T-SB-0034-22

April 5, 2022

2022 Tundra HV Pre-Delivery Service (PDS)
Service
Category

General

Section

Pre-Delivery Service

Market USA

Applicability
YEAR(S)

MODEL(S)

2022

Tundra HV

ADDITIONAL INFORMATION

Introduction

Pre-Delivery Service (PDS) is a critical step in satisfying our new car customers. Customer
feedback indicates the following areas deserve special attention when performing PDS:





Careful inspection for paint chips/scratches and body dents/dings.
Proper operation of electrical accessories (including interior light, clock, and radio reset).
Interior cleanliness.
Proper function of mechanical systems.

Customer retention and proper maintenance of vehicles are and have always been a major focus
for Toyota. To help remind customers that regular service is essential to the proper maintenance
of the vehicle, dealers are required to install a service reminder sticker before delivery. By doing
this, customers will be reminded to return to your dealership for service. Your current service
reminder sticker may be used. (See PDS Check Sheet item 8 of “Final Inspection and Cleaning.”)
This bulletin contains the PDS procedures that apply specifically to 2022 model year Tundra HV
vehicles. A universal PDS Check Sheet that contains PDS steps that apply to all 2022 model year
Toyota vehicles has been developed. To properly perform a complete PDS, you must complete
all procedures contained in this TSB as well as the universal PDS Check Sheet.
In addition, if the vehicle is stored for over 30 days, be sure to follow Long-Term Vehicle
Storage Guidelines.

© 2022 Toyota Motor Sales, USA

Page 1 of 5

T-SB-0034-22

April 5, 2022

Page 2 of 5

2022 Tundra HV Pre-Delivery Service (PDS)
Warranty Policy

If the need for additional repairs or adjustment is noted during PDS, the required service should
be performed under warranty. Reimbursement will be managed under the warranty policy.
The Warranty Policy and Procedures Manual requires that you maintain the completed
Check Sheet in the customer’s file. If you cannot produce a completed form for each retailed
vehicle upon TMS and/or Region/Distributor audit, the PDS payment amount will be subject
to debit.
An additional Repair Order completed in conjunction with normal PDS MUST have time
punch/flags for service. If multiple repairs are performed, separate time flags MUST be punched
for each repair.

Warranty Information
OP CODE

DESCRIPTION

MODEL

TIME

OFP

T1

T2

001013

Pre-Delivery Service (PDS)

Tundra

0.9

–

–

–

Required Tools & Equipment
REQUIRED EQUIPMENT

SUPPLIER

Techstream ADVi*

QTY

TSADVUNIT

Techstream 2.0
Techstream Lite

PART NUMBER

TS2UNIT
ADE

Techstream Lite (Green Cable)

TSLITEPDLR01
TSLP2DLR01

*Essential SST.

NOTE
 Only ONE of the Techstream units listed above is required.
 Software version 16.30.011 or later is required.
 Additional Techstream units may be ordered by calling Approved Dealer Equipment (ADE)
at 1-800-368-6787.

© 2022 Toyota Motor Sales, USA

1

T-SB-0034-22

April 5, 2022

Page 3 of 5

2022 Tundra HV Pre-Delivery Service (PDS)
Procedures



D/C Cut Fuse Installation ........................................................................................................... 3



Seating Position Control ECU Initialization ................................................................................. 4



Front License Plate and Mounting Bracket Installation* .............................................................. 4



Set Hybrid Radio Feature to “OFF”............................................................................................. 4



Navigation — “Set Date & Time by GPS” ................................................................................... 5



Tire Pressure Warning System (TPWS) Initialization .................................................................. 5



Multimedia Software Update ...................................................................................................... 5

*If applicable.

D/C Cut Fuse Installation

To minimize battery discharge, the D/C cut fuse (30A) has been removed and is stored in the
engine compartment relay block. Install the D/C cut fuse (30A) and confirm ALL related
Diagnostic Trouble Codes (DTCs) are cleared.
Figure 1.

1

2

3

1

Relay Block

2

Install D/C Cut Fuse (30A)

3

Remove D/C Cut Fuse (30A)

© 2022 Toyota Motor Sales, USA

T-SB-0034-22

April 5, 2022

Page 4 of 5

2022 Tundra HV Pre-Delivery Service (PDS)
Seating Position Control ECU Initialization

Refer to the applicable Repair Manual for the seating position control ECU
initialization procedure (procedure 2).

Front License Plate and Mounting Bracket Installation

1. Align the holes on the license plate mounting bracket with the dimples on the front of
the bumper.
NOTICE
Do NOT drill holes through the front bumper or overtighten the self-tapping screws.

2. Install two long self-tapping screws through the recessed holes on the license plate mounting
bracket and screw them through the bumper.
3. Insert the license plate onto the tabs on the license plate mounting bracket.
4. Align the holes on the license plate with the holes on the license plate mounting bracket.
5. Install one short self-tapping screw through the driver side license plate hole extending into the
license plate mounting bracket.
6. Install one short self-tapping screw through the passenger side license plate hole extending
into the license plate mounting bracket.

Set Hybrid Radio Feature to “OFF”

Without a Wi-Fi subscription, the customer will receive a “Subscription Required” pop-up while in
weak broadcast radio signal areas. This pop-up notification may cause confusion to the customer.
Therefore, it is necessary to toggle the Hybrid Radio feature to the “OFF” position.
1. Turn the engine switch (power switch) to ON position (ON mode).
2. Navigate the following menus in the head unit: Settings – Sound and Media – Radio –
Hybrid Radio.
3. Ensure the Hybrid Radio function is set to the “OFF” position.
NOTE
The “Enable hybrid radio” feature is factory preset to the “ON” position.

© 2022 Toyota Motor Sales, USA

T-SB-0034-22

April 5, 2022

Page 5 of 5

2022 Tundra HV Pre-Delivery Service (PDS)
Navigation — “Set Date & Time by GPS”

Prior to selling a Toyota/Lexus vehicle, we are asking that dealers please confirm that they have
turned the “Set time by GPS” functionality on in each vehicle. Therefore, it is necessary to turn
the Set Time by GPS setting to the “ON” position.
1. Turn the engine switch (power switch) to ON position (ON mode).
2. Navigate the following menus in the head unit: Settings – General – Date & Time – Set date &
time by GPS.
3. Ensure the Set date & time by GPS function is set to the “ON” position.

Tire Pressure Warning System (TPWS) Initialization

Refer to the applicable Repair Manual for the TPWS initialization procedure. Note the spare tire
does NOT have a TPWS sensor.
NOTE
To adjust the tire pressure correctly when the outside temperature is significantly colder than shop
temperature, perform a Health Check using Techstream and select the compensation tire pressure
checkbox. Compensation pressures will display on the Health Check results screen. Adjust the tire
pressure when the tires are cold.

Multimedia Software Update

Refer to T-SB-0023-22 Head Unit Software Update (Panasonic) to validate the latest software update
is present in the vehicle Multimedia System interface.

© 2022 Toyota Motor Sales, USA