Technical
Service Bulletin

Mazda North American Operations
Irvine, CA 92618-2922

Subject:
SPEEDOMETER REPLACEMENT PROCEDURE

Bulletin No.: 09-009/19

Last Issued: 01/14/2019

BULLETIN NOTES
This bulletin supersedes the previously issued bulletin(s) listed below. The changes are noted below in Red.

Previous TSBs:

Date(s) Issued:

Previous TSBs: Date(s) Issued:

09-034/18

08/31/2018 and 10/10/2018

09-034/14

08/15/2014

09-035/17

08/07/2017

09-026/04

07/01/2004

09-007/16

02/17/2016

---

---

APPLICABLE MODEL(S)/VINS

1990-1994 323
1992-1995 929
2006-2015 Mazda5
1992-1995 MX-3
1995-2002 Millenia 2003-2019 Mazda6
1990-2003 Protege 1991-1994 Navajo 2013-2019 CX-5
2002-2003 Protege5 1990-2006 MPV 2007-2012 CX-7
1990-2005 Miata 1995-2009 B-Series 2007-2019 CX-9
1993-1995 RX-7
2001-2011 Tribute 2006-2019 MX-5
1990-1995 MX-6
2011-2014 Mazda2 2004-2011 RX-8
1990-2002 626
2004-2019Mazda3 2016-2019 CX-3

DESCRIPTION
In accordance with Federal regulations, follow the procedure listed below when replacing a speedometer.
NOTE:






Tampering with a motor vehicle odometer is strictly prohibited by Federal, and State laws. It is the
dealer’s responsibility to comply with Federal, State, and local laws concerning odometer and
related documentation requirements when providing a repair or replacement.
Mazda vehicles are manufactured with tamper-proof speedometers.
When a speedometer is replaced, the new speedometer will read zero (0) miles.
This procedure is extremely important to accurately represent actual vehicle mileage.

Page 1 of 4
CONSUMER NOTICE: The information and instructions in this bulletin are intended for use by skilled technicians. Mazda technicians utilize the proper tools/
equipment and take training to correctly and safely maintain Mazda vehicles. These instructions should not be performed by “do-it-yourselfers.” Customers
should not assume this bulletin applies to their vehicle or that their vehicle will develop the described concern. To determine if the information applies,
customers should contact their nearest authorized Mazda dealership. Mazda North American Operations reserves the right to alter the specifications and
contents of this bulletin without obligation or advance notice. All rights reserved. No part of this bulletin may be reproduced in any form or by any means,
electronic or mechanical---including photocopying and recording and the use of any kind of information storage and retrieval system ---without permission in
writing.

© 2019 Mazda North American Operations, U.S.A.

Bulletin No.: 09-009/19




Last Issued: 01/14/2019

Prior to speedometer removal, complete the information required on the “Speedometer
Replacement Label”. Labels can only be ordered through Mazda eStore.
In an effort to achieve a higher level of Customer Experience and retain the value of Mazda’s
vehicles, MNAO Warranty Operations is allowing all Mazda dealers to utilize a third party, SPECMO
Enterprises, Inc., for Instrument Panel Cluster (IPC) odometer setting service. With the use of
SPECMO’s services, it is possible that the odometer will be set between 10 to 31 miles over the
odometer mileage at the time of replacement for both warranty and customer pay repairs. Please
make sure that the customer is aware that there may be a slight variance to the odometer, in which
case the customer may have to accept the slightly higher mileage. Since odometer setting service
is not part of the warranty repair, it is not warrantable nor required, but optional. However, Mazda
Warranty policy provides after- warranty assistance (AWA) or DSA that can be utilized to cover this
service expense.

REPAIR PROCEDURE
NOTE: Customers have two (2) repair options according to the table below. Discuss each option with the
customer and decide which one is best for their situation.

New Mileage
Setting

Speedometer
Sticker
Required

Cost

Option

Description

New
IPC

1

Speedometer
Replacement:

Yes

Zero (0)

Yes

Customer pay (unless vehicle is
still under warranty).

2

SPECMO Odometer
Setting:

Yes

Possibly 10~31
miles over
the existing
mileage

No

Customer pay or AWA / DSA /
DSM authorization.

Page 2 of 4
CONSUMER NOTICE: The information and instructions in this bulletin are intended for use by skilled technicians. Mazda technicians utilize the proper tools/
equipment and take training to correctly and safely maintain Mazda vehicles. These instructions should not be performed by “do-it-yourselfers.” Customers
should not assume this bulletin applies to their vehicle or that their vehicle will develop the described concern. To determine if the information applies,
customers should contact their nearest authorized Mazda dealership. Mazda North American Operations reserves the right to alter the specifications and
contents of this bulletin without obligation or advance notice. All rights reserved. No part of this bulletin may be reproduced in any form or by any means,
electronic or mechanical---including photocopying and recording and the use of any kind of information storage and retrieval system ---without permission in
writing.

© 2019 Mazda North American Operations, U.S.A.

Bulletin No.: 09-009/19

Last Issued: 01/14/2019

SPEEDOMETER REPLACEMENT:
1. Order “Speedometer Replacement Labels” through Mazda eStore.
2. Record vehicle mileage before removing the speedometer.
3. Remove and replace the speedometer according to the instructions on MGSS online.
4. Complete the following information on the “Speedometer Replacement Label.”
a. Mileage (before speedometer replacement).
b. Date of replacement.
c. Dealer code.

5. Attach the completed label to the driver's side “B” pillar.
SPECMO - ODOMETER SETTING:
IMPORTANT NOTE: Be sure that customers fully understand that the mileage on their new odometer may
not be exactly the same as the mileage their original odometer had before the repair. Due to technical
limitations, SPECMO may only be able to set the mileage to 10~31 miles over the existing odometer
mileage. If SPECMO is unable to set the exact same mileage, the customer can request to have their
odometer set to zero and use the Speedometer Replacement Label.
NOTE: From the time the dealer receives the new Instrument Panel Cluster IPC from the PDC, overnights it
to SPECMO for odometer setting, the complete process could take 2-3 days. Therefore, dealers are
encouraged to provide a loaner vehicle to the customer.
SPECMO requires the following forms in all shipments for odometer setting:
• SPECMO Unit Ship-In Form (completely filled-out, click HERE for attachment)
• RO/PO
The dealer can overnight the package to SPECO and request the Fed-EX overnight return shipping to
reduce vehicle down time. SPECMO will complete the odometer setting within 24-48 hours upon receipt of
IPC.

Page 3 of 4
CONSUMER NOTICE: The information and instructions in this bulletin are intended for use by skilled technicians. Mazda technicians utilize the proper tools/
equipment and take training to correctly and safely maintain Mazda vehicles. These instructions should not be performed by “do-it-yourselfers.” Customers
should not assume this bulletin applies to their vehicle or that their vehicle will develop the described concern. To determine if the information applies,
customers should contact their nearest authorized Mazda dealership. Mazda North American Operations reserves the right to alter the specifications and
contents of this bulletin without obligation or advance notice. All rights reserved. No part of this bulletin may be reproduced in any form or by any means,
electronic or mechanical---including photocopying and recording and the use of any kind of information storage and retrieval system ---without permission in
writing.

© 2019 Mazda North American Operations, U.S.A.

Bulletin No.: 09-009/19

Last Issued: 01/14/2019

PARTS INFORMATION
Part Number
Description
Qty.
Notes
9999-95-SPDO-97 Speedometer Replacement Labels 1 = 20 labels Order labels through Mazda eStore

WARRANTY INFORMATION
When replacing an Instrument Cluster within the warranty period and utilizing the odometer setting service,
two (2) warranty claims must be submitted. The first warranty claim is for the IPC replacement and
associated labor, the second is for the non-warrantable odometer setting service. The claim for the
odometer setting service must be submitted as a separate non-warrantable sublet with DSA or DSM
authorization.
NOTE: Odometer setting service must be claimed as non-warrantable AWA or DSA.

Symptom Code

99

Damage Code

99
****-55-***

Part Number Main Cause*

(refer to GEPC for applicable part number)

Quantity

0

Operation Number / Labor Hours:
Sublet Number:
Sublet Code:
Sublet Amount:
Authorization

T0603XRX / 0.0 Hr.
Invoice Number
M2 - Non-Warrantable Expense
Enter invoice charge
DSA or DSM Authorization

* PNMC will vary based on vehicle, year, and model.

Page 4 of 4
CONSUMER NOTICE: The information and instructions in this bulletin are intended for use by skilled technicians. Mazda technicians utilize the proper tools/
equipment and take training to correctly and safely maintain Mazda vehicles. These instructions should not be performed by “do-it-yourselfers.” Customers
should not assume this bulletin applies to their vehicle or that their vehicle will develop the described concern. To determine if the information applies,
customers should contact their nearest authorized Mazda dealership. Mazda North American Operations reserves the right to alter the specifications and
contents of this bulletin without obligation or advance notice. All rights reserved. No part of this bulletin may be reproduced in any form or by any means,
electronic or mechanical---including photocopying and recording and the use of any kind of information storage and retrieval system ---without permission in
writing.

© 2019 Mazda North American Operations, U.S.A.