CP) TOYOTA

T-SB-0024-12 Rev1 January 24, 2012 Technical Service Bulletin

Floor Mat Installation During PDS

Service
Category General

Toyota Supports
Section Pre-Delivery Service Market USA ASE Certification see
Applicability
YEAR(S) MODEL[S) ADDITIONAL INFORMATION
2013 4Runner, Avalon,

Avalon HV, Camry,
Camry HV, Corolla, FJ
Cruiser, Highlander,
Highlander HV, Land
Cruiser, Matrix, Prius,
Prius C, Prius PHV,
Prius V, RAV4,
Sequoia, Sienna,
Tacoma, Tundra,
Venza, Yaris

REVISION NOTICE
October 16, 2012 Rev1:

* Applicability has been updated to include 2013 model year Avalon HV, Prius C, and Prius PHV
vehicles,

Any previous printed versions of this bulletin should be discarded.

Introduction

2013 model year vehicles are equipped with driver's side floor mat retaining clips to secure the floor
mat in the correct position. In addition, some models may utilize retaining clips for passenger side
and rear seat floor mats as well. Follow the appropriate installation procedure to attach the driver's
side, and if applicable, the passenger's side and rear seat floor mats to the vehicle carpet using the
floor mat retaining clips during Pre-Delivery Service (PDS).

© 2012 Toyota Motor Sales, USA Page 1 of 9
CP TOYOTA F-SB-0024-12 Rev1 —_ January 24, 2012 Page 2 of 9

Floor Mat Installation During PDS

Introduction (Continued)

CAUTION

* Always verify the floor mat to assure it is designed specifically for the model and model year it
is being installed in.

ONLY use floor mats that can be retained using the retaining clips. All OEM Toyota floor mats
are specifically designed to fit correctly and be retained using the retaining clips.

Make sure the floor mat is properly placed on the vehicle carpet and secured with the retaining
clips. If the driver side floor mat is NOT properly placed and secured, it could slip and interfere
with the movement of the pedals during driving and may cause an accident.

Verify the operation of the accelerator, brake, and clutch (if equipped) pedals and clearance
to the mat.

NEVER install more than one floor mat at a time in the driver’s seating position.

if applicable, any secondary set of floor mats (based upon customer preference, such as the
all weather floor mats or other floor mats) MUST be placed in the trunk with all the packaging
material intact. Do NOT install the secondary mat on top of the primary floor mat already
installed in the driver's seating position.

Warranty Information

OP CODE DESCRIPTION TIME OFP 71 T2
NIA Not applicable to Warranty N/A NiA - a

® 2012 Toyota Motor Sales, USA
CP TOYOTA T-SB-0024-12 Rev1 January 24, 2012 Page 3 of 9

Fioor Mat Installation During PDS

installation Procedure: Hook Style

1. Verify that the driver, and if applicable, passenger side and rear seat, floor mats are for the
correct model and model year they are being installed in.

2. Attach the driver, and if applicable, passenger side and rear seat, floor mats to the vehicle
carpet using the retaining clips. Secure the mat by inserting the retaining clips through the
grommet holes.

Figure 1.

1 | Retalning Clips | 3 | Correct installation |
2 | Grommets

© 2012 Toyota Motor Sales, USA
GP) TOYOTA T-SB-0024-12 Rev1 January 24, 2012 Page 4 of 9

Floor Mat Installation During PDS

Installation Procedure: Hook Style (Continued)

3. Verify proper installation.

NOTE
If applicable, DO NOT remove the beige “Caution” tag from the floor mat. This should only be
removed by the customer,

Figure 2.

A Caution / Precaucion / Attention / 1435 A

NOTICE: THIS TAG TO BE REMOVED BY CUSTOMER ONLY.

To avoid interference wih pedal operation.
= Eech mat must be secured with retention hooks (clips)
- Da not instal a floor mat on top of an existing floor mat

AVISO: SOLAMENTE Et CLIENTE DEBE REMOVER ESTA ETIQUETA.

Para oviar interferenaa con la operscién del pada:
O - Cada tapeta debe sujetarss con seguros de retancién (broches}
«No instale un tapete de peso encima de un tapete de piso axisienie

REMARQUE : CETTE ETIQUETTE NE PEUT ETRE ENLEVEE QUE PAR LE CLIENT,
Pour éviter des interiérences avec le forictionnoment de la pédale:

- Chaque tapis coil dire fixé a faide des crochets de réisntion (agrafes)

-Ninstallex pas un tap pardessus un taps déj4 en place

ad pend) ud cs ASU bam & 55 wey s_jlant
Septal diay 3 ye of Gal Gy deol Aide y 4B ye ell
Mids Spo AF G8 Fell VASE HY -

TFMT-0001-REYV1 [1]

© 2012 Toyota Motor Sales, USA

C&P) TOYOTA T-SB-0024-12 Revl = January 24, 2012 Page 5 of 9

Floor Mat Installation During PDS

Installation Procedure: Hook Style with Locking Clip

1. Verify that the driver, and if applicable, passenger side and rear seat, floor mats are for the
correct model and model year they are being installed in.

2. Attach the retention clip to the floor by inserting the retention clip claws into the floor eyelet.

Figure 3.
® a
@ => ZL
ZAR BZ

L J

1 Retention Clip 5 | Cross-sectional Diagram

2 Front of Vehicle A | Retention Clip Claw

3 | Retention Clip Eyelet on Vehicle Floor B | Locking Clip

4 | Seat