L-SB-0012-1 4

Rev1

February 13, 2014

Floor Mat Installation During PDS
Service
Category

General

Section

Pre-Delivery Service

Market

USA

Lexus Supports ~
ASE Certification

V

Applicab ility
YEAR(S)

MODEL(S)

2015

CT200H, ES300H,
ES350, GS350,
GS450H, GX460,
IS250, IS250C, IS350,
IS350C, LS460,
LS600H, LX570,
NX2 00T, NX300H,
RC F, RC 350, RX350,
RX450H

A DDITIO NAL INFORMATION

REVISION NOTICE

November 6, 2014 Rev1 :
• Applicability has been updated to includ e 2015 model year NX 200T, NX 300h, RC F, and RC 350
vehicles.
Any previous printed version s of this bull etin should be discarded.

Introduction
2015 model year vehicles are equipped w ith driver's side floor mat retaining clips to secure the fl oor
mat in the correct position. In addition, some models may utilize reta ining clips for passenger side
and rea r seat floor mats as well. Follow the appropri ate installation procedure to attach the driver's
side, and if applicable, passenger's side and rear seat fl oor mats to the vehicle carpet using the fl oor
mat retaining cli ps during Pre-Delivery Service (PDS) .

© 2014 Lexus, a division of Toyota Motor Sales, USA

Page 1 of 6

L-SB-0012-14

Rev1

February 13, 2014

Page 2 of 6

Floor Mat Installation During PDS

Introduct ion (Continued)
CAUTION
• ALWAYS verify the floor mat to ensure it is designed specifically for the model and model
year i t is being installed in.
•

ONLY use floor mats that can be retain ed using the retaining clips . All OEM Lexus floor mats
are specifically designed to fit correctly and be retained using the retaining clips.

•

Make sure the floor mat is properly placed on the vehicle carpet and secured with the retaining
clips . If the driver side floor mat is NOT properly placed and secured , it could slip and interfere
with the movement of the pedals during driving and may cause an accident.

• Verify the operation of the accelerator, brake, and clutch (if equipped) pedals and clearance
to the mat.
•

NEVER install more than one floor mat at a time in the driver's seating position.

• If applicable, any secondary set of floor mats (based upon c ustomer preference, such as the
all-weather floor mats or other floor mats) MUST be placed in the trunk with all the packaging
material intact. Do NOT install the secondary mat on top of the primary floor mat already
installed in the driver's seating position .

Warranty Information
OP CODE

DESC RIPTION

TIME

OFP

T1

T2

N/A

Not applicable to Warranty

N/A

N/A

-

-

© 201 4 Lexus, a division of Toyota Motor Sales, USA

L-SB-0012-14

Rev1

February 13, 2014

Pag e 3 of 6

Floor Mat Installation During PDS

Installati on Procedure (Hook Style)

1. Verify that the driver, and if applicable, passenger side and rear seat floor mats are for the
co rrect model and model yea r they are being installed in.
2. Attach t he driver and if applicable, passenger side and rear seat floor mats to the vehicle
carpet using the retaining clips. Secure the mat by inserting the retaining clips throu gh the
grommet holes.
Figu re 1.

®

~
---~

.- : :. ..~- ;

~-~-.
-' - .
--\... . . -.. .' ~~~~
. ·- . .
...
.

:

~: .
- _.... '::..,

":

~ ;;

.

'

•

'

'

•

•

'

::;v

·.· . :"'-. ,- : .. _..
..... , ... . . . '-

•

-

....:· .. ·.·.: .

1
2

I

Reto;o;og CUp•

3

I

Correct Installatio n

Gro mmet s

© 2014 Lexus, a division of Toyota Motor Sales. USA

'

L-SB-0012-14

Rev1

February 13, 2014

Page 4 of 6

Floor Mat Installation During PDS

Installation Procedure (Hook Style) (Continued)

3. Verify proper installation.
NOTE
If applicable, DO NOT remove the beige " Caution " tag from the floor mat. This should only be
removed by the customer.
Figure 2.

A

Caution I Precauci6n I Attention I ..HW

A

NOTICE: THIS TAG TO BE REMOVED BY CUSTOMER ONLY.
To avold inlerfef'Uflco with pedal operation:
- E9Ch mat must be secured with retention hooks (clips)
- Do not Install e ftoor mot on lop or an exlstlng noor mal

0

AVISO: SOLAMENTE EL CLIENTE OEBE REMOVER ESTA ETlQUETA.
Para evltar loterfereflcla con la operaclOn del pedal:
- Cad& tapete debe sujel8rse con seguros de retenc;lon (brodies)
- No Jnstalo un tapete de plso enclma de un tapelo de plso e>tlsterlle

REMARQUE : CETTE £TIQUETTE NE PEUT £TRE ENLEvEE QUE PAR LE CLIENT.
Poix eviler des inlerf8'ences avec le rooclionnemenl de la p9dale:
- Cheque tapis dolt 61re nx& 6 !'aide des crochets de rlilention (egrafes)
• N'illS1allaz. pas un tlpi$ paM!essus un tapis d9jfl en piece

~ ~I ~ LJ.A .U~I o~ e_j:i ~ :...>\.&...!.}
.~1 ~ •_N..11 J...) •'•::.... ~ - :U.C...»1 ~.) ~.)'"- ~
.~ ~.>- J..) I)} i).J...JI J..) ~y 'J -

© 2014 Lexus, a division of Toyota Motor Sales, USA

El

L-SB-0012-14

Rev1

February 13, 2014

Page 5 of 6

Floor Mat Installation During PDS

Installation Proced ure (Knob Style)

1. Verify that the driver, and if applicable, passenger side and rea r seat floor mats are for the
correct model and model year they are being installed in.
2. Align the floo r mat holes with the retention clip
knobs and place the floor mat holes onto the
retention clip knobs.

Figure 3.

1

Retention Cli p Eyelet on Floor Mat

2

Retention Clip

3

Front of Veh icle

3. Turn the retention clip knobs a quarter of a turn to Figure 4.
lock in place and verify the "triangle" marks on the .-- - - - - - - - - - - - - -----.
retention clip knob and floor mat are aligned .

1

Twist Knob

2

Knob in Locked Position

3

Align " Triangle" Marks

© 2014 Lexus, a division of Toyota Motor Sales, USA

L-SB-0012-14

Rev1

February 13, 2014

Page 6 of 6

Floor Mat Installation During PDS

Installation Procedure (Knob Style) (Continued )

4 . Verify proper installation.

Figure 5.

A

NOTE
If applicable , DO NOT remove the yellow
" Caution" tag from the floor mat. This should
only be removed by the customer.

CAUTION

A

• Use !his floor mat 10< dn-·a
side only

• This floor mat was deSlgnod
specificady lot use in this model
and model year vehicle and
SHOULD NOT be usod In any
Oilier vehlde
• To pe !loot
wl1!1 !he retention dips
To properly use the retoot>on
dips. tum the knobS on the dips
to the lock poslbon OS Sho"'" In
the following 1UuSlratlon.
• The floor mal MUST BE
&\stalled d~Ocily on tho co