HYU na R 1 1~~~~~~~~~~~TIES.
Technical Service Bulletin
SUBJECT:

GROUP

MODEL

CAMPAIGN

AZERA (HG)

1--~~~~~~~1--~~~~~~--;

DATE

NUMBER

MARCH 2013

13-01-018

AZERA (HG) 3.3L ECM UPDATE - (SERVICE CAMPAIGN TN5)

Gi).)

®Kvu naRI

ECU Update

NOTE: THIS TSB REVISION SUPERSEDES TSB 12-01-048 TO INCLUDE RETAIL VEHICLES

*IMPORTANT

,_____ _ _ _ ______. ****DEALER STOCK AND RETAIL VEHICLES*****
Dealers must perform this Campaign on all affected vehicles prior to customer retail delivery and
whenever an affected vehicle is in the shop for any maintenance or repair.
When a vehicle arrives at the Service Department, access Hyundai Motor America's "Warranty
Vehicle Information" screen via WEBDCS to identify open Campaigns.
Description:
This bulletin provides information for an ECM software update of some Azera (HG) 3.3L GDI
vehicles.
Applicable Vehicles:
• 13 MY Azera (HG) 3.3L GDI vehicles
GOS Information:
EVENT#

DESCRIPTION

292

"HG 3.3 P0451 OTC LOGIC IMPROVEMENT."

Warranty Information:
Model
AZERA (HG)

Op Code

Operation

Op Time

20C120R1

ECM UPGRADE

0.3M/H

ROM ID INFORMATION TABLE:
Verify the ECM ROM ID before updating the vehicle's software. Refer to the table below.
ECM ROM ID
Model
AZERA(HG)

Engine
3.3 GDI

ECM P/N
39110-3CHN1

Previous

New

HGDN33GM2A6CL 1A*

HGDN33GM2A6CL 1B*

Circulate To: Service Manager, Warranty Manager, Service Advisors , Technicians, Fleet Repair

SUBJECT:

AZERA (HG) 3.3L ECM UPDATE-(SERVICE CAMPAIGN TNS)

GENERAL PRECAUTIONS:
•
•

Connect the USB cable between the GOS and
the VCI.
Connect the 16-pin DLC connector from the VCI
into the DLC located under the driver's side dash.

*NOTE
Make sure the battery icon at the bottom right of the GOS laptop shows at least 50% ; if not, charge
the GOS or attach a battery charger.
•

Turn off all lights (Do not leave the headlight switch in auto mode) and all accessories (including
heater/air conditioner/fan, audio , heated seats , rear defroster, etc) to ensure the battery will not
be discharged during the update.

•

Perform the update with the ignition key in the ON position .

•

Do not disconnect any cables connected to the vehicle or the GOS during the update .

•

Do not start the engine or turn the ignition switch OFF during the update.

I* NOTE

I

Confirm your GOS has the most recent version. If not, connect the GOS to an Internet port, open
the GOS home page and select "Update". Refer to instructions on hmaservice.com if necessary.
If you encounter GOS related problems, call the GIT Helpline at 888-437-0308 .

TSB #: 13-01-018

Page 2 of 4

SUBJECT: AZERA (HG) 3.3L ECM UPDATE - (SERVICE CAMPAIGN TN5)
SERVICE PROCEDURE:
GOS AUTO MODE ECM UPDATE PROCEDURE
1. From the GOS home page , select ECU Upgrade. If necessary, select the VIN.
2. Select Engine as the system and then select OK.
3. Select Auto Mode and then select Next.
4

From the System tab , select Engine and then select OK. The GOS will read the ROM ID.
Confirm the ROM is applicable as shown on Page 1, "ROM ID Information".

5 Select update event as listed on the GOS Event list of page-1. Select Upgrade.
Prep.t.ratlon

...,..;-q {•
• Mode.
A.... MOlk

Ev111ntCroup
• Cr.m•ti\ FIOM D
~

J

~!~~:;::::::----=====

U\. . l ROM D

•System
E,_CUN!

l.R.,..,,..._.......,.._.........., ...
'"'""o·---.
....... 1,-urv•E...-,...i--*"•·
i;,.,.""" ._,_,.a...,..
Et.-U _ ....
r ~"H r..-~.......,,.

l . Sek-ct~...,--.

l. CUd. 12volts), select OK. If not, select CANCEL
and charge the vehicle battery by running the engine for 10 minutes.

7 Updating will occur until 100% is reached on the bar graph. At the prompt, turn the ignition key
OFF for 10 seconds, then turn it ON and select OK.
8 The GOS will confirm that ECM reprogramming is successfully fin ished . Select OK.
9 If the ECM update was not successful, go to GOS MANUAL MODE ECM UPDATE
PROCEDURE.
10 Check for OTC in all systems and Erase All OTC that stored due to loss of CAN communication
during the ECM Update.
11 Turn OFF ignition 10 seconds then turn ON before going to engine start.
12 Start the engine to confirm proper operation.

TSB # : 13-01-018

Page 3 of 4

SUBJECT:

AZERA (HG) 3.3L ECM UPDATE- (SERVICE CAMPAIGN TN5)

'

*NOTE:
In event of AUTO MODE update failure:
• You must attempt MANUAL MODE. Use the ECM P/N from the vehicle's ECM label if it is
not clear from the ROM ID Table as to the correct ECM P/N to use for your vehicle .
• Replacing an ECM without carefully documenting that a MANUAL MODE update attempt was
made , will result in claims charge back.

GOS MANUAL MODE ECM UPDATE PROCEDURE

*NOTE
•
•
•
•

GOS Manual Mode is intended for recovery of an ECM Update should it
begin but then later fail in process in the Auto Mode .
The ECM connectors must be disconnected for 15 minutes to reset its
contents then perform this Manual Mode Update.
Do not force Manual Mode if you get an error in Auto Mode that the veh icle 's
current ROM ID did not apply.
It is critical to identify the correct ECM Part Number in the PASSWORD table
or the ECM may be permanently damaged. It is recommended to remove
ECM and read the part number from the label to confirm .

1. From the GOS home page , select ECU Upgrade. If necessary, select the VIN .
2. Select Engine as the system and then select OK.
3. Select Manual Mode and then select Next.

4

From the System tab , select Engine and then select OK.

5 Select update event as per the GOS Event List of page-1, then select Upgrade.
6

Be certain to enter the exact appropriate password from the table below and select OK. See the
important NOTE above.

7 The remaining steps are same as Steps 6-12 of the Auto Procedure.
MENU
HG 3.3 IMMO : 39110-3CHN1

TSB # : 13-01-018

PASSWORD

1031

Page 4 of 4