6/21/2018

LTB01179NAS1 - Click Noise When Opening/Closing Front/Rear Door | TOPIx

LT B 0 1 1 7 9 N A S 1

TECHNICAL BULLETIN
21 JUN 2018

© Jaguar Land Rover North America, LLC
NOTE: The information in Technical Bulletins is intended for use by trained, professional Technicians
with the knowledge, tools, and equipment required to do the job properly and safely. It informs these
Technicians of conditions that may occur on some vehicles, or provides information that could assist in
proper vehicle service. The procedures should not be performed by 'do-it-yourselfers'. If you are not a
Retailer, do not assume that a condition described affects your vehicle. Contact an authorized Land
Rover service facility to determine whether this bulletin applies to a specific vehicle.

I N F O R M AT I O N

SECTION:
501-03: Body Closures

S U B J E C T/ C O N C E R N :
Click Noise When Opening/Closing Front/Rear Door

AFFECTED VEHICLE RANGE:
MODEL:
LR4 (LA)

MODEL YEAR:
2010-2016

VIN:
516596-847658

https://topix.jaguar.jlrext.com/topix/content/document/view?id=903740

ASSEMBLY PLANT:
Solihull

1/5

6/21/2018

LTB01179NAS1 - Click Noise When Opening/Closing Front/Rear Door | TOPIx

MARKETS:
NORTH AMERICA

CONDITION SUMMARY:

SITUATION:
A click type noise may be heard when opening/closing a front and/or rear door.
CAUSE:
This may be caused by the front and/or rear door check arms being contaminated with dust/sand.
ACTION:
Should a customer express a concern, follow the appropriate Workshop Procedure below.

PA RTS :
PART NUMBER

DESCRIPTION

QUANTITY

BDH780070

Door check arm

Up to 4

BFM500020

Door check arm cover

Up to 4

WARRANT Y:

NOTES:
Repair procedures are under constant review, and therefore times are subject to change;
those quoted here must be taken as guidance only. Always refer to JLR claims submission
system to obtain the latest repair time.
The JLR Claims Submission System requires the use of causal part numbers. Labor only claims
must show the causal part number with a quantity of zero.
DESCRIPTION

SRO

https://topix.jaguar.jlrext.com/topix/content/document/view?id=903740

TIME (HOURS)

CONDITION CODE

CAUSAL PART

2/5

6/21/2018

LTB01179NAS1 - Click Noise When Opening/Closing Front/Rear Door | TOPIx

DESCRIPTION

SRO

TIME (HOURS)

CONDITION CODE

CAUSAL PART

Check Arm - Front Door - Each - Replace

76.40.64

0.5

41

BDH780070

Check Arm - Front Door - Pair - Replace

76.40.65

0.9

41

BDH780070

Check Arm - Rear Door - Each - Replace

76.40.66

0.4

41

BDH780070

Check Arm - Rear Door - Pair - Replace

76.40.67

0.7

41

BDH780070

NOTE:
Normal Warranty procedures apply.

WORKSHOP PROCEDURE 'A': FRONT DOOR

Perform this Workshop Procedure only for a customer concern of a click noise when
opening/closing a front door.
1

Remove and discard the affected front door check arm (see TOPIx Workshop Manual section
501-03: Body Closures - Removal and Installation - Front Door Check Arm - Removal steps 16).

https://topix.jaguar.jlrext.com/topix/content/document/view?id=903740

3/5

6/21/2018
2

LTB01179NAS1 - Click Noise When Opening/Closing Front/Rear Door | TOPIx



Install the new door check arm cover to the new front door check arm as shown.
3

Install the new front door check arm (see TOPIx Workshop Manual section 501-03: Body
Closures - Removal and Installation - Front Door Check Arm - Installation steps 1-5).

4

Only if required: repeat steps 1-3 for the other front door.

WORKSHOP PROCEDURE 'B': REAR DOOR

Perform this Workshop Procedure only for a customer concern of a click noise when
opening/closing a rear door.
1

Remove and discard the affected rear door check arm (see TOPIx Workshop Manual section
501-03: Body Closures - Removal and Installation - Rear Door Check Arm - Removal steps 1-5).

https://topix.jaguar.jlrext.com/topix/content/document/view?id=903740

4/5

6/21/2018
2

LTB01179NAS1 - Click Noise When Opening/Closing Front/Rear Door | TOPIx



Install the new door check arm cover to the new rear door check arm as shown.
3

Install the new rear door check arm (see TOPIx Workshop Manual section 501-03: Body
Closures - Removal and Installation - Rear Door Check Arm - Installation steps 1-4).

4

Only if required: repeat steps 1-3 for the other rear door.

https://topix.jaguar.jlrext.com/topix/content/document/view?id=903740

5/5