Technical Service Bulletin
01 Sporadic vehicle no start (DTC P170100, P157000)
01 14 51 2030580/8 January 3, 2014. Supersedes Technical Service Bulletin Group 01 number 13-19 dated
August 1, 2013 for reasons listed below.
Model(s)

Year

VIN Range

Vehicle-Specific Equipment

A6, A7, A8

2012 - 2013

All

Not Applicable

Condition
REVISION HISTORY
Revision

Date

Purpose

8

-

Revised Warranty (updated SRTs & changed labor division)

7

8/1/2013

Revised Warranty (updated SRTs)

6

5/13/2013

Revised Warranty (updated SRTs)

5

5/8/2013

Revised header data (Increased vehicle population)
Revised Service (Adjusted procedure to include additional vehicles)

4

12/7/2012

Revised Service (Added SVM Code)

3

10/4/2012

Revised header data (Adjusted to include early model year 2012 C7
vehicles)

2

8/20/2012

Revised header data (Updated VIN)

1

8/20/2012

Original publication

• The customer complains that the vehicle sporadically cannot be started.
• The yellow gearbox warning light may be illuminated.
• One or both of the following DTCs may be present:
• DTC P157000 (Control Module Locked, sporadic) - in the engine control module, J623 (address word 01)
• DTC P170100 (Transmission control module locked, sporadic) - in the transmission control module, J217
(address word 02)

Technical Background
The remote key being used is transmitting incomplete immobilizer information to the vehicle, resulting in the
condition.
© 2014 Audi of America, Inc.

Page 1 of 3

All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of
Audi of America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval
system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior
expressed written permission of the publisher.

Technical Service Bulletin
Production Solution
Not applicable.

Service
• For A6/A7 vehicles before VIN DN021776, or for A8 vehicles before VIN DN005692, replace the affected
remote key and perform the SVM code below.
• For A6/A7 vehicles after VIN DN021776, or for A8 vehicles after VIN DN005692, only perform the SVM code
below.
SVM Update Instructions
Follow all instructions in TSB 2011732: 00 Software Version Management (SVM), operating instructions.
Update the comfort control system module, J393 (address word 46), using the SVM action code as listed in the
table below if necessary.

Model

A6/A7/A8

Engine and/or
Transmission

Old Software
Part Number

Old Software
Version

New Software
Part Number

N/A

Varies

< 433

Varies

© 2014 Audi of America, Inc.

New Software
Version
(or higher)

SVM
Action
Code

433

46A004

Page 2 of 3

All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of
Audi of America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval
system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior
expressed written permission of the publisher.

Technical Service Bulletin
Warranty
Claim Type:

Use applicable claim type. If vehicle is outside any warranty, this Technical Service Bulletin
is informational only.

Service Number:

5789

Damage Code:

0039

Labor Operations:

Replace affected key (if necessary)

5708 5550

10 TU

Update comfort control system module using
SVM Code

5789 2599

30 TU

GFF (if key was replaced)

0150 0000

80 TU

GFF (if no key was replaced)

0150 0000

30 TU

Road test prior to service procedure

No allowance

0 TU

Road test after service procedure

No allowance

0 TU

Diagnostic Time:

Technical diagnosis at dealer’s discretion
(Refer to Section 2.2.1.2 and Audi Warranty Online for DADP allowance details)
Claim Comment:

As per TSB #2030580/8

All warranty claims submitted for payment must be in accordance with the Audi Warranty Policies and Procedures
Manual. Claims are subject to review or audit by Audi Warranty.

Required Parts and Tools
Part Number

Part Description

Quantity

See ETKA for the latest key part number

Key

1 (if necessary)

Additional Information
The following Technical Service Bulletin will be necessary to complete this procedure:
• TSB 2011732: 00 Software Version Management (SVM), operating instructions.
All parts and service references provided in this TSB (2030580) are subject to change and/or removal. Always
check with your Parts Department and service manuals for the latest information.

© 2014 Audi of America, Inc.

Page 3 of 3

All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of
Audi of America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval
system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior
expressed written permission of the publisher.