Classification:

Reference:

Date:

WT14-003

ITB14-012

March 14, 2014

2014 Q50; TPMS CONFIGURATION

APPLIED VEHICLES:

2014 Q50 (V37)
2014 Q50 Hybrid (V37)

SERVICE INFORMATION
When a BCM is replaced for any reason, TPMS (Tire Pressure Monitor System) configuration must be
performed.
TPMS configuration is in addition to any other BCM configurations that may be performed.
If TPMS configuration is not performed, TPMS transmitter ID registration will not complete.
Follow the Service Procedure in this bulletin to perform TPMS configuration.

Infiniti Bulletins are intended for use by qualified technicians, not 'do-it-yourselfers'. Qualified technicians are properly trained
individuals who have the equipment, tools, safety instruction, and know-how to do a job properly and safely. NOTE: If you believe that
a described condition may apply to a particular vehicle, DO NOT assume that it does. See your Infiniti dealer to determine if this
applies to your vehicle.

1/9

SERVICE PROCEDURE
1. Connect the CONSULT-III plus (C-III plus) Vehicle Interface (plus VI) to the vehicle.

2. Turn the ignition ON.

3. Open / start C-III plus.
4. Wait for the plus VI to be recognized.


The serial number will display when the plus VI is recognized.

5. Select Diagnosis (One System).

Step
5
plus VI is
recognized

Figure 1

2/9

ITB14-012

6. Select BCM.

Step
6

Figure 2
7. Select BCM again.

Step
7

Figure 3

3/9

ITB14-012

8. Select ECU Identification.

Step
8

Figure 4
9. Write down the BCM part number:
NOTE: This number will be used later for TPMS configuration.
10. Select Home.

Step
10

Step 9
Write down this number.
This is the BCM Part Number.

Figure 5

4/9

ITB14-012

11. Select Re/programming, Configuration.

Step
11

Figure 6
12. Use arrows (if needed) to view and read all precautions.
13. Check the box confirming the precautions have been read.
14. Select Next.

Step
12

Step
13

Step
14

Figure 7

5/9

ITB14-012

15. Select Infiniti, Vehicle Name, correct Model Year, and then Select.


If the screen in Figure 8 does not display, skip to step 16.

Step
15

Example

Figure 8
16. Make sure VIN or Chassis # matches the vehicle’s VIN.
17. Select Confirm.

Step
16

Step
17

Figure 9
6/9

ITB14-012

18. Select Confirm.

Step
18

Figure 10
19. Select Air Pressure Monitor.

Step
19

Figure 11

7/9

ITB14-012

20. Select Manual Configuration.

Step
20

Figure 12
21. Select the DATA PART NO. that matches the BCM part number you wrote down in step 9.
 Use the scroll arrows to scroll and find the correct DATA PART NO. / BCM part number.
22. Select Next.

Step
21

Example

Step
22
Scroll
arrows

Figure 13

8/9

ITB14-012

23. Confrim the correct DATA PART NO is listed.
 This should be the BCM part number you wrote down in step 9.

24. Select OK.

Step
23
Step
24

Figure 14

25. TPMS configuration is complete.

26. Select Home, close C-III plus and disconnect from the vehicle.

9/9

ITB14-012