Service Information
Diagnostic Device Hardware & Windows®

Number: AHW-16-03

Subject: VAS 6150D Diagnostic Laptop – Unpacking and Setup
Instructions

Date: Feb. 9, 2016

Supersedes AHW-15-02 due to new diagnostic laptop generation.

Table of Contents
Page

Section
1.0

Introduction

2

2.0

Additional Documentation

2

3.0

Safety Instructions

2

4.0

Important Information

5

5.0

Unpacking Instructions

6

6.0

Contents of Carton

6

7.0

Battery Safety & Access

7

8.0

Connecting to Power

8

9.0

Windows 7 Startup & Initial Setup

8

10.0

Network Setup & Internet Explorer Version

13

11.0

Install Offboard Diagnostic Information System Service (ODIS Service)

17

12.0

Diagnostic Interface Setup

17

13.0

Windows 7 Update Management

20

14.0

Warranty Registration

22

15.0

Malfunctions and Support

22

Note
• Please read these instructions carefully and in their entirety before performing any
procedures. If you do not understand these instructions, arrange to have a qualified person
perform these procedures.
• Heed all prerequisite requirements and notes. Follow all instruction steps in the Section order
given and heed all cross-references to the additional Service Information documentation
required.
• Discard all printed copies of this document after use. Revised versions may be issued at any
time. Always check ServiceNet for the latest version.

Page 1 of 22
© 2016 Audi of America, Inc.
All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual
property rights of Audi of America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may
be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be
modified or reposted to other sites, without the prior expressed written permission of the publisher.

Service Information
1.0 – Introduction
This document contains all instructions required to unpack and prepare new VAS 6150D Diagnostic
Laptops for workshop service. Instructions include references to other Service Information (SI)
documents containing additional instructions.

IMPORTANT!
The setup instructions provided here supersede those in the Panasonic manuals and
VAS 6154 Diagnostic Interface setup instructions included with the laptop shipment.

2.0 – Additional Documentation
Obtain the following documents from ServiceNet before proceeding with unpacking & setup:
Vehicle
Diagnostics
SI Document
Subcategory
ODIS Service

Document Titles

 Installation Phase 1 – Preparation, License & Security Certificate Process Instructions
 Installation Phase 2 - Software Installation & Configuration Instructions
 VAS Diagnostic Device Computer Name Builder

Diagnostic Device
Hardware &
Windows

Optional:
 VAS 5054A Diagnostic Interface – Bluetooth & EDIC Configuration
 VAS 5054A Diagnostic Interface - USB Configuration

3.0 – Safety Instructions
3.1 – Explanation of Symbols
Symbols with the following meanings are used in this document and elsewhere:

Warning!

Text with this symbol contains information regarding your safety and how you
can reduce the risk of serious or fatal injuries. The Warning symbol deserves
special attention with respect to your safety.

Caution!

Text with this symbol contains information on how you can prevent damage to
the vehicle and to the device. The Caution symbol informs you that failure to
comply with such information can result in damage to the vehicle and/or tester.

Note

Text with this symbol contains additional, useful information. The Note symbol
indicates important information on the product, its use and other items.

Page 2 of 22
© 2016 Audi of America, Inc.
All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual
property rights of Audi of America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may
be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be
modified or reposted to other sites, without the prior expressed written permission of the publisher.

Service Information
3.2 – Reference to Additional Safety Instructions
The following contains the general safety instructions that apply to all VAS diagnostic laptop and tablet
devices. Additional safety instructions can be found in the applicable device Operating Manuals. Safety
instructions may also appear on the screen of the tester and displayed by the diagnostic software. Heed all
instructions displayed.

3.3 – Important Safety Instructions

Warning!
1. Read all instructions carefully and thoroughly.
2. If the power cable or unit is damaged, the equipment may be not used until inspected by a
qualified technician.
3. Do not allow any cables or leads to drape over the edges of tables, benches or stands.
Prevent hot parts or rotating fans from coming into contact with cables or leads.
4. Use of an extension cable is prohibited. When performing tests, only the specified cables
and leads may be used.
5. Always unplug the equipment when it is not in use. Never unplug the power cable from
the outlet by pulling on the cable. Grasp the connector to disconnect the equipment from
the power outlet.
6. The tester may not be used in the vicinity of open fuel containers, as there is otherwise
the risk of fire or explosion.
7. When you are working on internal combustion engines, ensure adequate ventilation.

Otherwise, there is a risk of poisoning.
8. Use the equipment only in the manner described. Use only the accessories listed by the
manufacturer.
9. Risk of explosion. The equipment has spark-generating components inside and for this
reason must not be used in areas with flammable vapors. The equipment should be
operated at a height of at least 460 mm (18 inches) above the floor, since gasoline and
other possible vapors collect at floor level.
10. The equipment complies with Safety Class 1 when under power and is equipped with a
safety tested power cable. Connect the equipment only to electrical service or power
outlets with a grounded protective conductor (TN network).
11. Fasten the diagnosis laptop securely to the rear seat of the vehicle during test drives. A
second person on the rear seat must operate the diagnosis laptop. For safety reasons,
operation on the front seat and without being fastened securely is prohibited (e.g. risk of
triggering the airbag).
(cont.)

Page 3 of 22
© 2016 Audi of America, Inc.
All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual
property rights of Audi of America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may
be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be
modified or reposted to other sites, without the prior expressed written permission of the publisher.

Service Information
Warning!
12. Electric ignition systems have voltages of up to approx. 30 kV. General Safety guidelines
for workshops are to be observed at all times.
13. Opening of the tester, including its accessories, by unauthorized personnel can result in
serious risk to the individual and the equipment.
14. If the power cable, a diagnostic or measuring cable, the tester or any other accessory
under power is damaged, their use is prohibited until a qualified technician has given
approval to do so.
15. If you will not be using the equipment for a longer period of time, please switch it off at the
on/off switch and disconnect it from the power if the rechargeable battery is charged.
Switching off at the on/off switch alone does not ensure that the power supply, charging
circuit or any connected accessory has been disconnected from power.
16. Data transmission lines should not be connected or disconnected during a thunderstorm
nor should the equipment itself be operated.

3.4 – Safety Instructions for Wireless Units

Warning!
1. No antenna modifications, e.g. relocation or use of other antennas or transmitters, are
permitted on units approved for wireless operation.
2. Do not use a portable transmitter (e.g. wireless network (WLAN) or Bluetooth device) in
the vicinity of unshielded detonator caps or in an explosive atmosphere, unless the device
has been modified in a way that permits such use.
3. Information regarding Bluetooth and W-LAN approval in various countries may be found in
the diagnostic software operating manual.

(cont.)
Page 4 of 22
© 2016 Audi of America, Inc.
All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual
property rights of Audi of America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may
be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be
modified or reposted to other sites, without the prior expressed written permission of the publisher.

Service Information
Caution!
1. Line voltage fluctuations and deviations exceeding the permissible tolerance can result in
malfunction and damage to the diagnostic device.
2. When operating the VAS 6150D in a workshop cart, ensure that the power adapter has
adequate ventilation. Remember that the charging circuit is operating even when the tester is
switched off. This is also true in the power saving mode.
3. When connecting other make vehicles:
•

The VAS 6150D diagnostic laptop was developed and specified for vehicles manufactured
by the Volkswagen Group. Connecting the tester or diagnostic interface (VCI) directly to a
vehicle from another manufacturer, may cause damage to the vehicle’s electrical system.

•

If attempting to use the generally applicable OBD functions for self-diagnosis of other
make vehicles, the OBD adapter cable VAS 5052/16 should be connected between the
diagnostic head and diagnosis connection in the vehicle.

4. When handling the rechargeable battery:
•

The rechargeable battery should be replaced only by properly trained personnel.

•

Never short-circuit the rechargeable battery.

•

Never throw the rechargeable battery into a fire.

•

Dispose of/recycle the rechargeable battery only when discharged and in accordance with
local regulations.

4.0 – Important Information
4.1 – Shipping Damage / Incomplete Shipment
Please check the following items when unpacking/starting your VAS 6150D:
1. Packaging damaged:
•

Have the damage confirmed in writing on the shipping documents by the delivery service and
report it immediately.

2. Packaging in good condition, but contents damaged:
•

Report damage to Snap-on immediately.

3. Incomplete shipment:
•

Please check the contents list as per instructions in Section 6.0 – Contents of Carton to
determine whether your shipment is complete. Report issues to Snap-on immediately.

Page 5 of 22
© 2016 Audi of America, Inc.
All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual
property rights of Audi of America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may
be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be
modified or reposted to other sites, without the prior expressed written permission of the publisher.

Service Information
4.2 – Temperature Equalization

Caution!
If the VAS 6150D is delivered during winter months, efforts must be made to prevent the
formation of condensation within the device. For this reason it is recommended to leave the
device unattended at room temperature for approximately 3 hours prior to connecting and
switching on to allow for temperature compensation.

1.0 4.3 – Safety and Startup Instructions
Please review the Safety and Startup instructions very carefully prior to startup.

4.4 – Purchase Documentation
Please retain your shipping documents as proof of purchase and delivery.

5.0 – Unpacking Instructions
VAS 6150D are delivered with the laptop, docking station and VAS 6154 all packed separately in a main
shipping box.
1. Unpack all contents, then remove the protective film from the laptop and docking station.
2. Dispose of the packaging material in accordance with local regulations.
3. Check the contents for damage and completeness > Section 6.0 - Contents of Carton.
4. Report damaged contents and incomplete shipment issues immediately to Snap-on (SBS).

6.0 - Contents of Carton
Confirm your VAS 6150D shipment contains the following items (check the boxes provided):







1. VAS 6150D



Service Manager Cover Letter*

4

Rechargeable battery* (is pre-installed)
2. Docking Station (port replicator)

1

3. A/C Power Adapter /cables
4. VAS 6154 Diagnostic Interface
with add-on modules, cables etc.
2
3

*Not shown
Page 6 of 22
© 2016 Audi of America, Inc.
All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual
property rights of Audi of America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may
be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be
modified or reposted to other sites, without the prior expressed written permission of the publisher.

Service Information
7.0 - Battery Safety & Access
Caution!
When handling the rechargeable battery:
•

The rechargeable battery should be replaced only by properly trained personnel.

•

Never short-circuit the rechargeable battery.

•

Never throw the rechargeable battery into a fire.

•

Dispose of, or recycle the battery only when completely discharged and in accordance with
local regulations.

Note
The battery is pre-installed in the laptop prior to shipment and does not require any further setup.
The information below is for future reference only.
If it becomes necessary to remove and reinstall the battery, switch the laptop off and proceed as follows:
1. Carefully turn the laptop over.
2. Slide and hold the battery lock button in the unlock position, then grasp the battery on its raised
edge and slide out of housing:

3. Install in reverse order. (It is not necessary to hold the battery release button during installation.)

Caution!
Ensure battery pack locks into place to prevent accidental loss during transport.

Page 7 of 22
© 2016 Audi of America, Inc.
All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual
property rights of Audi of America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may
be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be
modified or reposted to other sites, without the prior expressed written permission of the publisher.

Service Information
8.0 – Connecting to Power
The laptop is connected to power either via the docking station (port replicator) connection to the A/C
power adapter, directly via the A/C power adapter or run from the internal rechargeable battery pack.

Caution!
•

The A/C power adapter includes a country-specific power cable (UL-approved or CSA-approved,
oil-resistant power cord).

•

Operation on ungrounded or impedance-grounded electrical networks (IT electrical networks) is
prohibited.

•

Use only the original Panasonic power adapter.

9.0 – Windows 7 Startup & Initial Setup