L-SB-0044-18

December 3, 2018

Long-Term Vehicle Storage Guidelines
Service
Category

General

Section

Pre-Delivery Service

Market USA

Applicability
YEAR(S)

MODEL(S)

2018 - 2019

ES300H, ES350, GS F,
GS300, GS350, GX460,
IS300, IS350, LC500,
LC500H, LS500, LS500H,
LX570, NX300, NX300H, RC
F, RC300, RC350, RX350,
RX450H

2018

GS450H

2019

UX200, UX250H

ADDITIONAL INFORMATION

SUPERSESSION NOTICE
The information contained in this bulletin supersedes Service Bulletin No. L-SB-0112-17.
 Applicability has been updated to include 2019 model year UX200 and UX250h vehicles.
Service Bulletin No. L-SB-0112-17 is obsolete and any printed versions should be discarded.

Introduction

Long-term or off-site storage requires special care to keep vehicles factory fresh and ready for
delivery. The following guidelines should be performed to minimize vehicle component/part
degradation due to extended vehicle storage conditions. Long-term storage can affect vehicle
systems and components. Any problems that are found should be corrected immediately.

Warranty Information
OP CODE

DESCRIPTION

TIME

OFP

T1

T2

N/A

Not Applicable to Warranty

–

–

–

–

© 2018 Lexus, a division of Toyota Motor Sales, USA

Page 1 of 5

L-SB-0044-18

December 3, 2018

Page 2 of 5

Long-Term Vehicle Storage Guidelines
Required Tools & Equipment
SPECIAL SERVICE TOOLS (SST)

PART NUMBER

Digital Battery System Analyzer and Printer*

00002-V8150-KIT

GR8 Battery Diagnostic Station*

00002-MCGR8

QTY

1

* Essential SST

NOTE
Additional SSTs may be ordered by calling 1-800-933-8335.

Summary Chart for Long-Term Storage

Below are items that should be checked periodically and their frequency.
ACTION

FREQUENCY

Tire Inflation Pressure Check

Monthly

Parts Rust Inspection

Monthly

A/C Compressor Lubrication

Monthly

Test/Charge Disconnected Battery to 12.6V

Monthly

Disc Brake Rotor Surface Rust Removal

Every 8 weeks

Engine Starting and Vehicle Movement

Every 6 weeks

Rapgard™ Removal

After 90 days

Tyvek® Removal

After 12 months

A combination of proper vehicle receipt, Pre-Delivery Service (PDS), and vehicle storage is the
ONLY way to maintain factory fresh vehicles. Lexus’ goal is to deliver 100% problem-free cars and
trucks. With your commitment to quality and customer satisfaction, we can reach that goal. Review
this bulletin often and be sure new employees are aware of the policies and procedures outlined
herein, as individual training in proper inspection, PDS, and storage and handling techniques are
essential to ensure high-quality delivery.

© 2018 Lexus, a division of Toyota Motor Sales, USA

L-SB-0044-18

December 3, 2018

Page 3 of 5

Long-Term Vehicle Storage Guidelines
Long-Term Vehicle Storage Guidelines
Reference and Training Materials

Listed below are additional resources, which will help with vehicle receipt, inspection, and
storage procedures.


CRIB Bulletin #165, Acid Rain Paint Finish Damage – Prevention and Repair



UoT e-Learning Course E257 Vehicle Delivery Quality – Paint Finish Repair



Service Bulletin BO015-91, Prevention and Repair of Acid Rain Damage



Service Bulletin BO029-91, New Vehicle Washing Schedule for Paint Protection



Service Bulletin L-SB-0108-17, Battery Maintenance During PDS



Service Bulletin PA001-05, Iron Particle Rust Contamination Repair



Service Bulletin PG004-94, Dealer Removal Procedures for Rapgard™ Protective Film



Service Bulletin PG006-07, Removal of Tyvek® Protective Film



Service Bulletin PD001-04, Wheel Film for Brake Rotor Rust Prevention

Parking and Paint Protection



Storage areas should be paved, well lit, and secure. If the off-site storage lot is NOT paved,
spread gravel down to minimize mud and dust. Make sure vehicles are driven carefully when
moving them to or from a long-term lot. This will help minimize damage to the paint finish from
road grit or gravel.



Park vehicles from right to left AT LEAST 3 feet apart. Leave enough space front and rear to
easily walk between rows.



HVAC vent controls should be set to Recirc to minimize dust and odor intrusion.



Make sure the plastic door edge protectors are in place and fold in the side view mirror
(if applicable).



Anti-rust covers or anti-rust film should remain on vehicle during storage.
A. Anti-rust covers (behind wheel) should be removed during PDS.
B. Anti-rust film (applied to wheel) should be removed just prior to customer delivery.



Wash vehicles frequently.

© 2018 Lexus, a division of Toyota Motor Sales, USA

L-SB-0044-18

December 3, 2018

Page 4 of 5

Long-Term Vehicle Storage Guidelines
Long-Term Vehicle Storage Guidelines (continued)
Battery



Turn OFF ALL electrical accessories, make sure windows and sunroof are closed, and check
that the transmission is in Park (First or Reverse for manual transmission vehicles). Do NOT
apply the parking brake.



Test batteries monthly (more often in high heat or cold areas), using the Digital Battery System
Analyzer. Refer to Service Bulletin L-SB-0108-17, Battery Maintenance During PDS, for
complete battery maintenance procedures.



To reduce battery drain during long-term storage, remove the battery ground negative (–) cable
of each vehicle and re-install just before delivery to the customer. Locate the current PDS
Service Bulletin on TIS for complete details.



If a hybrid vehicle is put into storage, the State-Of-Charge (SOC) of its HV battery and auxiliary
battery will gradually decrease. To prevent the auxiliary battery from becoming discharged
during storage, proper maintenance is required. Refer to the applicable Maintenance for
HV and Auxiliary Batteries Service Bulletin for procedure and additional information.

Tire Inflation Pressure

If the vehicle is parked over an extended period without being moved, a flat spot may develop on
each tire surface in contact with the ground, even if the tires are inflated to specification. Tire
inflation pressure should be checked once a month.
Tire inflation pressure for storage ONLY: 45 psi.
Parts Rust

If the vehicles in the storage area are exposed to a sea breeze and/or significant precipitation,
corrosion with rust in some parts may occur.
If rust is found, remove it, and treat it by applying rust inhibitor to prevent recurrence.

Engine Starting and Vehicle Movement

1. If the vehicle is stored over an extended period, starting and running the engine periodically will
ensure smooth running operation.
NOTE
Be sure to allow sufficient clearance at the rear of the vehicle to prevent other vehicles stored behind
from getting damaged by exhaust gas.

2. Move the vehicle AT LEAST 30 feet to lubricate the transmission and differential and prevent
tire flat-spot damage.
3. Raise engine speed above 3,000 rpm (N/A for hybrid vehicles) 10 times to eliminate moisture
from the exhaust.
© 2018 Lexus, a division of Toyota Motor Sales, USA

L-SB-0044-18

December 3, 2018

Page 5 of 5

Long-Term Vehicle Storage Guidelines
Long-Term Vehicle Storage Guidelines (continued)
A/C Compressor Lubrication

To minimize the possibility of damage to the A/C compressor while storing a vehicle, perform
the following recommended maintenance procedures AT LEAST once a month to lubricate
the compressor.
1. Turn OFF the A/C and blower switches prior to starting the engine.
2. Start and warm up the engine until the engine idle drops below 1,000 rpm.
3. Turn ON the A/C system (including the rear A/C) using the following settings:


A/C Switch: ON



Blower Speed: High



Engine Speed: Below 1,000 rpm

4. Keep the A/C ON with the engine idling for AT LEAST 1 minute (in dual A/C vehicle, leave ON
for 2 minutes).
5. Turn OFF the A/C system and stop the engine.
Disc Brake Rotor Surface Rust Removal

The brake rotors are made of cast iron, so they may show gradual buildup of surface rust during
long-term storage. AT LEAST once every 2 months, drive the vehicle and use the brakes normally,
stopping from about 30 mph AT LEAST 20 times. This regular usage will help prevent severe rust
buildup and the possibility of unwanted brake vibration concerns due to rust.
Figure 1. Slight Rust on Rotor (Easy to Remove
by Braking)

Figure 2. Severe Rust on Rotor (Hard to Remove
by Braking)

NOTE
 If the brake vibration still occurs AFTER the braking cycle, determine the root cause of the brake
vibration, and repair.
 Brake rotor resurfacing may be required if the rust was severe and resulted in excessive rotor
thickness variation.

© 2018 Lexus, a division of Toyota Motor Sales, USA