L636A.04.19

A:
Oggetto:
Data:
Pagine

Official After-Sales Network
Infotainment update
15 Febbraio 2019
10

Campaign code:
L636-A.04.19
Campaign Name:
Infotainment configuration update
Model:
Urus
Model year:
From 2019
Special or limited editions:
All versions
Markets:
All markets
VIN identification:
From VIN KLA00200 to KLA03260
Important: before proceeding with the repair, connect to
the warranty portal and use VIN Info to check that




The vehicle is actually affected by the instructions
given in this bulletin; some vehicles may not be,
even when their VIN is included.
Procedures are identified by a letter (e.g. A, B or
C….etc., whose differences will be explained later
in this bulletin); make sure that the spare parts corresponding to the assigned procedure are used.
Example

Note
Procedure A will be available only when the instructions
require a preliminary check to be performed to determine
whether or not the vehicle actually needs updating.
Information to the network:
As a result of the continuous monitoring of the product,
Automobili Lamborghini S.p.A. has released a new update
for the entertainment system of Urus. This update contains
improvements for infotainment diagnosis on GPS antenna
(all markets), for the data connection via WiFi hotspot using SIM plug-in (NAR markets only) and provides the activation of the DAB radio for the Baltic countries.
Operations:
The following instructions include the steps:
-

Step B: Infotainment configuration update

Solutions for the network:
Update the car as stated in the instructions.
Replacement parts:
Please order the indicated codes along with the following
steps
Cod.

Step B: Infotainment configuration update
Descrizione

n/n

Q
n/n

0

Management of replaced parts:
Store the parts removed from the vehicle in a suitable
manner, marked with their barcode for identification during visits by the competent Area Manager.
Labor:
- Step B: 0,5 h
Bulletins superseded:
None.

Rev.00

The procedures and information published herein are strictly confidential and are intended exclusively for recognized professionals and
persons who are authorized to receive said information. All copyrights are the property of Automobili Lamborghini S.p.A. pursuant to
copyright law. The company reserves the right to make updates and modifications as required. The reprinting, reproduction, distribution to
unauthorized persons and/or to third parties, and the partial or complete translation of the material contained herein are prohibited without
the express written consent of Automobili Lamborghini S.p.A.
doc. no.: L/V6_M06 Rev.[05]

1/10

L636A.04.19

A:
Oggetto:
Data:
Pagine

Official After-Sales Network
Infotainment update
15 Febbraio 2019
10

Warranty instructions:
To request reimbursement for the corrective action performed, access the Warranties section of the Lamborghini
Portal and follow the “Campaigns” entry instructions in
the W.Claim manual which can be downloaded from the
Portal.
Select the required campaign and proceed with entry, carefully reading the options present in the alert displayed by
the system (see example) and select the option performed
on the vehicle.
Tools/Materials required
Cod.
Descrizione.
n/n

Q
n/n

0

Depending on the option performed, the reimbursement will be structured in the following manner:
-

OPTION B – Infotainment configuration update
Labor: 0,5 h
spare parts: none

WARNING!
Attach all documents generated during the work carried
out as evidence of the work itself, for instance workshop
orders, diagnostic protocols etc. If one or more of these is
missing it may lead to a rejected reimbursement request.
Fill out the Service and Recall Campaign section in the
warranty booklet, which is shown in the figure below.

Rev.00

The procedures and information published herein are strictly confidential and are intended exclusively for recognized professionals and
persons who are authorized to receive said information. All copyrights are the property of Automobili Lamborghini S.p.A. pursuant to
copyright law. The company reserves the right to make updates and modifications as required. The reprinting, reproduction, distribution to
unauthorized persons and/or to third parties, and the partial or complete translation of the material contained herein are prohibited without
the express written consent of Automobili Lamborghini S.p.A.
doc. no.: L/V6_M06 Rev.[05]

2/10

L636A.04.19

A:
Oggetto:
Data:
Pagine

Official After-Sales Network
Infotainment update
15 Febbraio 2019
10

Preliminary operations:
1. Ensure you have recently synced with the Mirror server by checking the last synchronization date:
http://mirrorserver/maintenance/diagnosis.py
or by directly entering the Btac-box IP address:

The instructions contained in this bulletin are based on the
ODIS diagnosis software updated to version 5.0.4 and the
Lamborghini 2.14.4 or later database (refer to information
bulletin BI.07.15 and make sure that ODIS Service is
properly updated on the laptop).

http://[IP_address]/maintenance/diagnosis.py
if you have not previously set the IP alias of the mirror
server.
(e.g. http://12.34.567.890/maintenance/diagnosis.py)

IMPORTANT:
Make sure that the last synchronization was performed after December 18, 2018.
2. It is essential that you connect an appropriate battery
charger to the charge points available in the engine
hood (left side of the vehicle). Please refer to the following figure

Rev.00

The procedures and information published herein are strictly confidential and are intended exclusively for recognized professionals and
persons who are authorized to receive said information. All copyrights are the property of Automobili Lamborghini S.p.A. pursuant to
copyright law. The company reserves the right to make updates and modifications as required. The reprinting, reproduction, distribution to
unauthorized persons and/or to third parties, and the partial or complete translation of the material contained herein are prohibited without
the express written consent of Automobili Lamborghini S.p.A.
doc. no.: L/V6_M06 Rev.[05]

3/10

L636A.04.19

A:
Oggetto:
Data:
Pagine

Official After-Sales Network
Infotainment update
15 Febbraio 2019
10

Work instructions:
The updating procedure described here includes the following steps:
I. Infotainment configuration update;
II. Fault memory deletion;
III. Installation confirmation;
IV. Fault memory deletion.

IMPORTANT:
Do not perform other types of activity on the car while executing the campaign.
Carrying out the procedure blindly implies unsolvable
damage to the control unit and resulting replacements.

2. Click on “SVM–Direct input: SVM for problemrelated update” and then on “Perform test”.

NOTE:
Secure the key On during the entire procedure for updating the ECU 5F configuration. Start a diagnostic session
with ODIS Service, keep the diagnostic interface connected to the OBD socket and do not close the ODIS program
or use it for other purposes. Once the update has been
started, it is need to complete the operation in ODIS.

I.

3. Enter the campaign code "L636A0419" in the appropriate space at the top right and click “Adopt”.

Infotainment configuration update:

Refer to the procedure in the workshop manual regarding
“Implementation of an SVM code”.

L636A0419

IMPORTANT:
Improper use of this function can cause damage to the
ECUs.
1. To start the procedure to execute an SVM code, select
the “Special functions” card in ODIS.

Rev.00

4. The SVM code entered is again displayed in the dialog
box. If the entered code is correct, click on “Yes”.
Otherwise click on “No” to cancel the SVM procedure.

The procedures and information published herein are strictly confidential and are intended exclusively for recognized professionals and
persons who are authorized to receive said information. All copyrights are the property of Automobili Lamborghini S.p.A. pursuant to
copyright law. The company reserves the right to make updates and modifications as required. The reprinting, reproduction, distribution to
unauthorized persons and/or to third parties, and the partial or complete translation of the material contained herein are prohibited without
the express written consent of Automobili Lamborghini S.p.A.
doc. no.: L/V6_M06 Rev.[05]

4/10

L636A.04.19

A:
Oggetto:
Data:
Pagine

Official After-Sales Network
Infotainment update
15 Febbraio 2019
10

5. Wait for data to be acquired from all the control units.
This operation requires a few minutes.

8. It might become necessary to perform one or more of
the following operations in the SVM procedure:
6. To run the SVM function and access the Lamborghini
servers, you must have a valid GeKo account. Ensure
that the laptop is correctly connected to the Internet.
Enter your GeKo username in the "User name" field
and the PIN 1324 + the 6-digit code currently displayed on the GeKo token in the "Password" field.



Coding;



Parameterization;



Calibration.

To perform these actions, it is usually necessary to
click on “Done/Continue” where requested and to follow the instructions directly provided on the ODIS dialog screens.

Click “Adopt” to confirm.
7. The SVM function will automatically continue with
identification of the control units in the vehicle.
9. Click “Done/Continue” until the control unit 5F updating procedure is completed.

Rev.00

The procedures and information published herein are strictly confidential and are intended exclusively for recognized professionals and
persons who are authorized to receive said information. All copyrights are the property of Automobili Lamborghini S.p.A. pursuant to
copyright law. The company reserves the right to make updates and modifications as required. The reprinting, reproduction, distribution to
unauthorized persons and/or to third parties, and the partial or complete translation of the material contained herein are prohibited without
the express written consent of Automobili Lamborghini S.p.A.
doc. no.: L/V6_M06 Rev.[05]

5/10

A: