SERVICE PROCEDURE
13511
NOVEMBER 2013
SUBJECT:

SAFETY RECALL
Flip Seat on certain CE and RE bus models built 06
October 2005 through 18 April 2012 with the C.E.
White Flip Seat

DEFECT DESCRIPTION
The C.E. White Company has determined that a safety related design defect
exists in certain flip seats installed in certain IC Buses™. The occupant of the
adjacent seat located to the rear of the flip seat could suffer a pinch point injury
to their toes and / or foot as a result of this condition.

MODELS INVOLVED
This safety recall involves certain CE and RE bus models built 06 October 2005
through 18 April 2012 with the C.E. White flip seat.

PARTS INFORMATION
NOTE: The scope of buses requiring the 39-in seat guard is very narrow in
that it affects ONLY the 29 VINs listed below the Parts Information section.
There is also ONLY ONE bus that requires a 30-inch seat guard, DO NOT
preorder 39-in seat guards or 30-in seat guard for inventory, and only order
39-in seat guards or 30-in seat guard when customer repair request is
confirmed for one of the VINs listed below. This will allow 39-in seat guards
and / or 30-in seat guard to be available for each dealer when a customer
requests repair.

Part Number
8900241R91

8900242R91
8900243R91

Part Description
Kit, Flip Seat Guard, 45 In (used on all buses
except Clovis Unified School and Sanger Unified
School buses)
Kit, Flip Seat Guard, 39 In W/Bar LH (used only
on Clovis Unified School and Sanger Unified
School buses)
Kit, Flip Seat Guard, 30 In (used only on
Brockport School District bus)

Quantity
1

1
1

VEHICLE RECALL 13511
© 2013 Navistar, Inc. All rights reserved. All marks are trademarks of their respective owners.

1

8900241R91 contains the following parts:
Part Number
2512391C1
2512392C1

Part Description
Rivet, 0.18 X 0.501, Steel
Guard, Flip Seat, 45 In ABS

Quantity
4
1

8900242R91 contains the following parts:
Part Number
2512391C1
2512393C1

Part Description
Rivet, 0.18 X 0.501, Steel
Guard, Flip Seat, 39 In LH W / Bar Opening

Quantity
4
1

8900243R91 contains the following parts:
Part Number
2512391C1
2512394C1

Part Description
Rivet, 0.18 X 0.501, Steel
Guard, Flip Seat, 30 In ABS

VINs shown below require 39-in
guard P/N 8900242R91. All other
campaign related units
will
require
45-in
guard
P/N
8900241R91:
4DRBWAAR0CB614027
4DRBWAAR0CB614030
4DRBWAAR1CB614019
4DRBWAAR1CB614022
4DRBWAAR1CB614036
4DRBWAAR1CB696186
4DRBWAAR2CB614014
4DRBWAAR2CB614028
4DRBWAAR2CB614031
4DRBWAAR3CB614023
4DRBWAAR3CB614037
4DRBWAAR4CB614015
4DRBWAAR4CB614029
4DRBWAAR4CB614032
4DRBWAAR5CB614024

Quantity
4
1

4DRBWAAR5CB614038
4DRBWAAR6CB614016
4DRBWAAR6CB614033
4DRBWAAR6CB696183
4DRBWAAR7CB614025
4DRBWAAR8CB614017
4DRBWAAR8CB614020
4DRBWAAR8CB614034
4DRBWAAR8CB696184
4DRBWAAR9CB614026
4DRBWAARXCB614018
4DRBWAARXCB614021
4DRBWAARXCB614035
4DRBWAARXCB696185
VIN shown below requires 30-in
guard P/N 8900243R91:
4DRBUAAN69B059189

VEHICLE RECALL 13511
© 2013 Navistar, Inc. All rights reserved. All marks are trademarks of their respective owners.

2

SERVICE PROCEDURE
WARNING! PARK VEHICLE ON HARD FLAT SURFACE, TURN THE ENGINE
OFF, SET THE PARKING BRAKE AND BLOCK THE WHEELS TO PREVENT
THE VEHICLE FROM MOVING IN BOTH DIRECTIONS. FAILURE TO DO SO
MAY RESULT IN PROPERTY DAMAGE, PERSONAL INJURY AND / OR
DEATH.
WARNING! IF THE VEHICLE MUST BE RAISED, DO NOT WORK UNDER THE
VEHICLE SUPPORTED ONLY BY JACKS. JACKS CAN SLIP OR FALL OVER,
POTENTIALLY RESULTING IN PROPERTY DAMAGE, PERSONAL INJURY
AND / OR DEATH.
WARNING! ALWAYS WEAR SAFE EYE PROTECTION WHEN PERFORMING
VEHICLE MAINTENANCE. FAILURE TO DO SO MAY RESULT IN PERSONAL
INJURY AND / OR DEATH.
1. Bring vehicle into shop and park on flat surface.
2. Shift transmission to park or neutral and set parking brakes.
3. Install wheel chocks.

VEHICLE RECALL 13511
© 2013 Navistar, Inc. All rights reserved. All marks are trademarks of their respective owners.

3

Figure 1. Main Mounting Bar.
1. Bolt (3)
2. Main mounting bar
3. Retractor belt bracket (2)

4. Remove three bolts (Figure 1, Item 1) and main mounting bar
(Figure 1, Item 2) from retractor belt brackets (Figure 1, Item 3), and allow
retractor belt brackets to hang (Figure 1).

VEHICLE RECALL 13511
© 2013 Navistar, Inc. All rights reserved. All marks are trademarks of their respective owners.

4

Figure 2. Safety Guard.
1. Safety guard
NOTE: Perform Step 5 at wall and aisle sides of seat.
5. From rear side of seat, position safety guard (Figure 2, Item 1) as shown.

VEHICLE RECALL 13511
© 2013 Navistar, Inc. All rights reserved. All marks are trademarks of their respective owners.

5

Figure 3. Safety Guard Installation.
1. Rivet (4) (two shown)
2. Safety guard

6. Drill four 3/16-in holes (two on each end) through cushion flip frame hinge
and safety guard (Figure 3, Item 2).
7. Install safety guard onto seat with four 3/16-in rivets (Figure 3, Item 1).

VEHICLE RECALL 13511
© 2013 Navistar, Inc. All rights reserved. All marks are trademarks of their respective owners.

6

Figure 4. Main Mounting Bar.
1. Bolt (3)
2. Main mounting bar
3. Retractor belt bracket (2)

8. Install main mounting bar (Figure 4, Item 2) to retractor belt brackets
(Figure 4, Item 3) with three bolts (Figure 4, Item 1).
9. Remove wheel chocks.

END OF SERVICE PROCEDURE

VEHICLE RECALL 13511
© 2013 Navistar, Inc. All rights reserved. All marks are trademarks of their respective owners.

7

LABOR INFORMATION
Operation Number

A40-13511-1

Description

Install Plastic Guard

Time

0.3 hr

CAMPAIGN IDENTIFICATION LABEL
Each vehicle corrected in accordance with this
campaign must be marked with a CTS-1075
Campaign Identification Label.
Complete the label and attach on a clean surface
next to the vehicle identification number (VIN) plate.

VEHICLE RECALL 13511
© 2013 Navistar, Inc. All rights reserved. All marks are trademarks of their respective owners.

8

ADMINISTRATIVE / DEALER RESPONSIBILITIES
WARRANTY CLAIMS
Warranty claim expense is to be charged to Warranty. Claims are to be
submitted in the normal manner, making reference to Safety Recall 13511.
It is important that the coding be completed properly to assist in processing the
warranty claim. Complete instructions will be found in the Warranty Policy
Manual, Section 7.1.8.
As with all claim submissions, items acquired locally must be submitted in the
“Other Charges” tab. The cost of any bulk items (such as a bag of cable tie
straps, roll of wire, a barrel of oil, or a tube of silicone) should be prorated for the
cost of the individual pieces / amount used during each repair.

VEHICLE RECALL 13511
© 2013 Navistar, Inc. All rights reserved. All marks are trademarks of their respective owners.

9

UNITED STATES AND POSSESSIONS
The National Traffic and Motor Vehicle Safety Act, as amended, provides that
each vehicle that is subject to a vehicle recall campaign must be adequately
repaired within a reasonable time after the owner has tendered it for repair. A
failure to adequately repair within 60 days after a tender of a vehicle is prima
facie evidence of failure to repair within a reasonable time. If the condition is not
adequately repaired within 60 days, the owner may be entitled to replacement
with an identical or reasonable equivalent vehicle at no charge, or to a refund of
the purchase price less a reasonable allowance for depreciation.
Dealers must correct all vehicles subject to this campaign at no charge to the
owner, regardless of mileage, age of vehicle, or ownership, from this time
forward.
Dealers should proceed immediately to make necessary correction to units in
inventory. All inventory vehicles subject to this recall campaign must be
corrected prior to sale, transfer or delivery. If vehicles have been sold or
transferred and you are in receipt of Customer Notification Letters and
Authorization for Recall Service cards for those vehicles, the transfer location or
customer must be notified immediately from your dealer location.
Dealers must make every effort to promptly schedule an appointment with each
owner to repair his or her vehicle as soon as possible. However, consistent with
the customer notification, dealers are expected to complete the repairs on the
mutually agreed upon service date.
Dealers involved in the recall process will be furnished a listing of owner names
and addresses to enable them to follow up with owners and have the vehicles
corrected. Use of this listing must be limited to this campaign because the list
may contain information obtained from state motor vehicle registration records,
and the use of such motor vehicle registration data for purposes other than this
campaign is a violation of law in several states.

NAVISTAR, INC.

VEHICLE RECALL 13511
© 2013 Navistar, Inc. All rights reserved. All marks are trademarks of their respective owners.

10