NISSAN
BULLETIN
2015 Rogue (T32) Door Latch
Dealer Inventory Inspection

Attention: Dealer Principal, Sales, Service & Parts Managers

Reference: PC382
Date: July 1, 2015

***** Detailed Information *****
A STOP SALE CONDITION IS IN EFFECT.
On June 19th, 2015, Nissan announced a quality hold for certain 2015 Rogue vehicles for a
possible left side rear door latch issue. At this time, Nissan is providing inspection
instructions to determine if these vehicles can be released for sale. Dealers are requested to
inspect the Julian date and cavity code on the left side rear door latch on the subject
vehicles identified in SERVICE COMM.
If the date and cavity code are within the affected range, the VEHICLE MUST BE PLACED
ON HOLD AND CANNOT BE RETAILED.
***** What Dealers Should Do *****
PLEASE FOLLOW THE ATTACHED INSPECTION INSTRUCTIONS:
1. Verify if newly arriving vehicles or vehicles currently in dealer inventory are affected
by this dealer inventory inspection using Service Comm I.D. PC382
2. If inspection shows that the Julian date and cavity code on the left rear door latch
are not within the affected range, submit the warranty claim and release the vehicle
without further action.
3. If inspection shows that the Julian date and cavity code on the left rear door latch
are within the affected range:


Order the part via the order form.
NOTE: Once ordered, please allow up to 3 weeks for parts to arrive.



Hold the vehicle until the part shipment arrives.



Once the part arrives, repair the vehicle using the attached procedure, submit
the warranty claim, and release the vehicle.

***** Vehicle Identification – Dealer Inventory *****
A total of 38 2015 Rogue (T32) vehicles are subject to this dealer inventory inspection and
can be identified through two methods:


SERVICE COMM – Dealer service departments can complete an inquiry on
SERVICE COMM – I.D. PC382 - to determine if a vehicle is subject to this
Dealer Inventory Inspection.



VIN List – As a courtesy, posted with this announcement is a list of affected
dealer inventory VINs by region, district, and dealer code.

***** Dealer Responsibility *****
It is the dealer’s responsibility to check SERVICE COMM – I.D. PC382 – for the status
on each affected vehicle currently in inventory. Nissan requests dealers to perform this
inspection on vehicles in inventory prior to being retailed to ensure customer
satisfaction.
***** Inspection Procedure *****
This inspection procedure will be available on ASIST and www.NNAnet.com.


ASIST – Go to “Tech Support Info” on the left column of the ASIST opening page.
Under “Tech Support Info”, select “Inventory Vehicle Actions”. A new window will
open where you may access the technical procedures.



NNAnet.com –This procedure can be found on NNAnet.com under My Documents
in the following categories:
o Parts>Campaigns>
o Sales>Campaigns>
o Service>Campaigns>
 PC382

Thank you for your prompt attention to this matter.
NISSAN NORTH AMERICA, INC.
Aftersales DIVISION

Door Latch Inspection Procedure
2015 Sentra/Versa Note and Rogue

REPAIR OVERVIEW
Is the door lock Julian Date 154-160?
Unreadable

No Repair
Needed

No

No Repair
Needed

Yes

No Repair
Needed

Yes

Is the door lock Cavity Code “B”
Unreadable

No

Yes

Is the door lock Lot Number “E88”

Unreadable

No

Replace the affected Door
Lock Assembly

SERVICE PROCEDURE:
1. Locate door latch Julian Date on
applicable vehicle door/s listed
below.




Sentra/Versa Note:
Left Front and Left Rear
Doors
Rogue:
Left Rear Door ONLY

2. Inspect first three digits of the
above model specified door latch/s
Julian Date. Refer to Figure 2.


If the first three Julian date
digits ARE within (including)
154-160 or Unreadable,
continue to Step 3.



If the first three Julian date
digits are NOT within
(including) 154-160, then
submit claim and release the
vehicle.

Figure 1
Julian Date
Example (120)

Figure 2

3. Remove the Door Finisher of the
door/s with a suspect latch
identified in Step 2.


Verify door window is in the
full up position.



Refer to the applicable
Electronic Service Manual
(ESM). Section INT-Interior,
for removal procedures.

Figure 3

4. Working from the rear of the door,
partially peel back the vapor
barrier from door panel.

5. Front Doors ONLY:
Disconnect the key rod at the door
lock assembly.


Open yellow key rod holder
(1) by pulling downward and
separate key rod (3) from
door lock assembly (2). See
Figure 5.



Use care to not damage
yellow key rod holder as it
must be reused.

6. Vehicles Equipped With Power Door
Locks:
Disconnect door lock harness
retainer from the door.


Figure 4
Front Door ONLY

Figure 5

Pinch clips on both sides of
the harness retainer while
pushing the retainer into the
door (Figure 6).

Figure 6

7. Remove the rear window run from
the door.
All Except Sentra Left Rear
Door. See Figure 7.


Remove the (2) 10mm run
channel retaining bolts.



Slide rear window run
channel down and remove it
from the door.

Sentra Left Rear Door ONLY.
Refer to Figure 8.


Remove the (1) 10 mm run
channel retaining bolt.



Push the bottom of rear
window run back providing
clearance to remove the
door lock assembly.



Do NOT attempt to remove
the run channel as it is
attached to the door at the
top and could cause run
channel damage.

Figure 7
Sentra Left Rear Door

Figure 8

8. Remove door lock assembly
retaining bolts.


Remove the (3) T-27 Torx
head bolts and discard (Do
NOT reuse). See Figure 9.



During door lock assembly
installation, tighten door lock
screws to 5.8 Nm (51 in-lb).

Figure 9

9. Vehicles Equipped With Power Door
Locks:
Disconnect the door lock harness
connector.

Figure 10

10. Pull the door lock assembly out of
the door.


Do not kink the door lock
cables or disconnect them
from the door handles.

Figure 11

11. Inspect door lock assembly for Cavity Code stamped on plate edge.
See Figures 12 & 13.
Location of Lot Number and Cavity Code

Figure 12

Lot Number
Example “C99”

Cavity Code
Example “B”

Figure 13



If the Cavity Code stamped on the plate edge is “NOT a “B”, then
reassemble the vehicle, submit claim and release vehicle.



If the Cavity Code stamped on the plate edge IS a “B”, then proceed to Step
12.


If the Cavity Code Cannot be Determined, then, proceed to Step 12.

12. Inspect door lock assembly for Lot Number stamped on plate edge. See Figures 12
& 13.


If the Lot Number stamped on the plate edge IS an “E88”, then reassemble
the vehicle, submit claim and release the vehicle.



If the Lot Number stamped on the plate edge is NOT an “E88”, then replace
the affected door lock assembly. Refer to the applicable Electronic Service
Manual (ESM). Section DLK-Door & Lock, for replacement procedures.



If the Lot Number stamped on the plate edge Cannot be Determined,
then replace the affected door lock assembly. Refer to the applicable
Electronic Service Manual (ESM). Section DLK-Door & Lock, for replacement
procedures.

PARTS INFORMATION:
Description

Part #

Door Lock Assembly

Order Through Normal Nissan Parts Order
System

Screw (3 per lock required)

80599-AX00E

CLAIMS INFORMATION:
NOTE: All inspection and door lock replacements pertain to the Driver (Left) side
ONLY.

CAMPAIGN
("CM") I.D. DESCRIPTION

OP CODE FRT

VEHICLE
APPLICATION

PC382
PC382
PC382

Inspect Julian Date ONLY
Inspect Julian Date, R&R Rear Door Finisher
Inspect Julian Date, Replace Rear Door Lock

PC3820
PC3821
PC3822

0.2H
0.3H
0.3H

Rogue
Rogue
Rogue

PC383
PC383
PC383
PC383
PC383
PC383
PC383
PC383
PC383
PC383
PC383

Inspect Julian Date ONLY
Inspect Julian Date, R&R (1) Door Finisher
Inspect Julian Date, R&R (2) Door Finishers
Replace Front Door Lock, Inspect Rear Julian ONLY
Replace Front Door Lock, Inspect Rear Julian ONLY
Replace Rear Door Lock, Inspect Front Julian ONLY
Replace Front Door Lock, R&R Rear Door Finisher
Replace Front Door Lock, R&R Rear Door Finisher
Replace Rear Door Lock, R&R Front Door Finisher
Replace Both Front & Rear Door Locks
Replace Both Front & Rear Door Locks

PC3830
PC3831
PC3832
PC3833
PC3834
PC3835
PC3836
PC3837
PC3838
PC3839
PC383A

0.2H
0.3H
0.5H
0.3H
0.5H
0.4H
0.5H
0.7H
0.6H
0.6H
0.8H

Sentra
Sentra
Sentra
Sentra
Versa
Sentra
Sentra
Versa
Sentra
Sentra
Versa

& Versa
& Versa
& Versa

& Versa

& Versa