L-SB-0034-15 Revi August 5, 2015 © Lexus

Technical Service Information Bulletin

Floor Mat Installation During PDS

Service
Category General
Leaus Supports, EAS
Section —Pre-Delivery Service Market USA ASE Certification’
Applicability
YEAR(S) MODEL(S) ADDITIONAL INFORMATION
2016 CT200H, ES300H, ES350,

GS F, GS200T, GS350,
GS450H, GX460, IS200T,
1$300, 1S350, LS460,
LS600H, LX570, NX200T,
NX300H, RC F, RC200T,
RG300, RC350, RX350,
RX450H

REVISION NOTICE
February 25, 2016 Revi:

© Applicability has been updated to include 2016 model year GS F, GS 200t, GX 460, IS 200/300,
and RC 200/300 vehicles.

Any previous printed versions of this bulletin should be discarded.

Introduction

2016 model year vehicles are equipped with driver's side floor mat retaining clips to secure the
floor mat in the correct position. In addition, some models may utilize retaining clips for passenger
side and rear seat floor mats as well. Follow the appropriate installation procedure to attach the
driver's side, and if applicable, passenger's side and rear seat floor mats to the vehicle carpet
using the floor mat retaining clips during Pre-Delivery Service (PDS).

© 2016 Lexus, a division of Toyota Motor Sales, USA Page 1 of 6

(C4) Lexis L-SB-0034-15 Revi August 5, 2015 Page 2 of 6

Floor Mat Installation During PDS

Introduction (Continued)

CAUTION

« ALWAYS verify the floor mat to ensure it is designed specifically for the model and model
year it is being installed in.

e ONLY use floor mats that can be retained using the retaining clips. All OEM Lexus floor mats
are specifically designed to fit correctly and be retained using the retaining clips.

* Make sure the floor mat is properly placed on the vehicle carpet and secured with the retaining
clips. If the driver side floor mat is NOT properly placed and secured, it could slip and interfere
with the movement of the pedals during driving and may cause an accident.

¢ Verify the operation of the accelerator, brake, and clutch (if equipped) pedals and clearance
to the mat.

¢ NEVER install more than one floor mat at a time in the driver's seating position.
¢ If applicable, any secondary set of floor mats (based upon customer preference, such as the
all-weather floor mats or other floor mats) MUST be placed in the trunk with all the packaging

material intact. Do NOT install the secondary mat on top of the primary floor mat already
installed in the driver’s seating position.

Warranty Information

OP CODE DESCRIPTION TIME OFP "1 12
NIA Not applicable to Warranty - - = -

© 2016 Lexus, a division of Tayota Motor Sales, USA

@ Juexus (1-SB-0034-15 Revi August 5, 2015 Page 3 of 6

Floor Mat Installation During PDS

Installation Procedure (Hook Style)

1. Verify that the driver, and if applicable, passenger side and rear seat floor mats are for the
correct model and model year they are being installed in.

2. Attach the driver and if applicable, passenger side and rear seat floor mats to the vehicle
carpet using the retaining clips. Secure the mat by inserting the retaining clips through the
grommet holes

Figure 4

4 Retaining Clips 3 Correct Installation

2 | Grommets

© 2016 Lexus, a division of Toyota Motor Sales, USA

@ JLExXLis L-SB-0034-15 Revi August 5, 2015 Page 4 of 6

Fioor Mat Installation During PDS

Installation Procedure (Hook Style} (Continued)

3. Verify proper installation.

NOTE

If applicable, DO NOT remove the beige “Caution” tag from the floor mat. This should only be
removed by the customer.

Figure 2

A Caution / Precaucién / Attention /_y34.5 A

NOTICE: THIS TAG TO BE REMOVED BY CUSTOMER ONLY.
To avoid inlerference with pedal operator:

+ Exch met must be secured with rotontion hooks (clips)

= Do not instal a floor mat on tap of an existing floor mat

AVISO: SOLAMENTE EL CLIENTE DEBE REMOVER ESTA ETIQUETA,
Para evitar Inlerferencia con la operaciin del pedal
oO = Coda tapate debe aujetarse con saguros de retencién (brochea)

No Instale unitapete de piso encima de un tapate do pito axistente

REMARQUE : CETTE ETIQUETTE NE PEUT ee ENLEVEE QUE PAR LE CLIENT,
Pour éuitar des interférences evet le fonconnement da lo

“Cheque lapis doit tre fixd & lade des crochets do Peer {agrates)

*Ninstalloz pas un taps par-dessus un taps dja en place

Ash Spend) Suh Cpe ABLiag ode £55 Gey laut}
p Petal ALE al ot cunts nye Rte ihe 9 MM ye stat
Ge Bo BA Sd Bd aT

Tewr-ooourevs [7]

© 2016 Lexus, a division of Toyota Motor Sales, USA

© cexus L-SB-0034-15 Revi

Floor Mat Installation During PDS

August 5, 2015

Page 5 of 6

Installation Procedure (Knob Style)

1.

Verify that the driver, and if applicable, passenger side and rear seat floor mats are for the
correct model and model year they are being installed in

Align the floor mat holes with the retention
clip knobs and place the floor mat holes
onto the retention clip knobs.

Turn the retention clip knobs a quarter of a

turn to lock in place and verify the “triangle”

marks on the retention clip knob and floor
mat are aligned.

Figure 3.

1 | Retention Clip Eyelet on Floor Mat

2 | Retention Clip

3 Front of Vehicle

Figure 4.

4 Twist Knob

2 Knob in Locked Position

3 Align “Triangle” Marks

© 2016 Lexus, a division of Toyota Motor Sales, USA