Technical Service Bulletin
19 Coolant warning light or coolant loss - R8 4.2 FSI
19 13 37 2026109/2 May 13, 2013. Supersedes Technical Service Bulletin Group 19 number 11-23 dated April 14,
2011 for reasons listed below.
Model(s)

Year

VIN Range

2008

000189 – 999999

2009

000000 – 001500

Vehicle-Specific Equipment

R8 4.2 FSI

4.2 FSI

Condition
REVISION HISTORY
Revision

Date

Purpose

2

-

Revised header data (Adjusted VIN range)
Revised Technical Background (Edited description)

1

4/14/2011

Initial publication

Coolant warning light on or coolant loss.

Technical Background
The left and/or right side radiator cooling fans may be inoperative due to corrosion caused by water ingress into
the fan motors or into the fan control units. As a result, coolant temperatures may exceed the permissible value,
leading to increased system pressure and potential coolant loss from the system. Indication of coolant loss may be
noticed coming from the coolant reservoir.

© 2013 Audi of America, Inc.

Page 1 of 4

All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of
Audi of America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval
system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior
expressed written permission of the publisher.

Technical Service Bulletin
Production Solution
A splash guard was installed on the cooling fan to
protect the fan motor and the fan control unit (Figure
1).

Figure 1. Splash guard aligned with fan control unit.

Service
1. Remove the front vehicle underbody cover. Refer to Body Exterior >>Rep. Gr.66>>Removal and Installation.
2. Check the both fans for stiffness or rough running. If necessary, replace one or both auxiliary cooling fans (if
applicable).
3. Install the two splash guards.
Tip: The splash guard must be fitted with the arrow on the splash guard aligned with fan control unit.
4 Check cooling system for leaks and repair as necessary.
5. Check fan operation.
6. Reinstall front underbody cover.
© 2013 Audi of America, Inc.

Page 2 of 4

All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of
Audi of America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval
system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior
expressed written permission of the publisher.

Technical Service Bulletin
Warranty
Claim Type:

Use applicable claim type. If vehicle is outside any warranty, this Technical
Service Bulletin is informational only.

Service Number:

1908

Damage Code:

0040

Labor Operations:

Check both cooling fans operation and fit

1908 0299

130 TU

1908 1999

50 TU

1908 2099

100 TU

Cooling system check

1901 0100

20 TU

GFF

No allowance

0 TU

Road test prior to service procedure

No allowance

0 TU

Road test after service procedure

0121 0004

10 TU

splash guards on both sides
Check fan and replace on one side if
applicable.
Check fan and replace on both sides if
applicable.

Diagnostic Time:

Technical diagnosis at dealer’ s discretion
(Refer to Section 2.2.1.2 and Audi Warranty
Online for DADP allowance details)
Claim Comment:

As per TSB #206109/2

All warranty claims submitted for payment must be in accordance with the Audi Warranty Policies and Procedures

Manual. Claims are subject to review or audit by Audi Warranty.

© 2013 Audi of America, Inc.

Page 3 of 4

All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of
Audi of America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval
system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior
expressed written permission of the publisher.

Technical Service Bulletin
Required Parts and Tools
Parts

Quantity

Cooling fan motor splash guard 420 959 509

2

Cooling fans, replace as necessary if applicable.

Order per VIN search in ETKA

Additional Information
All parts and service references provided in this TSB are subject to change and/or removal. Always check with
your Parts Department and service manuals for the latest information

© 2013 Audi of America, Inc.

Page 4 of 4

All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of
Audi of America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval
system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior
expressed written permission of the publisher.