TECHNICAL SERVICE OPERATIONS

MAS004783 MCL 25-39
Circular Letter
FROM: Maserati TSO
TO: Maserati Network

Introduction to Maserati Grecale

IMPORTANT NOTICE This bulletin supersedes MAS004618 MCL 25-10 released on March 4, 2025. It
contains updated information, please ensure all previous versions are discarded.
DATE: July 25, 2025

The new Parts & Service mission aims to ensure a unique customer experience. A few important
guidelines for the technical management of the New Maserati Grecale are set out in this letter.
Maserati Grecale represents the right balance between versatility, elegance, performance, and
innovation, guaranteeing services, comfort, and safety at the same time; features that combine
with off-road capabilities and steadfast driving pleasure.
The new MY23 Grecale SUV, developed at Maserati Innovation Lab in Modena, is a range within
the range, the most complete and innovative ever in the House of the Trident.
The range of available engines varies from the traditional combustion to the hybrid engine and
includes three launch versions: GT, powered by a 4-cylinder Hybrid capable of developing 300 HP,
Modena with a 330 HP 4-cylinder Hybrid engine, and the powerful Trofeo, equipped with a
performing 530 HP 3.0L V6 engine, derived from the Neptune engine which equips MC20.
Topics covered in this Bulletin:
•
•
•
•
•

Taking charge of the vehicle and periodic checks.
Indications of best practices and technical notes for the Grecale Service.
Pre-Delivery inspection checklist.
Activation of the technical team.
Unveiling tech-doc/diagnosis and special tools.

Please read and review this bulletin first before starting the procedure.
Contact your Regional AfterSales Manager (RAM) or the Technical Support Helpdesk if you have
any questions.
© 2025 Maserati Americas.
Aftersales
www.maseratiusa.com

MAS004783

All rights reserved. Reproduction or translation in
whole or in part is not permitted without
authorization from the publisher. Printed in USA

Page 1 of 11

1

Vehicle maintenance and periodic battery checks…………………………………………….2
1.1

12V Battery Inspection at PDI……………………………………………………………………2

1.2

Check/restore 12V battery State Of Charge (SOC)………………………………………..2

2

Best practices in the workshop for Grecale service……………………………………………..3
2.1

Lifting the vehicle………………………………………………………………………………….3

2.2

Door opening………………………………………………………………………………………4

2.3

12 V battery access………………………………………………………………………………5

2.4

Disconnect the 12V battery negative cable………………………………………………..5

2.5

Emergency start - dead battery……………………………………………………………….5

2.6

Transmission unblocking………………………………………………………………………...6

3

Pre-Delivery Inspection Checklist…………………………………………………………………...7
3.1 Procedures performed with MEVO……………………………………………………………….7

4

Activation of the Technical Team……………………………………………………………………8

5

Technical Documents, Electronic Diagnosis, and Special tools………………………………8
5.1

Contained visibility………………………………………………………………………………..8

5.2

New GUI MDEVO for Grecale…………………………………………………………………..8

5.2.1

Vehicle view…………………………………………………………………………………..9

5.2.2

PROXI unaligned between vehicle and server………………………………………..10

5.3

Special tools………………………………………………………………………………………..11

1 Vehicle maintenance and periodic battery checks
The specifics on the maintenance of the vehicles in stock are reported as usual in the dedicated
circular letter, which undergoes periodic updates (See MAS004488 MCL 25-15 MGNT And MAINT Of
Instock Vehicles or newer for details.) In particular, the new Maserati GranTurismo features require
more restrictive 12V battery charge status control logistics than other models in the Maserati family.
The checks involve:
-

Performing a Battery test using the E-XTEQ MAXIMUS at PDI.
Performing a Battery test using the E-XTEQ MAXIMUS during the entire storage period.

1.1

12V Battery Inspection at PDI

Performing a Battery test following the procedures outlined in bulletin “MAS004655 MCL 25-21
Battery Policy for “E-XTEQ” Maximus charger tester (Or Newer)”.

1.2 Check/ restore 12V battery State Of Charge (SOC)
Perform a Battery test using the E-XTEQ MAXIMUS during the entire storage period at Intervals
outlined in “MAS004488 MCL 25-15 MGNT And MAINT Of Instock Vehicles”.

© 2025 Maserati Americas.
Aftersales
www.maseratiusa.com

MAS004783

All rights reserved. Reproduction or translation in
whole or in part is not permitted without
authorization from the publisher. Printed in USA

Page 2 of 11

TECHNICAL SERVICE OPERATIONS

Contents

The following chapter includes a list of best practices and technical notes for Maserati Grecale
Service; this vehicle’s features require precautions that may otherwise not be noticed or highlighted
While the car is undergoing normal operations in the workshop.

2.1 Lifting the vehicle
The position of the lifting points is indicated by an inverted triangle stamped on the edge of the
body; there are also vehicle side pads for interfacing the axle positioning.

Front pad

Rear pad

Be careful about the axle geometry to prevent damaging the vehicle during the lifting operation. We
recommend removing all possible loads from the vehicle (passengers, luggage, spare tire, etc.) to
increase the distance from the ground (in case there are no air springs ).

We recommend using lift plates with a diameter no greater than 125mm for the front axle and
centering the plate on the lifting dowel as well as possible to prevent contact with the car’s floor trim.

© 2025 Maserati Americas.
Aftersales
www.maseratiusa.com

MAS004783

All rights reserved. Reproduction or translation in
whole or in part is not permitted without
authorization from the publisher. Printed in USA

Page 3 of 11

TECHNICAL SERVICE OPERATIONS

2 Best practices in the workshop for Grecale service

Door Opening

The following diagram summarizes the instructions in the onboard documentation concerning the door
opening controls:
From outside:
press the button
shown on the key
twice within 5
seconds or press
the button on the
door

Opening using a
Bowden:
internal unlocking
lever located on
the driver's area
dashboard

From outside:
touch the inside
part of the
handle

From inside:
1. Emergency
opening
handle
2. Electronic
door
lock/unlock
button

From inside:
Press the button
on the headliner
front console

The tailgate is
moved
electronically

If the 12 V battery is discharged and the electric locks cannot be powered, the key fob has an
emergency mechanical key that can unlock the driver’s side door with a lock corresponding to the
handle itself, as shown in the figure below:

© 2025 Maserati Americas.
Aftersales
www.maseratiusa.com

MAS004783

All rights reserved. Reproduction or translation in
whole or in part is not permitted without
authorization from the publisher. Printed in USA

Page 4 of 11

TECHNICAL SERVICE OPERATIONS

2.2

12 V Battery access

The battery is positioned on the inside of the boot lid in the center. You need to lift the boot lid bottom
panel and remove the battery cover to access the battery.

2.4

Disconnect the 12V Battery negative cable.

If you need to disconnect the 12V battery negative pole (for example, due to long vehicle inactivity),
you can access it by removing the bottom cover of the rear trunk:

2.5

Emergency start - dead Battery

If an emergency start is needed for a dead battery, the remote poles located in the engine
compartment can be used, as indicated in the following figures:

© 2025 Maserati Americas.
Aftersales
www.maseratiusa.com

MAS004783

All rights reserved. Reproduction or translation in
whole or in part is not permitted without
authorization from the publisher. Printed in USA

Page 5 of 11

TECHNICAL SERVICE OPERATIONS

2.3

TECHNICAL SERVICE OPERATIONS

2.6

Transmission Park Release

If you need to move the car with the engine off, the “Car Wash” mode can be activated.
As shown below:
-

The car must be on a level surface, not moving
Put the transmission in N (Neutral) by using the control on the dashboard

-

Turn the engine off by pressing the START/STOP button.

The driver’s door must be shut during these steps. This condition must be maintained for about 15
minutes, after which the transmission moves to P (Park).
If this solution is not possible or if there are other transmission problems, the transmission can be
released manually as follows:
-