SLINGSHOT

HELP CENTER
What can we help you find?

SEARCH

Help Center Home / Article

4/18/2023

Battery Maintenance for Model Year 2019 and Older Slingshot
Maintaining Your Battery | Slingshot

This article contains information for model year 2019 and older Slingshot vehicles.
For battery service on model year 2020 and newer Slingshot models, see your Slingshot Dealer. Do
NOT remove the battery yourself. Read 2020+ Slingshot Battery Maintenance for more information
about caring for the battery.
When servicing your model year 2019 and older Slingshot, always wear safety glasses and nitrile
gloves.
Battery Access and Removal
The battery compartment (1) on these models is located on the lower-left side of the Slingshot,
behind the rider compartment.

To remove the battery:
1. Remove the access panel fasteners and remove the access panel. This requires removing two
plastic push darts and two T40 TORX® screws.
2. Disconnect the negative battery cable (2).

3. Remove the three bolts (3) holding the battery bracket.

4. Disconnect the positive battery cable.
5. Slide the battery out.
Battery Installation
The battery is part number 4014609. Contact your authorized Slingshot Dealer to order a new
battery. Using a new battery that has not been fully charged can damage the battery and result in a
shorter life. It also can hinder vehicle performance.
To install the battery:
1. Make sure the battery is fully charged.
2. Slide the battery into place.
3. Connect the positive battery cable (1).

4. Replace the three bolts to secure the battery bracket.
5. Connect the negative battery cable (2).

6. Reinstall the battery access panel.
Note that improperly connecting or disconnecting battery cables can result in an explosion and
cause serious injury or death. When removing the battery, always disconnect the negative (black)
cable first. When reinstalling the battery, always connect the negative (black) cable last.
Battery connections should be tightened to the correct torque during installation. This will reduce
voltage drop and ensure a reliable connection between the alternator and battery.
AGM Batteries
Model Year 2016 and newer Slingshot vehicles use Absorbed Glass Mat (AGM) maintenance-free
batteries. AGM batteries are selected for their superior vibration resistance, weight savings and high
output.
Low-maintenance, sealed batteries are already filled with electrolyte and have been sealed and fully
charged at the factory. If they're not fully charged before use, battery life will be significantly
reduced. Never pry the sealing strip off or add any other fluid to the battery. Never add electrolyte
or distilled water to a low maintenance battery. Doing so will damage the case and shorten the life
of the battery.
Slingshot recommends using the BatteryMINDer® 2012 AGM 2-AMP battery charger (part number
2830438) to charge and maintain AGM batteries. If the vehicle will not be driven for more than 2
weeks, maintaining the battery with the BatteryMINDer® 2012 AGM 2-AMP charger is
recommended.

Batteries that fall below 12.5 volts run the risk of sulfation, a condition whereby sulfate crystals form
inside the battery and significantly reduce performance. AGM chargers are designed specifically for
charging AGM type batteries and use high frequency pulses to partially reverse sulfation.
The nominal voltage for a Slingshot AGM battery is 12.8V when fully charged. The battery will selfdischarge when disconnected from a vehicle, and will discharge at a faster rate when connected. If
the battery voltage falls below 12.5V, it should be charged immediately using the recommended
battery charger. Wait for the charger to complete the charge cycle before disconnecting it.
The use of non-AGM battery chargers or non-AGM battery tenders may result in a misleading
"battery not found" or "open cell" fault message. Please ensure you are using the recommended
AGM charger when charging AGM type batteries.
For added convenience, Slingshot offers the BatteryMINDer® Accessory Vehicle Power Plug (part
number 2830518), which allows easy connection to the vehicle's battery through the 12-volt socket.
The 12V socket located between the seats, directly above the cup holders, can be used for charging.
The 12V socket located in the glove box is powered after key-on and cannot be used for charging.
AGM batteries discharged to a voltage of 3V or less may not be recognized by the recommended
automatic battery charger (the minimum voltage threshold recognized by other battery chargers
may be as high as 10.5V). Often times, deeply discharged batteries can be restored by attaching
another, fully-charged battery to "jump start" the low battery. Follow the steps below to restore a
deeply discharged battery.
1. Carefully connect the two batteries' positive terminals and then the negative terminals using
jumper cables.
2. Connect the recommended battery charger to the low battery and initiate the charging
sequence. Warning: Always check to ensure the positive cables are connected to the positive
terminals before powering on the charger. Reversing polarity when charging can damage electrical
components and risk personal injury. Be careful not to let battery cable clamps touch each other.
3. After the charging sequence has initiated, disconnect the fully-charged battery. Always disconnect
the fully-charged battery positive first, followed by low battery positive, low battery negative and
finally, fully-charged battery negative.
4. Proceed with charging both batteries to full capacity.
Conventional Batteries
Model Year 2015 Slingshot vehicles came factory-equipped with flooded lead-acid batteries.
Lead Acid Conventional batteries must be fully charged before use or their life will be significantly
reduced.

If the battery is stored or used in a partially charged condition or with low electrolyte levels, hard
crystal sulfation will form on the plates, reducing the efficiency and service life of the battery.
A poorly maintained battery will deteriorate rapidly. Check the battery fluid level often. Add only
distilled water. Tap water contains minerals that are harmful to a battery.
For Model Year 2015 models with flooded batteries, the BatteryMINDer® 1510 1.5-AMP battery
charger is recommended (part number 2830404). You can find parts for your vehicle through the
online parts catalog.
Battery Maintenance During Storage
Whenever your Slingshot is not used for one month or longer, remove the battery from the vehicle.
Ensure it is fully charged and store it out of the sun in a cool, dry place. Batteries will self-discharge
more rapidly when stored in extreme temperatures. Check the battery voltage each month during
storage. Recharge as needed to maintain a full charge.
Consult your Owner’s Manual for complete instructions for battery testing, maintenance and
charging.
Warnings
No matter what type of battery your Slingshot is equipped with, note that improperly connecting or
disconnecting battery cables can result in an explosion and cause serious death or injury. When
removing the battery, always disconnect the negative (black) cable first. When reinstalling the
battery, always connect the negative (black) cable last.
Also be aware that battery electrolyte is poisonous. It contains sulfuric acid, and contact with skin,
eyes or clothing can result in serious burns. For external exposure, flush with water. For internal
exposure, drink large quantities of water or milk. Follow with milk of magnesia, a beaten egg or
vegetable oil. Call a physician immediately. Flush eyes with water for 15 minutes and get prompt
medical attention.
Always keep battery terminals and connections free of corrosion. If cleaning is necessary, remove
corrosion with a terminal brush. Wash with a solution of one tablespoon baking soda and one cup
water. Rinse well with tap water and dry off with clean shop towels. Coat the terminals with dielectric
grease or petroleum jelly. Be careful not to allow cleaning solution or tap water into a conventional
battery. Batteries will self-discharge more quickly when dirty.
Make sure battery connections are tight. This will reduce voltage drop and ensure a reliable
connection between the alternator and battery. See your Owner's Manual for torque specifications.
For more information, see your authorized Slingshot Dealer. Find a dealer near you with the Dealer
Locator.

Maintenance tips, procedures and specifications can be found in your Owner's Manual.
To find diagrams and replacement part numbers, use the online parts catalog.
Batteryminder® is a registered trademark of VDC Electronics Inc.
TORX® is a registered trademark of Acument Intellectual Properties, LLC
Unless noted, trademarks are the property of Polaris Industries Inc.
© 2022 Polaris Industries Inc.

Was this article helpful?
Yes, it answers my question
No, it's missing information or visuals
No, the instructions are unclear
No, What are the next steps?
No, I'm experiencing a technical error
Other

* [-] How can we improve this article? We'd love to hear your suggestions
Tell us what you would like to see in this article

SEND
Keyword(s) video , instruction , maintenance , battery , tips , location , removal , installation , install , remove , located , charge , charging ,
slingshot ,

HELPFUL LINKS
Parts, Accessories and Apparel
Owner's Manuals
Safety Information

Polaris Protection Plan
Special Offers
Recalls
Slingshot Lubricants

CONTACT US
BY E-MAIL
Send us an e-mail inquiry.

CLICK TO CALL

BY DEALER
Locate the nearest dealer in your area.

FIND A DEALER NEAR YOU
Enter City, State or Zip Code
55422

SEARCH

Use Current Location

Reset Filters

Filter By (Optional)
Show dealers that offer online service scheduling

Site Map

Privacy
Cookie Preferences

Terms

Accessibility

Global Sites

Slingshot® is a three-wheeled motorcycle. It is not an automobile. It does not have airbags and it does not meet automotive safety standards.
Three wheel vehicles may handle differently than other vehicles, especially in wet conditions. Always wear a DOT-approved full-face helmet and
fasten seatbelts. The Driver may need a valid motorcycle endorsement. Don’t drink and drive.
© 2023 Polaris Inc.