INDIAN MOTORCYCLE

HELP CENTER
SEARCH

What can we help you find?

Help Center Home / Article

4/6/2023

2014+ Chieftain Battery Removal and Installation
Indian Chieftain Battery Removal and Installation - Indian Motorcycle

Required Tools and Supplies
Dielectric Grease or Petroleum Jelly
5mm Allen Socket
Ratchet
Shop Rags

10mm Socket
6mm Allen Socket
Torque Wrench
Safety Glasses & Nitrile Gloves

Always wear safety glasses and nitrile gloves when servicing your Indian Motorcycle. To remove and
replace the battery on your Chieftain, follow these steps:
1. Park the motorcycle on a flat, level surface.
2. Ensure the bike is powered OFF.
3. Remove the upper side covers by pulling the corners straight out to disengage from the rubber
grommets in the frame.

4. To remove the seat, first use a 6mm Allen socket to remove the two fasteners securing the driver’s
seat to the frame.
5. Then remove the passenger seat fastener with a 5mm Allen socket.
6. Lift the rear of the seat and pull rearward to disengage the front retaining arms.
7. Use a 5mm Allen socket to remove the fastener securing the Vehicle Control Module mounting
plate to the top of the battery box.
8. Slide the VCM assembly forward to disengage the tabs.
9. Carefully place it out of the way. Do not disconnect the VCM. Ensure the VCM does not touch the
positive battery terminal or cable. This can cause the VCM to short out.
10. Remove the negative battery cable first with a 10mm socket. Position the cable well clear of the
terminal.
11. Remove the positive protector boot from the positive battery cable. Then remove the cable from
the terminal with a 10mm socket. Position the cable well clear of the terminal.
12. Reinstall the fasteners onto the posts to prevent misplacement.
13. Lift the battery straight up and out of the battery box.
14. Inspect the battery box and cover for damage. Ensure the pads are properly located and in good
condition.
15. If reinstalling the battery, ensure it is fully charged and free of any debris or damage. Follow the
instructions in the Battery Charging section of your Owner’s Manual before installing the battery.
16. Carefully position the battery into the battery box with the negative terminal toward the front of
the motorcycle.
17. Route the positive cable perpendicular to the long side of the battery. Install the positive cable
first to prevent arcing. Torque to 45 in-lbs (5 Nm).
18. Reinstall the positive cable protector boot.
19. Then install the negative cable. Route the cable perpendicular to the battery. Torque to 45 in-lbs
(5 Nm).
20. Apply a light film of dielectric grease or petroleum jelly to the terminals.
21. Verify the cables are secure and properly routed.

22. Carefully reinstall the VCM mounting plate and fastener, avoiding any contact with the positive
battery cable. Torque to 84 in-lbs (9.5 Nm).
23. Turn the bike ON to verify the battery has been connected properly.
24. Reinstall the seat by engaging the front retainers and aligning the mounting holes.
25. Reinstall the two driver’s seat fasteners. Torque to 84 in-lbs (9.5 Nm).
26. Align the passenger seat bracket over the rubber washer. Torque the fastener to 84 in-lbs (9.5
Nm).
27. Finally, align the three side panel grommets and reinstall each upper side panel.
For more information, see your authorized Indian Motorcycle Dealer. Find a dealer near you with
the Dealer Locator.
Maintenance tips, procedures and specifications can be found in your Owner's Manual.
To find diagrams and replacement part numbers, use the online parts catalog.
YouTube® is a registered trademark of Google LLC
Unless noted, trademarks are the property of Indian Motorcycle International, LLC
© 2022 Indian Motorcycle International, LLC
Was this article helpful?
Yes, it answers my question
No, it's missing information or visuals
No, the instructions are unclear
No, What are the next steps?
No, I'm experiencing a technical error
Other

* [-] How can we improve this article? We'd love to hear your suggestions
Tell us what you would like to see in this article

SEND

Keyword(s) video , maintenance , battery , remove , removing , install , installing ,

HELPFUL LINKS
Parts, Accessories and Apparel
Owner's Manuals
Indian Motorcycle Protection Plan
Special Offers
Recalls
Indian Motorcycle Lubricants

CONTACT US
BY E-MAIL
Send us an e-mail inquiry.

CLICK TO CALL

BY DEALER
Locate the nearest dealer in your area.

Find A Dealer Near You
Enter City, State or Zip Code
55033

SEARCH

Use Current Location

Filter By (Optional)
Show dealers that offer online service scheduling

Reset Filters

SUBSCRIBE NOW
FIND A DEALER
US-ENGLISH

MOTORCYCLES
SHOPPING TOOLS
ASSISTANCE
OWNER RESOURCES
ABOUT US
© 2023 Indian Motorcycle
Site Map
Privacy
Cookie Preferences

Terms
Accessibility
Careers
Global Sites