SERVICE BULLETIN
Subject: TS45 TIRE BALANCING

Bulletin Type: FC

Bulletin No: TS45-FC-2508

PQR No: 500000007767

Rev No:

Ref. No:700004710

Vehicle Model : TS45

Labor Time / Code: 3 hour .

Date of issue :17.12.2024

Modify Before:01.12.2025

What to do with off coming parts :

What to do with outstanding parts of previous
revision:
☒Scrap
☐ Return
☐Use with additional parts
☐On consignment
☐ No parts outstanding

☐Scrap
☐ Return
☐Use with additional parts
☐On consignment
☒ No off coming parts

Modification Description:
Vehicles that feel vibration should be
balanced.

Bulletin Responsible: Oğuz DURAL

SERVICE BULLETIN
SAFETY INSTRUCTIONS
1. Mechanical Requested Dress Code
WARNING:
➢ Dress properly to avoid personal injury and damage to the
vehicle
✓
✓
✓
✓
✓

Always wear protective clothing
Do not wear any worn or loose-fitting clothing
Remove jewelry before starting to work
In case of long hair, use hairnet
The illustration on the left shows some of the correct and
incorrect clothing
✓ Sharp edged items should be avoided in order not to
scratch vehicle (i.e. belts, watches, necklace)

2. Protect Seats when Mechanic Starts Working

✓ Seats, trimming, upholstery stuff and carpeting should be
protected with appropriate coverings.

3. Welding on the Chassis
a. Always disconnect the batteries (starting with the negative lead).
b. Disconnect the connectors of electrical and electronic equipment (electronic control
units, sensors and actuators) if they are less than 2 meters away from the chassis
part to be welded or the earth terminal of the welding equipment.
c. The earth terminal should never be attached to vehicle components such as engine,
axles and springs. Arcing on these parts is not permitted, because of the risk of
damage to bearings, springs, etc.
d. The earth terminal must make good contact and be placed as close as possible to
the part to be welded.
e. Plastic pipes, rubber parts and parabolic springs should be well protected against
welding spatter and temperatures higher than 70°.
f. The contact switch must not be in the accessory or contact position. The contact key
should be removed.
g. Reconnect in reversed order of disconnecting. Ensure that a good earth connection
is made between chassis, engine and cab.

SERVICE BULLETIN
TECHNICAL INSTRUCTIONS
1. Vehicles that feel vibration should be balanced.
2. Tires should be removed and balance (runout values) measurements should be made one
by one.
3. Runout values above ‘1’ should be balanced and reduced to below ‘1’.

RUNOUT
VALUE

4. If the runout value cannot be reduced below ‘1’, the tire should not be used. It should be
replaced with another tire with a runout value below ‘1’.