Daimler Truck
North America LLC

Emission Recall

May 2023
D22R6

Subject: Emission Recall DETROIT™ DD13®, DD15®, DD16® Soot Sensor
Installation and Software Reprogramming
Models Affected: DD13, DD15, DD16 (471.928, 472.910, 472.912, 473.910)

General Information
Daimler Trucks North America LLC, on behalf of its Detroit Powertrain Division, is initiating Emission Recall D22R6
to modify the vehicles mentioned above.
Certain Detroit DD13®, DD15®, and DD16® engines were built without soot sensors due to global component
shortages and supply chain issues. The majority of these vehicles will require installation of a new soot sensor. All
of these vehicles will require reprogramming to a minimum of the ACM, MCM, CPC and TCM software versions
and fuel map versions listed below:
For DD15 w/ GATS 2.0:
 ACM Software Version 10.52.1.0 ZGS 001
 MCM Software Version 19.2.1.4 ZGS 001
 CPC Software Version R21.42.00.00A
 TCM (if applicable): Software Version NAMT201403
For DD13, DD15, DD16 w/ 1-Box Aftertreatment
 ACM Software Version 7.61.1.0 ZGS 003
 MCM Software Version:
o DD13: 14.3.1.1 ZGS 001
DD15: 6.9.0.2 ZGS 002
DD16: 6.9.0.2 ZGS 003
 CPC Software Version:
o CPC501T R20.11.00.00A or R20.31.00.00A
o CPC04T R44_00_000A
 TCM (if applicable):Software Version NAMT201403
Updated programming is available for DD13®, DD15®, and DD16® powered vehicles manufactured between June
2021 and December 2021. These DD13®, DD15®, and DD16® powered vehicles will need to have the ACM
reprogrammed, at minimum.
The California Air Resource Board (CARB) and the Environment Protection Agency (EPA) regulations require that
software and fuel maps meet certification criteria. Reprogramming the ACM corrects the fuel maps to new certified
versions, once a new soot sensor is installed.
There are approximately 38,376 engines affected by this Emission Recall.
Note that some engines are already reprogrammed and have had soot sensor installed. These engines are
excluded from this Emission Recall. In addition, the currently available software levels may be higher than the
minimum levels shown above.

IMPORTANT:
DPF failures and related fault codes, before and after Recall completion, are not caused by missing or failed soot
sensors and cannot be filed under D22R6 Emission Recall. Normal in Warranty procedures apply.

Daimler Truck

Emission Recall

North America LLC
May 2023
D22R6

Work Instructions
Please refer to the attached work instructions. Prior to performing the emission recall, check the vehicle for a
completion sticker (Form WAR260).

Replacement Parts
Replacement parts are now available and should be ordered before the customer arrives to avoid unnecessary
downtime. Please follow the guidelines below and allow time to receive parts.

NOTE: These recall kits are made available for D22R6 repairs ONLY and are not to be ordered and stocked
for warranty or customer purchase repairs.



1-Box equipped DD13®, DD15®, and DD16® (471.928, 472.910, 473.910) vehicles require Recall Kit
number DDE 25-D22R6-001
GATS 2.0 equipped DD15® (472.912) require Recall Kit Number DDE 25-D22R6-002

Table 1 – Replacement Parts for D22R6
Engine Model

Recall Kit Number

1-Box equipped
DD13®, DD15®, and DD16®
(471.928, 472.910, 473.910,)

DDE 25-D22R6-001

GATS 2.0 equipped
DD15® (472.912)

DDE 25-D22R6-002

Part Contents

Qty per Kit

Soot Sensor 1-Box

1

Soot Sensor Pigtail

1

PHM 1 1863 Splice Connector

4

Soot Sensor GATS 2.0

1

Soot Sensor Pigtail

1

PHM 1 1863 Splice Connector

4

Removed Parts
The original soot sensor pigtail and soot sensor orifice plug can be scrapped.

Page 2

Daimler Truck

Emission Recall

North America LLC
May 2023
D22R6

Labor Allowance
Table 2 – Labor Allowance for D22R6-A
Campaign
Group

Time
Allowed
(hours)

Procedure

SRT Number

Corrective
Action

D22R6-A
A

No Reprogramming or Soot Sensor
Install Required, INSPECTION ONLY

0.2 Hours

996-R156A

06-Inspect

A

Reprogram ONE Module, Install
Soot Sensor

0.9 - 1.0
Hours

996-R156B

12-Repair
Recall/Campaign

A

Reprogram TWO Modules, Install
Soot Sensor

1.0 - 1.1
Hours

996-R156C

12-Repair
Recall/Campaign

A

Reprogram THREE Modules, Install
Soot Sensor

1.2 Hours

996-R156D

12-Repair
Recall/Campaign

A

Reprogram FOUR Modules, Install
Soot Sensor

1.3 Hours

996-R156E

12-Repair
Recall/Campaign

Time
Allowed
(hours)

SRT Number

Corrective
Action

Table 3 – Labor Allowance for D22R6-B
Campaign
Group

Procedure

D22R6-B
B

No Reprogramming or Soot Sensor
Install Required, INSPECTION ONLY

0.2 Hours

996-R156A

06-Inspect

B

Reprogram ONE Module, Replace
Soot Sensor, Discard Pigtail

0.9 - 1.0
Hours

996-R156B

12-Repair
Recall/Campaign

B

Reprogram TWO modules, Replace
Soot Sensor, Discard Pigtail

1.0 - 1.1
Hours

996-R156C

12-Repair
Recall/Campaign

B

Reprogram THREE Modules, Replace
Soot Sensor, Discard Pigtail

1.2 Hours

996-R156D

12-Repair
Recall/Campaign

B

Reprogram FOUR modules, Replace
Soot Sensor, Discard Pigtail

1.3 Hours

996-R156E

12-Repair
Recall/Campaign

Page 3

Daimler Truck

Emission Recall

North America LLC
May 2023
D22R6

Claim Reimbursement
You will be reimbursed for your parts, labor, and handling (landed cost for Export Distributors) by submitting your
claim through the Warranty system within 30 days of completing this recall. Please reference the following information
in OWL.
Table 3 – Claim Reimbursement for D22R6
Claim Type

Recall Campaign

Campaign

D22R6

Component Code
Cause Code
Primary Failed Part

043-007-172
A1-Campaign
DDE A0111531228
Procedure A1

Use this procedure if repair and programming was NOT REQUIRED.
Labor Number

996-R156A
INCPECTION ONLY

Labor Hours

0.2 Hours

Part Number

DDE A0111531228

Parts Return

SCRAP

Use one of the following procedures if repair and programming was REQUIRED.
Procedure B1
Labor Number

996-R156B
SOOT SENSOR REPAIR AND PROGRAM ONE MODULE

Labor Hours

0.9 - 1.0 Hours

Part Number

DDE A0111531228

Parts Return

SCRAP
Procedure C1

Labor Number

Page 4

996-R156C
SOOT SENSOR REPAIR AND PROGRAM TWO MODULES

Labor Hours

1.0 - 1.1 Hours

Part Number

DDE A0111531228

Parts Return

SCRAP

Daimler Truck

Emission Recall

North America LLC
May 2023
D22R6
Procedure D1
Labor Number

996-R156D
SOOT SENSOR REPAIR AND PROGRAM THREE MODULES

Labor Hours

1.2 Hours

Part Number

DDE A0111531228

Parts Return

SCRAP
Procedure E1

Labor Number

1

996-R156E
SOOT SENSOR REPAIR AND PROGRAM FOUR MODULES

Labor Hours

1.3 Hours

Part Number

DDE A0111531228

Parts Return

SCRAP

Administrative time (SRT 939-6010A) for 0.3 hours is automatically added to the claim.

IMPORTANT: OWL must be viewed prior to beginning work to ensure the vehicle is involved in the recall and the
campaign has not previously been completed.
For questions, U.S. and Canadian dealers, contact the Warranty Campaigns Department via Web inquiry at
DTNAPortal.com using the WSC function.

Page 5

Daimler Truck
North America LLC
May 2023
D22R6

Emission Recall
Detroit Diesel Corporation
13400 Outer Drive, West
Detroit, Michigan 48239-4001
Telephone: 313‐592‐5000

Copy of Notice to USA Registered Owners
Subject: Emission Recall D22R6 DETROIT™ DD13®, DD15®, DD16® Soot
Sensor Installation and Software Reprogramming
This notice was sent to you in accordance with the requirements of California emission standards and regulations.
Daimler Truck North America LLC manufactured some certified DD13®, DD15®, and DD16® engines without soot
sensors due to global component shortages. Engines registered in California will require reprogramming to a
minimum software and fuel map version, with soot sensor installation. California Air Resources Board (CARB)