ATTENTION:
GENERAL MANAGER

q

PARTS MANAGER

q

CLAIMS PERSONNEL

q

IMPORTANT - All
Service Personnel
Should Read and
Initial in the boxes
provided, right.

SERVICE MANAGER

q

© 2020 Subaru of America, Inc. All rights reserved.

SERVICE INFORMATION BULLETIN
APPLICABILITY:

2004-20MY WRX and WRX STI
2013-20MY BRZ

NUMBER: 06-76-20
DATE: 05/26/20

SUBJECT: Brembo Brake Calipers- Special Servicing
Precautions
INTRODUCTION:
This Service Information Bulletin provides precautions to follow
when servicing the Brembo brake calipers utilized on the models
listed above. Because of their aluminum construction, it is
CRITICAL to take extra care when servicing.
PART INFORMATION:
IMPORTANT REMINDER: When needed, always order the most up-to-date replacement hardware
based on the specific VIN being repaired. This is especially important for the caliper bolts referenced
below as different bolts are used for different model years.
SERVICE PROCEDURE / INFORMATION:
REMINDER: Customer satisfaction and retention starts with performing quality repairs.
The service procedures for brake caliper removal and installation remain unchanged. Additional
precautions to follow are supplied below. Always refer to the applicable Service Manual and
review the full requirements of the repair being performed. The Service Manual procedures contain
information critical to performing an effective repair the first time and every time. This includes but
is not limited to: important SAFETY precautions, proper inspection criteria, necessary special tools,
required processes and related one-time-use parts needed for a complete and lasting repair.
•

When caliper assembly removal is necessary, it is CRITICAL to inspect the threads of the
retaining bolts closely before reinstallation. If inspection reveals the surface coating of
the bolt threads is peeling or otherwise damaged, the affected bolt(s) MUST be replaced to
prevent damaging the threads in the aluminum caliper body as shown in the example photos
below.

CAUTION: VEHICLE SERVICING PERFORMED BY UNTRAINED PERSONS COULD
RESULT IN SERIOUS INJURY TO THOSE PERSONS OR TO OTHERS.
Subaru Service Bulletins are intended for use by professional technicians ONLY. They
are written to inform those technicians of conditions that may occur in some vehicles,
or to provide information that could assist in the proper servicing of the vehicle. Properly
trained technicians have the equipment, tools, safety instructions, and know-how to
do the job correctly and safely. If a condition is described, DO NOT assume that this
Service Bulletin applies to your vehicle, or that your vehicle will have that condition.

Subaru of America, Inc. is
ISO 14001 Compliant
ISO 14001 is the international standard for
excellence in Environmental Management
Systems. Please recycle or dispose of
automotive products in a manner that is friendly
to our environment and in accordance with all
local, state and federal laws and regulations.

Continued...
Bulletin Number: 06-76-20; Date: 05/26/20

Page 1 of 2

NOTE: If the mounting bolt threads in the caliper are damaged, the caliper assembly must be
replaced.

•

When re-mounting the calipers, tighten both retaining bolts CAREFULLY BY HAND and
EVENLY until the underside of the bolt heads bottom against the bracket. Once both bolts
are fully installed against the mounting bracket, proceed with final torqueing to the specified
values as listed in the applicable Service Manual.

NOTE: Additional Brembo-specific disc brake servicing procedures and precautions relating to
brake hose replacement are supplied in TSB 06-64-18.

IMPORTANT REMINDERS:
•

SOA strongly discourages the printing and/or local storage of service information as
previously released information and electronic publications may be updated at any time.

•

Always check for any open recalls or campaigns anytime a vehicle is in for servicing.

•

Always refer to STIS for the latest service information before performing any repairs.

Bulletin Number: 06-76-20; Date: 05/26/20

Page 2 of 2