4/20/2018

H079 UPS11917-3bNAS1 - Update Prior to Sale: Anti-Lock Braking System (ABS) Module Water Ingress | TOPIx

H079 UPS11917-3BNAS1

TECHNICAL BULLETIN
20 APR 2018

© Jaguar Land Rover North America, LLC
NOTE: The information in Technical Bulletins is intended for use by trained, professional Technicians with
the knowledge, tools, and equipment required to do the job properly and safely. It informs these
Technicians of conditions that may occur on some vehicles, or provides information that could assist in
proper vehicle service. The procedures should not be performed by 'do-it-yourselfers'. If you are not a
Retailer, do not assume that a condition described affects your vehicle. Contact an authorized Jaguar
service facility to determine whether this bulletin applies to a specific vehicle.

INFORMATION

SECTION:
206-09A: Anti-Lock Control

SUBJECT/CONCERN:
Update Prior to Sale: Anti-Lock Braking System (ABS) Module Water Ingress

AFFECTED VEHICLE RANGE:
MODEL:
E-PACE (X540)

MODEL YEAR:
2018

VIN:
Z00104-Z05013

ASSEMBLY PLANT:
Graz (Austria)

MARKETS:
https://topix.jaguar.jlrext.com/topix/content/document/view?id=891997

1/18

4/20/2018

H079 UPS11917-3bNAS1 - Update Prior to Sale: Anti-Lock Braking System (ABS) Module Water Ingress | TOPIx

NORTH AMERICA

CONDITION SUMMARY:

SITUATION:
An issue has been identified on certain vehicles within the listed Affected Vehicle Range where ground
wire connection to the Anti-lock Brake System (ABS) control module may not be fully sealed. This may
allow water to leak into the ABS module and cause the illumination of certain warning lamps, including
ABS and Dynamic Stability Control (DSC).

ACTION:
Retailers are required to HOLD affected new vehicles that are within your control and refrain from
releasing the vehicles for new vehicle sale pending completion of the Inspection and, if necessary,
Workshop and Diagnostic Procedures detailed in this Technical Bulletin. Unsold vehicles should have this
performed as part of the Pre-Delivery Inspection (PDI) process but must have it completed prior to vehicle
handover to the customer.
This program does not apply to any vehicle already registered and in use, either with the retailer or
customer. Any vehicle already in use may continue to be driven and any repair instructions deemed
necessary will be communicated through a separate Field Action or Technical Bulletin.

PARTS:

NOTES:
The repair requires two (2) 4mm strips of butyl tape. This is a consumable and should be readily
available in the workshop.
If a vehicle fails the inspection procedure and requires an Anti-lock Brake System (ABS) Control
Module and Engine Compartment Harness, follow the standard part procurement process. Send
an email to [email protected] to expedite the supply of these components.
Order only the expected percentage demand of parts identified.
DESCRIPTION

PART NO./SUNDRY
CODE

https://topix.jaguar.jlrext.com/topix/content/document/view?id=891997

QTY./VALUE

EXPECTED PERCENTAGE
DEMAND
2/18

4/20/2018

H079 UPS11917-3bNAS1 - Update Prior to Sale: Anti-Lock Braking System (ABS) Module Water Ingress | TOPIx

DESCRIPTION

PART NO./SUNDRY
CODE

QTY./VALUE

EXPECTED PERCENTAGE
DEMAND

Anti-Lock Brake System (ABS)
Module

J9C9375

1

1

Engine Compartment Harness

J9C11007

1

1

Bush

C2P5224

1

1

Seal & Nut

T4A2690

1

1

Gasket

T4A12220

1

1

Insert (Ring)

J9C7817

1

1

Insert (Ring)

J9C7818

1

1

O-ring (13.7 x 2.5 mm)

J9C7820

1

1

O-ring (9.5 x 2.5 mm)

C2Z14586

1

1

*Brake Fluid

*ZZZ001

*$26.00 USD

1

* - an allowance of $26.00 USD (or local equivalent) has been provided to cover the cost of the brake
fluid. Claim using Sundry Code ‘ZZZ001’.

WARRANTY:

NOTES:
Use the Jaguar Land Rover claims submission system to make sure that a vehicle is affected by
this program prior to undertaking any rework action.
If a vehicle fails the inspection procedure, send an email to [email protected] with
the VIN, retailer code, and retailer name. Continue to hold all vehicles that fail the inspection
procedure.
At the time of confirming a booking for vehicle repair, make sure that all outstanding Recall and Service
Actions are identified to ensure the correct parts are available and adequate workshop time is allocated
for repairs to be completed at one visit.
Warranty claims must be submitted quoting the Program Code and the relevant Option Code; this will
result in payment of the stated time. The SRO and parts information is included for information only. The
https://topix.jaguar.jlrext.com/topix/content/document/view?id=891997

3/18

4/20/2018

H079 UPS11917-3bNAS1 - Update Prior to Sale: Anti-Lock Braking System (ABS) Module Water Ingress | TOPIx

Option Code(s) that allows for the drive in/drive out allowance may only be claimed if the vehicle is
brought back into the workshop for this action alone to be undertaken.
Repair procedures are under constant review and therefore times / prices are subject to change; those
quoted here must be taken as guidance only. Use the Jaguar Land Rover claims submission system to
obtain the latest repair time.
This program is valid for a limited time only. Warranty claims with a repair date prior to the 20 December
2018 closure date must be submitted or payment within 30 calendar days of completion of the repair.
PROGRAM
CODE

OPTION
CODE

DESCRIPTION

SRO

TIME
(HOURS)

PARTS/SUNDRY
CODE

QTY./VALUE

H079

A

Inspect and seal ground
cable

05.10.50

0.5

-

-

H079

B

Inspect and seal ground
cable
Drive in/drive out

05.10.50
10.10.10

0.5
0.2

-

-

H079

C

*Engine Compartment
Harness - Renew

*86.70.81

*11.0

86.99.33

0.2

J9C9375
J9C11007
C2P5224
T4A2690
T4A12220
J9C7817
J9C7818
J9C7820
C2Z14586
**ZZZ001
-

1
1
1
1
1
1
1
1
1
**$26.00
-

*86.70.81

*11.0

86.99.33
10.10.10

0.2
0.2

J9C9375
J9C11007
C2P5224
T4A2690
T4A12220
J9C7817
J9C7818
J9C7820
C2Z14586
**ZZZ001
-

1
1