TECHNICAL SERVICE BULLETIN
Dirt/Dust And/Or Ice Accumulation At The Bottom Inside Of Doors

18-2339
09 November
2018

This bulletin supersedes 17-0056. Reason for update: New Part/Procedure For Same Condition
Model:
Ford
2015-2018 Edge
Summary
This article supersedes TSB 17-0056 to update the Service Procedure, Parts List, and vehicle model years affected.
Issue: Some 2015-2018 Edge vehicles may exhibit dirt, dust and/or ice accumulation at the bottom of the inside of
the front and/or rear door openings. This may be due to extended driving on non-paved or slushy roads.
Action: Follow the Service Procedure steps to correct the condition.
Parts
Part Number

Description

Quantity

FT4Z-5828124-D

Body Mounted Weatherstrip (Right Side)

1

FT4Z-5828125-C

Body Mounted Weatherstrip (Left Side)

1

FT4Z-5820758-B

Lower Door Weatherstrip (Right Side)

1

FT4Z-5820759-B

Lower Door Weatherstrip (Left Side)

1

HT4Z-16A550-AA Mini Mudflap (Right Side)

1

HT4Z-16A550-BA Mini Mudflap (Left Side)

1

5G1Z-5421702-A

Grip Tape

2

Push Pin Retainer

2

W713331-S300

K2GZ-61021A46-B Foam Patch

1

Warranty Status: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage Warranty/ESP coverage
limits/policies/prior approvals are not altered by a TSB. Warranty/ESP coverage limits are determined by the
identified causal part and verified using the OASIS part coverage tool.
Labor Times
Operation
Time
No.

Description
2015-2018 Edge: Replace Both Rear Door Opening Weatherstrips And Install Both Front Mini
Mud Flaps (Do Not Use With Any Other Labor Operations)
Repair/Claim Coding
Causal Part:

5828124

Condition Code: 01
Tool List
Tool Name
Trim Tool
Erasable Marker
Ruler

182339A

0.6
Hrs.

Service Procedure
Apply the procedure to both rear doors.
1. Using a non-marring trim removal tool, remove the 7 push pins securing the rear door body mounted weatherstrip.
2. Pull the rear door body mounted weatherstrip away from the flange and discard.
3. Using a clean shop rag, clean any dirt that may have accumulated along the rear door body mounted weatherstrip
channel where the weatherstrip was removed.
4. Using an erasable marker, measure in a straight line and mark a distance of 45 cm (18 in). (Figure 1, Callout A)
Figure 1

5. Fold a piece of grip tape in half along the long direction. Peel away the tape backing. Starting from the marked
position, apply the grip tape around the metal weatherstrip channel, with half of the tape on each side. Press the
tape firmly against the channel to fully seat the tape. (Figure 1)
6. Install a new body mounted weatherstrip by starting from the top and pushing the 7 push pins into the door
opening frame. Slide the bottom half of the body mounted weatherstrip onto the flange.
7. Using an erasable marker, measure in a straight line and mark a distance of 17.5 cm (7 in) on the inside of the
rear door. (Figure 2, Callout A)
Figure 2

8. Peel away the tape backing of the foam patch and apply to the door with the bottom of the tape hitting the marked
position. Press the patch firmly to seat it. (Figure 2)
9. Raise the vehicle. Refer to WSM, Section 100-02.
10. Using a non-marring trim removal tool (RTTP or equivalent), remove the 9 push pins securing the lower door
weatherstrip assembly.
11. Replace the lower door weatherstrip assemblies by starting from the front and pushing the 9 push pins under the
lower door channel. (Figure 3)
Figure 3

12. Tuck the bottom of the body mounted weatherstrips inside the lower rocker weatherstrip.
13. On both sides, remove and discard the lower retainers from the left and right side rocker panel moulding end
caps located behind the front tires. (Figure 4)
Figure 4

14. Install the mini mud flaps under the rocker panel moulding end caps using a new lower retainer. (Figure 5)
Figure 5

15. Lower the vehicle. Refer to WSM, Section 100-02.

© 2018 Ford Motor Company
All rights reserved.
NOTE: The information in Technical Service Bulletins is intended for use by trained, professional technicians with the knowledge, tools, and
equipment to do the job properly and safely. It informs these technicians of conditions that may occur on some vehicles, or provides information
that could assist in proper vehicle service. The procedures should not be performed by "do-it-yourselfers". Do not assume that a condition
described affects your car or truck. Contact a Ford or Lincoln dealership to determine whether the Bulletin applies to your vehicle. Warranty Policy
and Extended Service Plan documentation determine Warranty and/or Extended Service Plan coverage unless stated otherwise in the TSB article.
The information in this Technical Service Bulletin (TSB) was current at the time of printing. Ford Motor Company reserves the right to supersede
this information with updates. The most recent information is available through Ford Motor Company's on-line technical resources.