INDIAN MOTORCYCLE

HELP CENTER
What can we help you find?

Search

Help Center Home / Article

07/15/2025

2015-2024 Scout Oil Change
Indian Scout Oil Change - Indian Motorcycle

Required Tools and Supplies
Oil Change Kit
2.5-inch (64mm) Oil Filter Wrench
6mm Allen Head Socket
Safety Glasses
Torque Wrench
Nitrile Gloves

For more information on tools, read the Tools and Fasteners Guide.
Always wear safety glasses and nitrile gloves when servicing your Indian Motorcycle. Change the
engine oil at the intervals specified in the Periodic Maintenance Table found in your Owner's Manual.
Change the oil more frequently if the motorcycle is subjected to severe use, especially operation in

cold weather. Always use the recommended oil, which for Scout models is Indian Motorcycle Full
Synthetic 15W60, part number 2880187. Failure to perform frequent oil changes during cold weather
operation can result in condensation forming. Freezing condensation can result in plugged oil lines
and serious engine damage.
The total amount of oil required for the oil and filter change is approximately 3 to 4 quarts (2.8 to
3.8 l). Follow all instructions carefully. Do not overfill.
Note that after an oil change, the low oil pressure indicator may illuminate when the engine is
started. If this occurs, do not increase RPM above idle speed until the indicator turns off. Operating
above idle speed could result in damage to the engine.
To change the oil and filter:
1. Change the oil and filter (1) when the engine is warm. If the engine is cold, start the engine and
allow it to run at idle for at least 5 minutes.
2. Park the motorcycle with the sidestand down on a firm, level surface. For proper oil drain, use a
service lift to ensure the motorcycle is vertically centered.
3. Clean the area around the two drain plugs (2). Place a drain pan under both drain plugs. Caution:
Hot oil can cause burns to skin. Do not allow hot oil to contact skin.

4. Remove the drain plugs with the 6mm Allen head socket. Allow the oil to drain completely.
5. Install new sealing washers on the drain plugs. The sealing surfaces on the drain plugs and engine
should be clean and free of burrs, nicks or scratches.
6. Reinstall the drain plugs with the 6mm Allen head socket. Torque to 15 ft-lbs (20 Nm).
7. Place a drain plug or shop towels under the oil filter. Using a 2.5-inch (64 mm) oil filter wrench,
turn the filter counter-clockwise to remove it. If necessary, remove the horn bracket to improve
access.

8. Using a clean dry cloth, clean the filter sealing surface on the engine.
9. Lubricate the O-ring on the new filter with a film of fresh engine oil. Check to make sure the Oring is in good condition.
10. Install the new filter and rotate it clockwise by hand until the filter gasket contacts the sealing
surface and then turn it an additional 3/4 to one full turn.
11. Reinstall the horn bracket if it was removed.
12. Remove the dipstick (1). Using a funnel, add 3 to 4 quarts (2.8 to 3.8 liters) of the recommended
oil. Reinstall the dipstick securely.

13. With the motorcycle in an upright, centered position, start the engine and allow it to idle for 30
seconds. Stop the engine.
14. Add the recommended oil as needed to bring the level to the FULL mark on the dipstick. Verify
the level on the dipstick. The approximate volume between the FULL (2) and ADD (3) marks on the
dipstick is 16 ounces (0.45 liters).

15. Reinstall the dipstick securely. Do not overfill. Overfilling can result in loss of engine performance
and an oil-saturated air filter. Use a suction device to remove excess oil if overfilled.

16. Dispose of the used filter and oil properly.
For more information, see your authorized Indian Motorcycle Dealer. Find a dealer near you with the
Dealer Locator.
Maintenance tips, procedures and specifications can be found in your Owner's Manual.
To find diagrams and replacement part numbers, use the online parts catalog.
YouTube® is a registered trademark of Google LLC
Unless noted, trademarks are the property of Indian Motorcycle International, LLC
© 2022 Indian Motorcycle International, LLC
Was this article helpful?
Yes, it answers my question
No, it's missing information or visuals
No, the instructions are unclear
No, What are the next steps?
No, I'm experiencing a technical error
Other

* [-] How can we improve this article? We'd love to hear your suggestions
Tell us what you would like to see in this article

Send

Keyword(s) scout , oil , change , fluid , instruction , procedure , video ,

HELPFUL LINKS
Parts, Accessories and Apparel
Owner's Manuals

Indian Motorcycle Protection Plan
Special Offers
Recalls
Indian Motorcycle Lubricants

CONTACT US
BY E-MAIL
Send us an e-mail inquiry.

CLICK TO CALL
BY DEALER
Locate the nearest dealer in your area.

SUBSCRIBE NOW
FIND A DEALER
US-ENGLISH

MOTORCYCLES
SHOPPING TOOLS
ASSISTANCE
OWNER RESOURCES
ABOUT US

© 2025 Indian Motorcycle
Site Map
Privacy
Your Privacy Choices
Terms
Accessibility
Careers
Global Sites