12/16/25, 8:28 AM Transmission Control Module (TCM) Software Update
yh MS SERVICE ACTION Global Service Action

@ eye Vi Number: D067

7.
Subject: Publication No.: D067
Transmission Control Module (TCM) Software Update Model: Range Rover (LK)

Model Year: 2024

Model: Range Rover Sport (L1)
Model Year: 2024

Date of Issue: 16 December 2025

Jaguar Land Rover North America, LLC and Jaguar Land Rover Canada ULC

For the The approved JLR retailer / authorized repairer.

Attention of:

Important: NOTE: The information in this campaign is intended for use by professional technicians. If you are not a JLR retailer /
authorized repairer, do not assume that a condition described affects a specific vehicle. Contact an authorized JLR
retailer / authorized repairer to determine if this campaign applies to a specific vehicle.

This campaign has been issued to provide the relevant repair instructions, parts and warranty information.

FOR THE ATTENTION OF ALL:
DESCRIPTION OF ISSUE
A potential concern has been identified on certain 2024 model year Range Rover and Range Rover Sport vehicles equipped with
the 4.4 NC11 P8S engine. The Malfunction Indicator Lamp (MIL) is illuminated on the vehicles instrument panel cluster, due to a
Transmission Control Module (TCM) network communication fault. There are no other effects on the vehicle, or loss of functionality.
ACTION TO BE TAKEN
At the next opportunity, you are requested to repair the vehicle.
Check the JLR Warranty Portal to make sure affected vehicles are correctly identified prior to starting this campaign. The Warranty
Portal will be updated to reflect only those vehicles affected.
JLR retailers / authorized repairers are reminded that they must not sell vehicles identified as affected by this campaign until such
time as the repair has been successfully completed
An owner may indicate that a repair has already been completed for this concern, in which case the full cost of the repair should be
reimbursed. Refer to the warranty section of this campaign for details of the Customer Reimbursement and Related Damage
Process. At the time of confirming a booking for a vehicle repair, make sure you check the Warranty Portal to confirm if there are
any other outstanding campaigns, to make sure the correct parts are available and adequate workshop time is allocated for repairs
to be completed in one visit.

https://topix.jirext.com/topix/content/document/view?id=1803794&groupld=1585 4/2

12/16/25, 8:28 AM Transmission Control Module (TCM) Software Update
The following applies to:
e [NORTH AMERICA]
FOR THE ATTENTION OF NORTH AMERICAN TERRITORIES ONLY:
The following applies to:
e [NORTH AMERICA]
Visit the British Brands Sales Suite (BBSS) website for a list of affected vehicles at your JLR retailer / authorized repairer. Unsold
vehicles must be repaired prior to handover of the vehicle for retail sale
Yours faithfully
Steve Oldham
Global Customer Care Quality Director
https://topix jrext. com/topix/content/document/view?id=1803794&groupld=1585 212

12/16/25, 8:29 AM SERVICE INSTRUCTION
D067 Transmission Control Module (TCM) Software update
This campaign must be completed using the campaign workflow.
Outstanding campaigns are listed on the TOPIx vehicle home page.
To complete D067 return to the TOPIx vehicle home page and select ‘Start Workflow’ from the OUTSTANDING CAMPAIGNS section. All instructions must be followed to complete the campaign.
SROs
[Description [SRO [Time]
TCM - update 85.44.05
Software level check | 85.99.41
Drive in/ drive out | 02.02.02
NOTE:
Repair procedures are under constant review, and therefore times are subject to change; those quoted here must be taken as guidance only. Always refer to TOPIx to obtain the latest repair time.
Warranty Information
Warranty claims must be submitted quoting program code D067 with the relevant option code from the table below. As option codes are used there is no requirement for you to enter SROs or parts, these
are included for information only.
NOTES:
* If the module(s) software is already up to date; you must not continue with the campaign. Only claim the relevant option code for diagnostic software level check.
* Option codes Y and Z are ONLY to be used when the Software is already at the latest level.
[Program[Option] Description | _SRO_ [Time
D067 TCM - update 85.44.05
067 TCM - update 85.44.05 | 0.2
Drive in / drive out 02.02.02} 0.2
D067 Software level check | 85.99.41
Doe7 |Z Software level check | 85.99.41 | 0.1
Drive in/ drive out | 02.02.02 | 0.2
NOTE:
The option that contains the drive in / drive out allowance may only be claimed when the vehicle has been brought back into the workshop for this action alone to be undertaken.
https://topix.jIrext.com/topix/content/document/view?id= 1803794 &groupld=1585#G474 19691112 112

12/16/25, 8:29 AM SERVICE INSTRUCTION
Warranty claims must be submitted in accordance with the current JLR Global Warranty Manual, and its amendments, unless stated otherwise in this campaign.
Customer Reimbursement and Related Damage Process
NOTE:
If there is a requirement to claim for related / consequential damage or customer reimbursement, refer to the related instruction that can be found in TOPIx (in the Search box, search for ‘Related
Damage Claim’ and open the related bulletin link)
CAUTIONS:
* Allcontent in the Diagnostic Instruction MUST be read before selecting ‘Complete Step’.
* You MUST connect the JLR approved diagnostic equipment and approved battery support unit. To complete the campaign workflow.
NOTE:
Option codes Y and Z are ONLY to be used when the Software is already at the latest level.
4, Connect the JLR approved diagnostic equipment and the approved battery support unit.
2.
CAUTION:
The campaign workflow MUST be run for the software update to be applied.
Select ‘Complete Step’ and follow all on-screen instructions.
3. Disconnect the JLR approved diagnostic equipment and the approved battery support unit.
https://topix.jIrext.com/topix/content/document/view?id= 1803794 &groupld=1585#G474 196911112 212