PERFECT DELIVERY INSPECTION (PDI)

2014

A5 Cabriolet/S5 Cabriolet

Audi Technician Report

Stock No.

Dealer Number

R.O. No.

VIN

Road test mileage out

Road test mileage in

All items must be completed prior to customer delivery by an Audi
technician
**Refer to the Special functions tab of ODIS Diagnosis using GFF
for the PDI function tests
**Audi recommends using an Audi approved battery charger to
prevent excessive battery discharge during inspection

Trunk Inspection
FF     Install wheel bolt cover removal tool from PDI kit and wheel
lock key (if applicable) into trunk tool kit behind right side
cover
FF     Set spare tire pressure
FF     Verify trunk operation, including emergency release handle

Open Campaigns/Updates
FF     Check Elsa for open campaigns and updates. Perform
campaigns not requiring SVM if applicable. Campaigns
requiring SVM should only be performed after the vehicle has
been taken out of transport mode.

Exterior
FF     Test windshield washers for aim and function
FF     Turn on headlights and test headlamp washers (if equipped)
FF     Test exterior lighting functions

Battery Inspection
FF     Check battery clamps for proper torque. Re-torque if required
FF     Perform the A-battery test for new batteries using GFF in ODIS
Diagnosis –> Special functions –> Service work. Select option 2,
the battery test for new batteries as part of the pre–delivery
inspection and act according to the test result (ok, recharge,
replace). Ensure diagnosis log is uploaded to the GFF paperless
server by selecting “ok” when tester wants to send the current
generated diagnosis protocol online. (Note: Do not use Guided
Function. The diagnosis log will not be uploaded to GFF paperless)
Transport Mode Deactivation, DTC check, set service reminder
FF     Deactivate vehicle transport mode (via Special functions –>
Service work –> 19-Transport mode activating/deactivating)
FF     Set service reminder (via Special functions –> Service work –>
17-PDI-resetting SRI at PDI, counter reset, etc.)
FF     For MMI3G+ vehicles, set adaptation channel (via Special
functions –> Service work –> : 5F–Activating/deactivating
storage of music)
FF     Perform an SVM specified /actual comparison (via Special
functions ->Software Version Management (SVM))
FF     Perform any campaign update requiring SVM at this time
(follow instructions listed in campaign documentation)

FF     Check key functionality including seat memory (if applicable);
verify vehicle starts and runs with the start/stop button; verify
all doors lock/unlock with remote and Advanced Key, including
door handle sensors (if equipped)
Interior
FF     Check operation of all switches: Locks, windows, seat adjustment, and child safety features
FF     Calibrate rear view mirror compass to proper zone and check
self-dimming function/lighting (if equipped)
FF     Verify operation of all interior lights
FF     Mirrors: Inspect folding, adjustments, RH tilt in reverse, and
memory (if equipped)
FF     Inspect operation of lighter, aux. outlet under armrest and rear
outlet
FF     Verify operation of all front and rear seat belts and latches
FF     Check horn operation
FF     Passenger side airbag: Verify operation of Passenger Occupant
Detection System
FF     Verify convertible top manual closing tools are present
Radio
FF     Verify operation of CD player

Under the Hood Fluid Check and Inspection
FF     Check all fluid levels and top off if necessary
FF     Check engine oil level using Special Tool T40178 on a flat and
level surface

Effective 10-1-2013
Version 1.0

FF     Verify operation of AMI or aux. input (if equipped)
FF     SD card slot: Insert SD card and test function (Test all SD card
slots as equipped)
FF     Verify HD Radio is turned “off” in Radio/Settings Menu
(USA ONLY)

1 of 2

PERFECT DELIVERY INSPECTION (PDI)

2014 A5 Cabriolet/S5 Cabriolet | Audi Technician Report

Stock No.

Dealer Number

R.O. No.

VIN

Road test mileage out

Road test mileage in

Audi MMI/Navigation

Road Test (continued)

FF     Verify and set language and Measurement Units in Setup Menu

FF     Test operation of folding power top (Cabriolet)

FF     Set Time source setting to “GPS” and set Auto daylight savings
time to “on.” Change time zone to the appropriate dealer
location

FF     Verify operation of rear view camera and rear parking sensors
(if equipped)

FF     Navigation mode (if equipped): Set dealership location (for
following back to dealership during road test)

FF     Verify Audi side assist functionality (if equipped)
FF     Verify Audi active lane assist functionality (if equipped)
FF     Verify transmission operation including shift paddles
FF     Check steering/tire alignment

Audi connect (if equipped) (USA ONLY)
FF     Verify Audi connect Information Packet is present, including
Audi brochure, T-Mobile brochure, customer SIM card, T-Mobile
Terms & Conditions (T&C) (if applicable)
FF     Connect the dealer demo SIM card to the vehicle and make
sure the system fully connects to 2G or 3G (2G or 3G symbol
with arrows)(only applies if in a T-Mobile service area)
FF     Enable Google Earth in the navigation settings and verify the
white Google Logo appears next to the 2G or 3G symbol
FF     Ensure the wireless network is turned on (TEL function button
> Settings Ctrl button > Wi-Fi settings > Wi-Fi active > select
“Visible”)
FF     Check Wi-Fi hotspot functionality is enabled and verify the
SSID is set to “AUDIXXXXX,” where XXXXX = the last five digits
of VIN that are automatically preset in the system.

FF     Test drive vehicle applying brakes at least 4 times at 20 mph
(35 km/h) to clean brake rotors. Check for abnormal noise/
vibration/pulsation
FF     Parking brake: Apply and verify hold and release
FF     Verify quality of radio reception in AM/FM/SAT bands
FF     Verify cruise control/ACC functionality (if equipped)
FF     Verify functionality of heated/ventilated seats and neck-level
heating system (if equipped)
FF     Climate control: Verify all functions and ensure proper A/C
cooling
FF     Navigation function (if equipped): Activate NAV and follow
directions back to dealership
Post-Road Test Inspection

On-Hoist Inspection

FF     Interrogate fault memory using using Scan Tool and print
Diagnostic Log

FF     Check vehicle underside for fluid leaks and loose components

FF     Record final mileage on checklist and sign checklist

FF     Check steering, boots, brake system, hoses, tires and wheels
for damage

FF     Ensure the yellow tire pressure tag is installed on steering
wheel

FF     Remove transport suspension blocks (if installed)
FF     Inspect wheel bolts for proper torque using torque wrench
FF     Install wheel bolt covers and center caps as supplied
Road Test
FF     Check for squeaks, rattles and wind noise
FF     With engine running to conserve battery power, test folding
power top

If Vehicle is for Showroom Display/Inventory Storage or Demo
Use
FF     Install showroom charger to ensure battery remains charged at
all times
FF     Apply Inventory Maintenance Sticker
FF     Install standard wiper blades (if not already installed)

FF     Verify engine performance and acceleration
Technician
I certify that all operations have been completed and this vehicle has been prepared in accordance with Audi Procedures and
Quality Standards, and has met the standards for Perfect Delivery.
Technician Signature
Effective 10-1-2013
Version 1.0

Completion Date

2 of 2