Page 1 of 5

SI B01 04 16
N54 Tank Leak Diagnostic Module (DMTL) Pump:
Limited Warranty Extension to 10 Years/120,000
Miles

March 2016
Technical Service

SUBJECT

N54 Tank Leak Diagnostic Module (DMTL) Pump: Limited Warranty Extension to 10
Years/120,000 Miles
MODEL

F01 (740i Sedan)
Model Year 2012 produced 2/17/2011 to 6/20/2012
F02 (740i Sedan LWB)
Model Year 2012 produced 2/28/2011 to 6/20/2012
With the N54 engine
INFORMATION

For the above-referenced vehicles, BMW of North America, LLC (“BMW NA”) is extending the
limited warranty for the tank leak diagnostic module (DMTL) pump to:
z

10 years/120,000 miles as determined by the vehicle’s original in-service date

Item #1: This “component-specific”
limited warranty extension applies to
defects in materials and workmanship
and is subject to the applicable vehicle
and coverage eligibility requirements,
exclusions and limitations that apply to
the BMW New Vehicle Limited
Warranty for Passenger Cars and Light
Trucks.

This bulletin is notice of a “limited warranty extension.” This is NOT a notice of a Recall or
Service Action.
There is no immediate repair required unless the BMW vehicle is currently experiencing this
problem.

https://www.bmwtis.net/tiscode/cgi-bin/bulletin.aspx?sie_path=/tsb/bulletins/htm_store/314... 4/4/2016

Page 2 of 5

Even though this is NOT a Recall, BMW NA will be sending VIN-specific customer notification
letters in a phased release.
Customer Notification Letter – VIN and Component-specific Warranty Extension
Even though this is NOT a Recall, BMW NA will be sending VIN-specific customer notification
letters in a phased release.
INCLUDED MODELS
The “model year” start and end date (SOP/EOD) for a specific “model” vehicle within a Series will
vary for a number of reasons.
If you are reviewing and verifying a specific vehicle for inclusion, it is important to first:
z

Confirm that the “model” and “model year” are identified in the “Model” list above; and
second

z

Confirm vehicle’s “product date” is also within corresponding date range (the
“MM/DD/YYYY” version is available in ISPA Light)

ELIGIBLE BMW VEHICLES
To assist you in identifying the eligible vehicles, the DCSnet Warranty Vehicle Inquiry has been
updated with the “Vehicle Comment” shown below:
BMW NA has extended the limited warranty for the tank leak diagnostic module
(DMTL) pump on this vehicle to 10 years/120,000 miles as determined from the
original in-service date. This component-specific limited warranty extension is subject
to all the applicable vehicle and coverage eligibility requirements, exclusions and
limitations that apply to the BMW New Vehicle Limited Warranty for Passenger Cars
and Light Trucks. Please seeSI B01 04 16.
Note: Always check the DCSnet Warranty Vehicle Inquiry “Vehicle Comments” and the “Repair
History (Claims)” sections first, before performing any repairs.
PARTS INFORMATION

Please refer to the Electronic Parts Catalog (ETK/EPC), using the customer’s VIN to locate the
applicable replacement part numbers.
Important Notes:
z

Only order these parts in the quantities needed to address customers’ vehicles that have
confirmed failures.

z

“Only in conjunction with” parts: When applicable, if ETK/EPC identifies additional part
(s) that must also be replaced/installed together with the replacement of this component.
These “required” additional items are also covered “in-conjunction” and under the terms of
this extended limited warranty.

https://www.bmwtis.net/tiscode/cgi-bin/bulletin.aspx?sie_path=/tsb/bulletins/htm_store/314... 4/4/2016

Page 3 of 5

z

Also refer to ETK/EPC and the repair instructions for onetime-use fasteners/screws and other
information regarding repair-related gaskets, seals, fluid and/or lubricants that also need to be
replaced/used and claimed.

WARRANTY INFORMATION

The tank leak diagnostic module (DMTL) pump limited warranty extension to 10 years/120,000
miles applies to “eligible US-specification BMW vehicles” that are registered, operated and have
their covered repair performed by an authorized BMW center in the United States (including Puerto
Rico).
This coverage supersedes the coverage that is provided under the BMW Certified Pre-Owned
Program or any BMW Group Vehicle Service Contract that applies to the vehicle.
Should the DMTL pump fail again, this component is covered by the remaining portion of the
extended limited warranty coverage period.
The existing limited warranty coverage for all other parts has not changed.
Non-Qualifying Repairs
Non-US specification vehicles, ineligible vehicles, eligible vehicles operated and repaired outside
the United States and Puerto Rico and/or the diagnosis and repair of other unrelated issues are not
covered under the terms of this limited warranty extension.
Qualifying Repairs - Claim Submission
Claim this work with the defect code and labor operations provided below.

Defect Code:

16 13 90 01 00

Tank Leak Diagnostic Module
(DMTL) Pump - Limited Warranty
Extension

Labor Operation:

Labor Allowance:

Description:

00 00 006

Refer to KSD2

Performing “vehicle test” (with vehicle
diagnosis system – checking faults)

Refer to KSD2

Connect an approved battery
charger/power supply(indicated in
KSD2 as “Charging battery”)

Refer to KSD2

checking fuel tank leak module (after
vehicle diagnosis)

And:
61 21 528
And, as necessary:
16 00 720

https://www.bmwtis.net/tiscode/cgi-bin/bulletin.aspx?sie_path=/tsb/bulletins/htm_store/314... 4/4/2016

Page 4 of 5

And:
If you are using a Main labor code for another repair, use the Plus code labor operation 00 00 556
instead.
Refer to KSD2 for the corresponding flat rate unit (FRU) allowances.
And, if necessary:
Sublet – Bulk Materials

Sublet Code 4

Reimbursement for the repair-related
See sublet reimbursement bulk materials (BMW part number,
calculation below
please do not use the part numbers for
claim submission)

Sublet reimbursement calculation for claiming the “used quantities” of repair-related bulk materials
(BMW part numbers) is at dealer net plus your center’s handling.
Enter this material cost in sublet and itemize the amount on the repair order and in claim comment
section.
Previous Customer-pay Repairs – Limited Warranty Extension Reimbursement
Under this extended limited warranty, BMW of North America, LLC (“BMW NA”) will provide
reimbursement for “qualifying customer-pay repairs” that were performed on an eligible vehicle
prior to the release of this component-specific limited warranty extension.
Customer-pay repairs are subject to the applicable vehicle and coverage eligibility requirements,
exclusions and limitations that apply to the BMW New Vehicle Limited Warranty for Passenger
Cars and Light Trucks.
Repairs that do not Qualify for Reimbursement
Repairs performed on ineligible vehicles, eligible vehicles operated and repaired outside the United
States and Puerto Rico and/or the diagnosis and repair of other unrelated issues. This exclusion
applies to repairs, including consequential, that were performed using non-genuine BMW parts
and/or used passenger car or light truck parts.
Requesting Reimbursement for a Previous Repair that Qualifies
For a customer to request reimbursement for a “qualifying customer-pay repair” performed either
by an authorized BMW center or independent repair shop located in the United States (including
Puerto Rico), please have him/her submit his/her reimbursement request “online” at www.BMWRP.com under the following reference:
z

B-ELWR 2016 DMTL Pump 10Y120M

https://www.bmwtis.net/tiscode/cgi-bin/bulletin.aspx?sie_path=/tsb/bulletins/htm_store/314... 4/4/2016

Page 5 of 5

Reimbursement Request Procedure
The online process is initiated by attaching/sending “PDF files” of the supporting documentation
for the “prior repair.”
The website, the customer-pay reimbursement attachment to this bulletin and the soon to be mailed
customer letters all provide information as to “what” documentation is needed to be supplied to
support a prior repair.
Note: The online reimbursement request option will be available the week of 3/14/2016.
Alternative methods to request reimbursement, either through the mail or by fax, are also provided.
A copy of the “Customer-pay” reimbursement attachment may be printed and provided to
the customer.
ATTACHMENTS

View PDF attachment B010416 Prior Customer-pay Repairs.
[ Copyright ©2016 BMW of North America, Inc. ]

https://www.bmwtis.net/tiscode/cgi-bin/bulletin.aspx?sie_path=/tsb/bulletins/htm_store/314... 4/4/2016