T-SB-0058-21

Rev1

July 26, 2021

2022 Camry, Camry HV Pre-Delivery Service (PDS)
Service
Category

General

Section

Pre-Delivery Service

Market USA

Applicability
YEAR(S)

MODEL(S)

2022

Camry, Camry HV

ADDITIONAL INFORMATION

REVISION NOTICE
January 12, 2022 Rev1:
 The Procedures and D/C Cut Fuse Installation sections have been updated.
Any previous printed versions of this bulletin should be discarded.

Introduction

Pre-Delivery Service (PDS) is a critical step in satisfying our new car customers. Customer
feedback indicates the following areas deserve special attention when performing PDS:





Careful inspection for paint chips/scratches and body dents/dings.
Proper operation of electrical accessories (including interior light, clock, and radio reset).
Interior cleanliness.
Proper function of mechanical systems.

Customer retention and proper maintenance of vehicles are and have always been a major focus
for Toyota. To help remind customers that regular service is essential to the proper maintenance
of the vehicle, dealers are required to install a service reminder sticker before delivery. By doing
this, customers will be reminded to return to your dealership for service. Your current service
reminder sticker may be used. (See PDS Check Sheet item 8 of “Final Inspection and Cleaning.”)
This bulletin contains the PDS procedures that apply specifically to 2022 model year Camry and
Camry Hybrid vehicles. A universal PDS Check Sheet that contains PDS steps that apply to all
2022 model year Toyota vehicles has been developed. To properly perform a complete PDS, you
must complete all procedures contained in this TSB as well as the universal PDS Check Sheet.
In addition, if the vehicle is stored for over 30 days, be sure to follow Long-Term Vehicle
Storage Guidelines.

© 2021 Toyota Motor Sales, USA

Page 1 of 9

T-SB-0058-21

Rev1

July 26, 2021

Page 2 of 9

2022 Camry, Camry HV Pre-Delivery Service (PDS)
Warranty Policy

If the need for additional repairs or adjustment is noted during PDS, the required service should
be performed under warranty. Reimbursement will be managed under the warranty policy.
The Warranty Policy and Procedures Manual requires that you maintain the completed
Check Sheet in the customer’s file. If you cannot produce a completed form for each retailed
vehicle upon TMS and/or Region/Distributor audit, the PDS payment amount will be subject
to debit.
An additional Repair Order completed in conjunction with normal PDS MUST have time
punch/flags for service. If multiple repairs are performed, separate time flags MUST be punched
for each repair.

Warranty Information
OP CODE

DESCRIPTION

001013

Pre-Delivery Service (PDS)

MODEL

TIME

Camry

1.0

Camry HV

1.5

OFP

T1

T2

–

–

–

Required Tools & Equipment
REQUIRED EQUIPMENT

SUPPLIER

Techstream ADVi*

QTY

TSADVUNIT

Techstream 2.0
Techstream Lite

PART NUMBER

TS2UNIT
ADE

Techstream Lite (Green Cable)

TSLITEPDLR01
TSLP2DLR01

*Essential SST.

NOTE
 Only ONE of the Techstream units listed above is required.
 Software version 16.30.011 or later is required.
 Additional Techstream units may be ordered by calling Approved Dealer Equipment (ADE)
at 1-800-368-6787.

© 2021 Toyota Motor Sales, USA

1

T-SB-0058-21

Rev1

July 26, 2021

Page 3 of 9

2022 Camry, Camry HV Pre-Delivery Service (PDS)
Procedures



D/C Cut Fuse Installation ..................................................................................................... 4



Memorize Steering Angle Neutral Point* .............................................................................. 5



Steering Sensor Zero Point Calibration* .............................................................................. 5



Front Wheel Opening Extension Pad Installation ................................................................. 6



Front License Plate and Mounting Bracket Installation* ........................................................ 7



Installation of Rubber Body Plugs*........................................................................................ 8



Dealer Contact Information for Call Dealer Head Unit Function ............................................ 9



Entune™ 3.0 App Suite Connect Initialization/Update ......................................................... 9

*If applicable.

© 2021 Toyota Motor Sales, USA

T-SB-0058-21

Rev1

July 26, 2021

Page 4 of 9

2022 Camry, Camry HV Pre-Delivery Service (PDS)
D/C Cut Fuse Installation
To minimize battery discharge, the D/C cut fuse (25A) has been removed and is stored in the
engine compartment relay block. Install the D/C cut fuse (25A) and confirm ALL related
Diagnostic Trouble Codes (DTCs) are cleared.
Figure 1.

1

2
3

1

Relay Block

2

Remove D/C Cut Fuse (25A)

3

Install D/C Cut Fuse (25A)

© 2021 Toyota Motor Sales, USA

T-SB-0058-21

Rev1

July 26, 2021

Page 5 of 9

2022 Camry, Camry HV Pre-Delivery Service (PDS)
Memorize Steering Angle Neutral Point

As a result of the removal of the D/C cut fuse, the power source to the steering angle sensor is
cut off. When the D/C cut fuse is reinstalled, the parking assist monitor system/panoramic view
monitor system will be operative, but it cannot display guidelines to assist parking operation
because the center position recognized by the steering angle sensor may not be in an initial
position. Therefore, perform steering angle neutral point initialization AFTER installing the D/C
cut fuse during PDS.
Refer to the applicable Repair Manual for the steering angle neutral point initialization procedure
(Camry / Camry HV).

Steering Sensor Zero Point Calibration

As a result of the removal of the D/C cut fuse, the steering angle sensor power source is cut off.
When the D/C cut fuse is reinstalled, the center position recognized by the steering angle sensor
may not be the appropriate position. Therefore, it is necessary to perform steering sensor zero
point calibration AFTER installing the D/C cut fuse during PDS.
Refer to the applicable Repair Manual for the steering sensor zero point calibration procedure:


Driving Method (Camry / Camry HV).



Techstream Method (Camry / Camry HV) (procedure 4).

© 2021 Toyota Motor Sales, USA

T-SB-0058-21

Rev1

July 26, 2021

Page 6 of 9

2022 Camry, Camry HV Pre-Delivery Service (PDS)
Front Wheel Opening Extension Pad Installation

The front wheel opening extension pad set (right and left front wheel opening extension pads)
is loaded in the luggage compartment at the assembly plant to avoid damage in transit.
1. Remove the three self-tapping screws from
the engine under cover (the self-tapping
screws will be reused for installation).

Figure 2.

HINT
The removed self-tapping screws are reused
when installing the front wheel opening
extension pad.

2. Place the left front wheel opening
extension pad on the installation position
as shown and tighten the three
self-tapping screws.

1

HINT
There is a distinguishable mark on each pad.
2

3. Repeat steps 1 and 2 for the
right-hand side.

3

1

Remove Self-tapping Screw

2

Front Wheel Opening Extension Pad

3

Install Self-tapping Screw

© 2021 Toyota Motor Sales, USA

T-SB-0058-21

Rev1

July 26, 2021

Page 7 of 9

2022 Camry, Camry HV Pre-Delivery Service (PDS)
Front License Plate and Mounting Bracket Installation

The front license plate mounting bracket set (front license plate mounting bracket, four long
self-tapping screws, and two short self-tapping screws) is loaded in the luggage compartment at
the assembly plant. Follow this procedure to install the front license plate bracket and front
license plate in states where it is required by law.
1. Align the holes on the front license plate
mounting bracket with the dimples on the
front of the lower grille.

Figure 3.

1

2. Install the two long self-tapping screws
through the holes on the front license plate
mounting bracket into the lower grille.
Long Self-tapping Screw: 37 mm (1.456 in.)
NOTICE

2

 Do NOT pre-drill holes into the bumper.
 Do NOT overtighten the
self-tapping screws.

3

3. Insert the license plate into the tabs on
the bracket.
4. Align the holes on the license plate with the
corresponding holes of the front license
plate mounting bracket.
4
5

5. Install the two short self-tapping screws
through the holes on the front license plate
mounting bracket and license plate.
Short Self-tapping Screw: 16 mm (0.630 in.)
NOTICE
 Do NOT pre-drill holes through the
front license plate mounting bracket.
 Do NOT overtighten the
self-tapping screws.

1

Dimple

2

Front License Plate Mounting Bracket

3

Long Self-tapping Screw

4

Short Self-tapping Screw

5

Front License Plate

© 2021 Toyota Motor Sales, USA

T-SB-0058-21

Rev1

July 26, 2021

Page 8 of 9

2022 Camry, Camry HV Pre-Delivery Service (PDS)
Installation of Rubber Body Plugs

1. Confirm the number of plugs in the glove box. If two plugs are present, perform
substep 2A ONLY. If four plugs are present, perform substep 2A AND substep 2B.
2. Install plugs according to the instructions below by confirming the number of plugs in the
glove box.
A. Install two plugs in the rear side member hole or rocker inner hole as shown.
B. Install two plugs in the torque box hole or rocker inner hole as shown.
Figure 4.

1

2

z
6

3

z

5

6

1

Front Side

2

Rear Side

3

Torque Box Hole or Rocker Inner Hole

4

Rear Side Member Hole or Rocker Inner Hole

5

Rocker Inner

6

Install Plug Here (if Applicable)

z

z

z

4

z

z

NOTICE
 The installation of these plugs is required to prevent rust.
 These plugs are stored in the glove box.
 The number of plugs may vary according to production locations in the same
vehicle model.

© 2021 Toyota Motor Sales, USA

T-SB-0058-21

Rev1

July 26, 2021

Page 9 of 9

2022 Camry, Camry HV Pre-Delivery Service (PDS)
Dealer Contact Information for Call Dealer Head Unit Function
Refer to the Multimedia System Owner’s Manual to add dealer contact information
(Camry / Camry HV).
NOTE
This step is not applicable to the following Camry models without optional audio:






L
LE
SE
TRD
Nightshade

Entune™ 3.0 App Suite Connect Initialization/Update
Refer to T-SB-0037-21 Entune™ 3.0 App Suite Connect to initialize/update the Entune™ 3.0 App
Suite Connect.

© 2021 Toyota Motor Sales, USA