Technical Service Bulletin
00 PDI inspection - IQS supplement
00 13 56 2035669/1 November 1, 2013.

Model(s)

Year

VIN Range

Vehicle-Specific Equipment

A6, A7, Q5, Q7

2014

All

Not Applicable

Condition
There are special service instructions to be performed on all Model Year 2014 A6, A7, Q5, and Q7 vehicles before
the vehicles are delivered to customers.

Technical Background
When performing PDI inspections on vehicles delivered from November 2013 - February 2014, please prepare the
vehicles for delivery with a special focus on the areas listed in this bulletin. These checks can be performed during
the normal PDI inspection process.
Contact the Technical Assistance Center (TAC) with any questions about the information in this bulletin.

Production Solution
Not applicable.

© 2013 Audi of America, Inc.

Page 1 of 4

All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of
Audi of America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval
system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior
expressed written permission of the publisher.

Technical Service Bulletin
Service
The Service steps below are sorted by model. Refer to the appropriate section for the model that is being
inspected.
For 2014 A6 and A7:
✔ Check Brakes for Pulsation/Vibration (3.0T engines only):
• If vibration or pulsation is felt while
braking (in brake pedal or in entire
vehicle) at speeds higher than 20
mph, put the vehicle on a lift and
inspect the brake discs for pad marks
(Figure 1).
• Replace only those brake discs that
have pad marks (Figure 1). Use the
following part numbers:
• Front brake disc: 4G0615301A
• Rear brake disc: 4H0615601H

Figure 1. Brake pad marks on brake disc.

For 2014 Q5:
✔ Check for Rattle Noise in Driver Side Door or Dash:
• During test drive, drive over a bumpy road. If a rattling or buzzing noise is heard from the dash area, refer
to instructions in TSB 2035626: Rattle noise from driver side door or dash area.
✔ Check for Brake Squeal from Front Brakes (Non-Hybrid Vehicles only):
• If a squealing sound is heard when brakes are applied lightly when the vehicle is driven at a low speed,
submit a PSS ticket under the topic PSS 46 Brake noise (non-hybrid vehicles).

© 2013 Audi of America, Inc.

Page 2 of 4

All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of
Audi of America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval
system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior
expressed written permission of the publisher.

Technical Service Bulletin
For 2014 Q7:
✔ Check for EVAP Leak DTC in Engine Control Module (ECM) (3.0T engines only):
• Use ODIS to check the DTC memory of the ECM, J623 (address word 01) for the following DTCs:
• DTC P0456 (EVAP System Leak Detected (very small leak))
• DTC P0442 (EVAP System Leak Detected (small leak))
• If either DTC is present, replace the Leak Diagnostic Pump (LDP).
• Use the following part number:
• LDP: 7L8906271A
✔ Check A Pillar Trim:
• If the A pillar trim on either side of the vehicle is
loose or ill-fitting as shown at right (Figure 5),
replace the trim.

Figure 5. Loose A pillar trim.
• When installing the new trim make certain that the
assembly support strap is not trapped or pinched
between the adapter and the A pillar structure
(Figure 6).

Figure 6. Location of the assembly support strap
along A pillar trim bracket.
© 2013 Audi of America, Inc.

Page 3 of 4

All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of
Audi of America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval
system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior
expressed written permission of the publisher.

Technical Service Bulletin
Warranty
Use applicable labor operations as per Elsa for each repair performed.

Additional Information
All parts and service references provided in this TSB (2035669) are subject to change and/or removal. Always
check with your Parts Department and service manuals for the latest information.

© 2013 Audi of America, Inc.

Page 4 of 4

All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of
Audi of America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval
system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior
expressed written permission of the publisher.