INSTRUCTION TO SERVICE
ITS61359

6/3/25

SECTION:

260-BATTERY SYSTEM

SUBJECT:

INSTALL RFID TAG w/ BRACKET

ISSUE:

BRACKET w/RFID NOT INSTALLED

SUMMARY:

BRACKET w/RFID RFID TAG INSTALL INSTRUCTIONS

ITS61359
Ref. NHTSA Recall No.
Not Applicable

Ref. Transport Canada Recall No.
Not Applicable

THIS ITS DOCUMENT SHOULD BE RETAINED AND REFERRED TO FOR FUTURE MAINTENANCE UNTIL
THE NEW FLYER PARTS AND/OR SERVICE MANUAL IS UPDATED TO REFLECT WORK DONE AS A
RESULT OF THIS DOCUMENT. ENSURE THAT THIS DOCUMENT IS AVAILABLE FOR PARTS AND
MAINTENANCE STAFF GOING FORWARD.
This document and the contents discussed herein are the confidential and proprietary information of New Flyer Industries Canada
ULC and New Flyer of America Inc. and are disclosed by New Flyer in confidence. This document and the contents herein are not
to be disclosed by the intended recipient without the prior written authorization of New Flyer. Any unauthorized disclosure,
reproduction or other distribution of this document or information strictly prohibited and may result in action being taken against
the party making the unauthorized disclosure. This document and all copies hereof must be returned to New Flyer upon request.

INSTRUCTION TO SERVICE
ITS61359

WARNING:
Only trained personnel shall supervise and perform High Voltage system testing, checkout
and troubleshooting. Two personnel (one called the Checker & the other called Monitor/Recorder) shall
perform Checkout Procedures, together, to ensure safety of themselves, others nearby & for the
protection of vehicle & property. Refresher training shall be provided to these personnel on a regular
basis and when new systems are to be checked by them. The training of the personnel shall consist of:

1. SAFETY PROCEDURE
1.1.
1.2.
1.3.
1.4.

Turn the master run switch to the off position and wait 5 minutes before proceeding.
Turn the 12/24V battery disconnect and HV Interlock switch to the “OFF” position.
Lock and tag the electrical system of the bus out and retain the key. See Figure 1.
Install a Lockout/Tagout Steering wheel cover as require.

NOTE:

Refer to the Lockout/Tagout Procedure in section 1 of your Preventive Maintenance
Manual or section 9 of your Service manual for additional information.

NOTE:

Use commercially available lock out equipment and tags being sure to follow any local
laws or workplace procedures.

NOTE:

Refer to New Flyer High Voltage Safety Guidelines and Procedures Document 532295
when completing installation or service work on high voltage power cables.

Figure 1- Lockout tagout location reference

INSTRUCTION TO SERVICE
ITS61359

2. Rework – Adding RFID bracket
A. Unmount WLAN antenna shown in detail.

Note: Parts removed for clarity.

B. Insert RFID bracket under WLAN as shown in detail and reinstall mounting hardware

Note: Parts removed for clarity

INSTRUCTION TO SERVICE
ITS61359

C. Mount RFID tag with supplied 14S98012 hardware(X2)

D.

Rework complete. Clean area if needed.

INSTRUCTION TO SERVICE
ITS61359

LABOUR ESTIMATE
Operation
1

INSTALL BRACKET

Number of
Technician(s)
1

Hours
.30

Labor Time
T X HR
.30

PARTS REQUIRED
Description

Qty.
per
Coach
1

Units

Item

Part Number

1

918210

ASSY-BRKT, RFID TAG

2

908156

TAG-RFID

1

EA

3

14S988012

MACHINE SCREW 8-32 X .75

2

EA

EA

Notes