2019

Q8
Audi Pre-Delivery Inspection
Stock No.

Dealer Number

R.O. No.

VIN

Road test mileage out

Road test mileage in

Reminders
 All items must be completed prior to customer delivery by an Audi technician
 Audi recommends using an Audi approved battery charger to prevent excessive battery discharge during inspection
 ALL PDI function tests must be run in Guided Fault Finding (GFF) using PDI Total Function Test Plan only. Do NOT use Guided
Functions for any PDI related test as these will not be uploaded to the Paperless Server. Refer to the Special functions tab of ODIS
Diagnosis for using GFF for PDI function tests
 It is advised to start ODIS with the engine running to enable all 5F Test Plans in GFF
 For items marked with *, please refer to the PDI Technician Reference Document posted on ServiceNet for additional information
 For items marked with **, follow instructions for stock inventory vehicle

Vehicle Preparation

Exterior (continued)

 Check Elsa for open campaigns and updates

 Check all doors for proper power closing (if equipped)*

 Deactivate vehicle transport mode*
This step must be performed with the engine off, and ignition on*
Note: The VAS 6154 diagnostic head is required along with
ODIS Audi Brand version 2.15.5 or higher*

 Inspect exterior for damage, dings, dents and surface
scratches

 Deactivate air suspension loading mode (if equipped)*
 Set service reminder*
 Perform any open campaigns*
 Set the service intervals to 10k instead of 5k during PDI or
existing 2017 vehicles that are set incorrectly
1. Click on the “Special functions” tab
2. Scroll down to ‘Maintenance’
3. Select the 17 - inspection with oil change - 10,000 miles,
USA function test
4. Perform the function test, but make sure you select
“USA” as the country variant and when the question
“Which service display should be reset?” comes up,
select #2 (Oil service display and inspection service
display).
5. Then the MMI® indicator should now properly display the
following values

Lighting and Windshield
 Test exterior lighting functions
 Test front washers (and headlight washers if equipped)*
 Install wiper blades
Trunk Inspection
 Verify power tailgate is operational and set to maximum
opening height (if equipped)*
 Verify operation of emergency release handle
 Install wheel bolt cover removal tool from PDI kit into trunk
tool kit*
 Verify tool kit is installed securely in luggage compartment
 Check battery clamps for proper torque*
 Set spare tire pressure*
Interior
 Verify operation of all seat belts and latches

− Next oil service in 10,000 miles / 365 days

 Check operation of window, lock, and seat controls*

− Next inspection service at 20,000 miles / 730 days

 Inspect mirrors for proper operation*
 Check rear view mirror operation*

Exterior

 Verify operation of all interior lights

 Check all key buttons and features*

 Check heated steering wheel operation (if equipped)

Effective 9-17-2018-US
Version 1.0

PRE-DELIVERY INSPECTION (PDI) | 1

2019

Q8
Audi Pre-Delivery Inspection
Interior (continued)

On-Hoist Inspection (continued)

 Verify operation of heated/ventilated and massaging seats
(if equipped)*

 Install wheel locks (if equipped)

 Verify operation of manual folding 2nd row seats

 Inspect wheel bolts for proper torque*

 Verify proper operation of climate control*

 Set and store tire pressures for either sold vehicle OR stock
inventory vehicle*

 Inspect operation of all power outlets*

 Install wheel bolt covers and center caps as supplied*

 Check panoramic sunroof and sunshade operation*
 Verify operation of rear side sunshade operation (if
equipped)

Driving Performance

 Verify operation of front Passenger Occupant Detection
System

 Verify hold and release of electronic parking brake

Settings

 Verify engine performance and acceleration*

 Verify operation of MMI® touch screens, upper and lower

 Verify transmission operation, including shift paddles (if
equipped)

 Set Time source setting to “GPS” and set Auto daylight savings time to “on”*

 Check horn operation
 Verify engine Start-Stop System functionality*

 Test drive vehicle applying brakes several times*

 Verify and set language and measurement units*

 Check adaptive air suspension in all positions (if equipped)

 Verify Speech Dialog System is operating*

 Check steering/tire alignment

 Set “Music volume while parking” to medium*

 Check for squeaks, rattles and wind noise

 Set dealership location in navigation*

 Calibrate rear view mirror*

 Turn off Manual Speed Warning (if equipped)*

 Verify quality of radio reception in AM/FM/SiriusXM® bands

Media / Radio / SAT
 Verify operation of aux. input
 Verify operation of CD/DVD player (if equipped)
 Insert SD card and test function of slot
 Program the presets to local stations
 Verify HD Radio is turned “off”*
 Verify Audi phone box sticker and registration information is
present (if equipped)

Driver Assistance
 Verify all cruise control functions
 Verify cruise control/ACC with Stop & Go functionality (if
equipped), which includes the following:
 Adaptive Cruise Assist
 Turn Assist
 Intersection Assistant
 Traffic Jam Assist

Audi connect® (USA ONLY)
 Turn on the Wi-Fi® hotspot (if equipped)*
 Check Wi-Fi® hotspot visibility. No data available at PDI due
to dealer demo mode (if equipped)*
 Enable satellite map for navigation (if equipped)*
On-Hoist Inspection
 Remove transport suspension blocks (follow ELSA instructions)
 Check underside of vehicle for fluid leaks and loose components

 Predictive Efficiency Assist
 Active lane assist with emergency assistant
 Traffic sign recognition
 Verify Audi side assist functionality Pre sense® rear (if
equipped)
 Verify operation of night vision camera (if equipped)
 Verify operation of parking system*
 Verify all vehicle Head-up display functionality (if equipped)*
 Verify operation of High-beam assist (if equipped)
 Activate NAV and follow directions back to dealership

 Check steering, boots, brake system, hoses, tires and wheels
for damage
Effective 9-17-2018-US
Version 1.0

PRE-DELIVERY INSPECTION (PDI) | 2

2019

Q8
Audi Pre-Delivery Inspection
Post-Road Test Inspection
 Interrogate fault memory and upload diagnostic log to
GFF Paperless Server
 Perform a battery test*
 Check service interval and verify correct interval is displayed
 Check engine oil level*
 Check all fluid levels and top off if necessary
 Ensure the yellow tire pressure tag is installed on the
steering wheel
 Apply Inventory Maintenance Sticker**
 Install showroom charger to ensure battery remains
charged at all times**

Technician
I certify that all operations have been completed and this vehicle has been prepared in accordance with Audi Procedures and
Quality Standards, and has met the standards for Perfect Delivery.

Technician Signature

Effective 9-17-2018-US
Version 1.0

Last 8 of VIN

Completion Date

PRE-DELIVERY INSPECTION (PDI) | 3