4. Remanufactured
5. Forty seven
6. Sample
7. Zoom
8. Curvature
9. Gaps
10. Ground
11. Transient
12. Resistance
13. Firing
14. Sport
15. Downshift
16. Shorter
17. Ten
18. Moisture

C

T

I

Z

E

N

N T

F

N

R

L

P

B

A

X

N T

T

X

G

F

I

U

C W S

S

T

O O

R

E D

E

O P

T

F O

R

Q R

O

P D

H

B

S

E

N

S

L

Z

E

L M N
C

S

F

R T

U
V
I

T
T
R

H
C
I

I
B

I

U M M

F

Y M W D

C

Y

V
A

R