GROUP

NUMBER

CAMPAIGN

Technical Service Bulletin
SUBJECT:

DATE

24-01-077H
MODEL(S)

SEPTEMBER 2024

KONA (SX2)

FRONT CAMERA SOFTWARE UPDATE FOR FCA & LKA LOGIC
IMPROVEMENT (SERVICE CAMPAIGN TCF)

 IMPORTANT
Dealers must perform this service campaign on all affected vehicles prior to customer retail delivery
and whenever an affected vehicle is in the shop for any maintenance or repair.
Access the “Vehicle Information” screen via WebDCS to identify open campaigns.
Description: Certain Kona (SX2) vehicles may exhibit a warning light ON in the cluster related to the
“Check Forward Safety system” due to software intended from an alternate region. This bulletin
provides a software update for the Front Camera system to update logic in the Forward Collision
Avoidance (FCA) and Lane Keeping Assist (LKA) functions.
Advanced Driver Assistance System (ADAS) functions are not affected due to this condition.

FCA Warning on Cluster
Front Camera

Applicable Vehicles (Certain):
• 2025MY Kona (SX2) produced 6/3/2024 – 7/19/2024

GDS Information:
System Selection: FR_CMR
System

Event #

Description

FR_CMR

1136

SX2 25MY FCA AND LKA LOGIC IMPROVEMENT

(*or use a later available event as listed in the GDS FR_CMR System Update screen if one is
available.)
Circulate To: General Manager, Service Manager, Parts Manager, Warranty Manager, Service
Advisors, Technicians, Body Shop Manager, Fleet Repair

FRONT CAMERA SOFTWARE UPDATE FOR FCA & LKA LOGIC
IMPROVEMENT (SERVICE CAMPAIGN TCF)

SUBJECT:

Warranty Information:
Model

Op. Code

Operation

Op.
Time

Casual Part

Nature
Code

Cause
Code

Kona (SX2)

40D109R0

Front Camera
Software Update

0.4 M/H

99211-BE000

I14

ZZ3

NOTE 1: Submit claim on Claim Entry Screen as “Campaign” type.
NOTE 2: If a part is found in need of replacement while performing this campaign and the affected
part is still under warranty, submit a separate claim using the same repair order. If the affected part is
out of warranty, submit a Prior Approval request for goodwill consideration prior to performing the
work.
NOTE 3: Op times include VIN, Mileage, and photo capture of the “ECU update complete” screen as
outlined in the Digital Documentation Policy.

ROM ID Information:
Model

System

ECU
Part Number

Kona (SX2)

FR_CMR

99211-BE000

TSB #: 24-01-077H

ROM ID
Old

New

1.05.00
1.06.00

1.07.00

Page 2 of 5
SUBJECT:

FRONT CAMERA SOFTWARE UPDATE FOR FCA & LKA LOGIC
IMPROVEMENT (SERVICE CAMPAIGN TCF)

SUBJECT:

Service Procedure:

STUI
This TSB includes Repair validation photos. Refer to the latest Warranty Digital Documentation
Policy for requirements.

NOTICE
You must initially perform the GDS ECU update in Auto Mode.
• If the ECU update starts but then fails in Auto Mode, perform the update in Manual Mode
to recover.

NOTICE
GDS Vehicle Battery Low Voltage Warning:
If voltage is below 12 Volts per the GDS warning, then select Back and attach a battery charger
to ensure an adequate battery charge for reliable update results. Turn ignition back ON, and then
retry the ECU update again.

ECU Update Procedure
1.

Perform the ECU update in Auto Mode.
Use the ID Check to verify the ROM ID before
updating the software.

i

Information

Refer to TSB 24-GI-012H, “ECU Update
Procedure for Tablet-Based GDSSmart”, for additional information.

TSB #: 24-01-077H

Page 3 of 5
SUBJECT:

FRONT CAMERA SOFTWARE UPDATE FOR FCA & LKA LOGIC
IMPROVEMENT (SERVICE CAMPAIGN TCF)

SUBJECT:

2.

Select the FR_CMR system to scan the
vehicle’s current ROM ID.

NOTICE
Check the current ROM ID version and
compare it to the ROM ID Information
table before attempting to perform the
software update.

NOTICE
If the update fails, please remove the
power connector or the battery (–)
connector from the indoor fuse box for at
least 5 seconds and reassemble it to
retry the update.
3.

After the ECU update process shows 100%
complete, follow the prompts on the screen to
cycle the ignition OFF for at least 10 seconds
to reset the control unit (certain models may
take up to 30 seconds).

i

Information

Use the Refresh button to reset the timer.

TSB #: 24-01-077H

Page 4 of 5
SUBJECT:

SUBJECT:

FRONT CAMERA SOFTWARE UPDATE FOR FCA & LKA LOGIC
IMPROVEMENT (SERVICE CAMPAIGN TCF)

4.

STUI
Take a screenshot of the ECU update
complete screen using your tablet and
upload to STUI.

5.

Perform an All Systems Fault Code search
and erase DTC history that had incidentally
occurred from the ECU update.

6.

Start the engine to confirm proper operation of
the vehicle.

NOTICE
If the ECU update fails in Auto Mode, perform the update in Manual Mode using the password(s)
below.
Manual Mode Password:
ECM Menu

Password

SX2 LKA 99211-BE000

0792

TSB #: 24-01-077H

Page 5 of 5
SUBJECT: