Start-Up Procedure

Bulletin Type:

Publication Date:

February 2023

23-086

Make(s):

Entegra Coach

2023-2024

Model(s):

Aspire, Anthem, Cornerstone

INC

Bulletin No:
Model Year (s):
Incident:
Affected Units:

Understanding the start-up procedure
2023-2024 Entegra Coach Aspire, Anthem, Cornerstone

Start-up Procedure Instructions
At the time of pick up, the delivery driver should use the following start-up procedure:
1. Turning on the disconnect switches:
A
C
B
A. Use the round Trimark key to unlock the
baggage doors to access the disconnect
switches.
B. Turn on the (2) Chassis Battery Disconnect
Switches in the rear battery compartment.
C. Turn on the (4) House Battery Disconnect
Switches in the passenger mid storage
compartment.
D. Turn on the Main Disconnect Switch inside the unit mounted on passenger lower panel.
2. Starting the unit:
C
A. Keys must be within proximity of the driver’s
A
seat.
B. Apply foot to brake
C. Push the start button one time (green light
should be solid)
D. The vehicle’s grid heater must heat up before the
vehicle starts. Wait for the Malfunction Indicator
Lamp (upper right corner) and the Wait to Start
B
Indicator Lamp (upper left corner) lamp to go
out before starting.
E. Push and hold the start button a second time to start the vehicle.
23-086_INC Start-up Procedure

February 2023

Page 1 of 4

3. Adjust Pedals and Steering Column
Aspire
A. Aspire: Use the foot pedal located
on the left side of the steering
column. To adjust the tilt and
telescope of the column, push the
pedal down, move to the desired
location, then release the pedal.
B. Anthem/Cornerstone: Through the
Center Console Interface (CCI), use
the Controls screen to control the
positioning of the items listed below:
i. Steering wheel tilt: Press Tilt to set the vertical position of the steering wheel. (Figure 1)
ii. Steering wheel telescope (distance from driver's seat): With the vehicle in PARK, press Tele
to set the horizontal distance of the steering wheel from the dash. (Figure 2)
iii. Floor pedals: Press Pedals control to adjust the distance of the gas and brake pedals from
the firewall or driver’s seat. (Figure 3)
Fig. 3

Fig. 2

Fig. 1

4. Raising Jacks (jacks down on CCI)
A. Through the Center Console Interface (CCI), use the Leveling screen to control the jacks controls.
B. Select “All Retract”.
5. Parked Vehicle
A. Any time a vehicle is parked for any length of storage time, all the disconnect switches from step #1
should be turned off.
After delivery, the Dealer should use the following start-up procedure:
1. Turning on the disconnect switches:
A. Use the round Trimark key to unlock the
C
A
B
baggage doors to access the disconnect
switches.
B. Turn ON the (2) Chassis Battery Disconnect
Switches in the rear battery compartment.
C. Turn ON the (4) House Battery Disconnect
Switches in the passenger mid storage
compartment.
D. Turn the Rotary Disconnect to the ON position
E. Initiate the inverter by pressing the Inverter Toggle Switch (Red Box on D)
F. Turn on the Main Disconnect Switch inside the unit mounted on passenger lower panel.
23-086_INC Start-up Procedure

February 2023

D

Page 2 of 4

2. Power Shore Connection:
A. Aspire:
i. Firefly Vegatouch Home Screen, press the Electrical icon. (Red Box in A)
ii. At the Electrical Screen
1. Tap the Inverter icon to enable the inverter. (Red Box in B)
2. Tap the Charger Icon to enable the charger. (Red Box in C)
iii. Plug in the Power Shore Cord
iv. The Inverter icon should change to pass through and Charger icon should change to Bulk at
the main screen on the Firefly Vegatouch Screen.
A

C

B

B. Anthem/Cornerstone:
i. Firefly Vegatouch Home Screen, press and hold the Inverter icon
ii. At the Go Power Inverter Screen (Red box on A)
1. Tap the “INV 1” icon. The icon should change from Orange to Green. (Green Box on
B)
2. Tap the “CHG 1” Icon. Below the icon should show enabled but the stay Orange.
(Orange Box on B)
iii. Plug in the Power Shore Cord
iv. Go back to the Firefly Vegatouch Screen. The “CHG 1” icon should now be green.
1. NOTE: If the operation sequence is not followed, the inverter AC Out will not have
voltage. Verify the system connected correctly by reviewing.

A

B

yco’s sole obligation under our limited warranty is to repair or replace defective materials and/or workmanship deemed our responsibility as determined by
Jayco in our sole discretion. Jayco reserves the right to use new and/or remanufactured parts or materials of similar quality to complete any work, and to
make parts and/or design changes as appropriate without notice to anyone. Jayco designs and/or materials changes are done without obligation to
incorporate such changes in previously manufactured product. Jayco makes every reasonable effort to ensure field remedies will not adversely affect
performance and/or safety of the unit. This field remedy is not intended to extend to future performance of this RV, or any of its materials, components or
parts beyond the standard warranty period. The RV owner’s obligation to notify Jayco, or one of its independent, authorized dealers, of a claimed defect
does not modify any obligation placed on the RV owner to contact Jayco directly when attempting to pursue remedies under state or federal law. Jan. 2019.

23-086_INC Start-up Procedure

February 2023

Page 3 of 4

03 South Main Street • P.O. Box 460 • Middlebury, IN 46540

23-086_INC Start-up Procedure

February 2023

Page 4 of 4