Classification:

Reference:

Date:

EL20-030

ITB20-023

September 16, 2020

LANE CAMERA AIMING
VEHICLE REFERENCE VALUES NOT IN ESM
APPLIED VEHICLES:

2016-2020 Q50 (V37)
2017-2020 Q60 (CV37)
2014-2019 Q70 (Y51)
2019-2020 QX50 (J55)
2017-2020 QX60 (L50)
2014-2017 QX70 (S51)
2017-2020 QX80 (Z62)

SERVICE INFORMATION
If the lane camera requires aiming, the values in Table A on page 4 must be used.


For all other models, consult the Electronic Service Manual (ESM).

Infiniti Bulletins are intended for use by qualified technicians, not 'do-it-yourselfers'. Qualified technicians are properly trained
individuals who have the equipment, tools, safety instruction, and know-how to do a job properly and safely. NOTE: If you believe that
a described condition may apply to a particular vehicle, DO NOT assume that it does. See your Infiniti retailer to determine if this
applies to your vehicle.

1/4

SERVICE INFORMATION (continued)

The following CONSULT-III plus (C-III plus) figures and steps are only provided to indicate where the VEHICLE
REFERENCE VALUE from Table A is to be entered. The entire camera aiming procedure must be followed to
complete the aiming procedure.


Refer to the Electronic ESM section: CRUISE CONTROL & DRIVER ASSISTANCE > DRIVER
ASSISTANCE SYSTEM > DRIVER ASSISTANCE SYSTEM > BASIC INSPECTION > LANE
CAMERA UNIT > CAMERA AIMING ADJUSTMENT.

1.

Turn the ignition ON.

2.

From the C-III plus home screen, select Diagnosis (One System).

VI is
recognized

Figure 1

2/4

ITB20-023

3.

Select LANE CAMERA.

Figure 2
4.

Select Work support, and then AUTO AIM.

5.

Enter the values for Hfl and Hfr into the first two rows of C-III plus where shown in Figure 3.


For the process to measure the model specific values, refer to the ESM section: CRUISE
CONTROL & DRIVER ASSISTANCE > DRIVER ASSISTANCE SYSTEM > DRIVER ASSISTANCE
SYSTEM > BASIC INSPECTION > LANE CAMERA UNIT > CAMERA AIMING ADJUSTMENT.

Values from
ESM

Figure 3

3/4

ITB20-023

6.

Enter the model specific VEHICLE REFERENCE VALUE from Table A (below) into the third row where
shown in Figure 4.

Value from
Table A

Figure 4
Table A
Model

Vehicle reference value

2016-2020 Q50

756 mm

2017 Q60

711 mm

2018-2020 Q60

705 mm

2014-2019 Q70

711 mm

2019-2020 QX50

791 mm

2017-2020 QX60

826 mm

2014-2017 QX70

831 mm

2017-2020 QX80

910 mm

AMENDMENT HISTORY
PUBLISHED DATE

REFERENCE

September 16, 2020

ITB20-023

DESCRIPTION
Original bulletin published

4/4

ITB20-023