T-SB-0026-12 Rev2

Entune/Navigation Software U
Audio (Non-HDD Type)

Service
Category Audio/Visual/Telematics

January 24, 2012

C) TOYOTA

Technical Service Bulletin

pdate Process for Display

Toyota Supports

ASE Ceriheauon Zest

Section Navigation/Multi Info Display Market USA
Applicability
YEAR(S} MODEL(S) ADDITIONAL INFORMATION
2012 4Runner, Camry,
Camry HV, Corolla,
Prius, Prius C, Prius
PHV, Prius V, RAV4,
Tacoma
2013 4Runner, Avaton,

Camry, Camry HV,
Corolla, Highiander,
Highlander HV, Prius,
Prius C, Prius PHV,
Prius V, RAV4,
Tacoma, Venza

REVISION NOTICE
January 16, 2013 Rev2:

* Software Version has been updated.

dune 28, 2012 Revi:

* SST part number has been updated.

* Repair Procedure has been updated.

* Applicability has been updated to include 2013 model year vehicles.

* Applicability has been updated to include 2013 model year Venza vehicles.

Any previous printed versions of this service bulletin should be discarded.

© 2013 Toyota Motor Sales, USA

Page 1 of 5
CP TOYOTA T-SB-0026-12 Rev2 January 24, 2012 Page 2 of 5

Entune/Navigation Software Update Process for Display Audio (Non-HDD Type)

Introduction

Use the following procedures to check and/or update the software version of Entune/Navigation for
Non-HDD Type units.

NOTE
* Non-HDD Type Navigation units have a CD slot visible on the front of the radio.

- HDD Type Navigation units have a tilt-open navigation screen and CD siot behind the screen.

Required Tools & Equipment
SPECIAL SERVICE TOOLS (SST) PART NUMBER ary
Firmware Update USB Drive* 01004-HBEKR-13A 1

* Essential SST.

NOTE
Additional SSTs may be ordered by calling 1-800-933-8335.

Warranty Information
OP CODE DESCRIPTION TIME OFP T1 «| *T2
NYA Not Applicable to Warranty =

© 2013 Toyota Motor Sales, USA

TOYOTA T-SB-0026-12 Rev2 —- January 24, 2012 Page 3 of 5

Entune/Navigation Software Update Process for Display Audio (Non-HDD Type)

Software Version Check Procedure
1. Press the “Setup” button.

2. In Setup menu press “General”. Figure 1.

ber da] Ene

ese cc oe [is

[ Audic j) Wimels a
a Nae f=

3. In the General Settings menu scroll down and Figure 2.
ress “System Information’. ss ;
7 ¥ feral Settings
(pi MSEC SRL Clic: Rte CTs oO = Se 7
Restere Cantact Backus from UB (a

System Information WS -

4. In the System Information menu the Software Figure 3.
Version information is displayed (eg., 1.7.X, 1.8.4,
2.1.0).

ATE UME Ct

ST aM cee aa

er
el
-_ ‘

APES Co IC) ME a OPEL)

Tt Eveo eee aay

A Se ree

j Nav 1D; MONA201054 Pe RUS
jaa | 7

hated A pe

© 2013 Toyota Motor Sales, USA
CP) TOYOTA T-SB-0026-12 Rev2 _—_ January 24, 2012 Page 4 of 5

Entune/Navigation Software Update Process for Display Audio (Non-HDD Type)

Software Update Procedure
1. Start the vehicle or put hybrid system in Ready ON mode.
2. Turn on the Radio.
3. Press the “Apps” button (the system will switch to the Apps main page).
4.

Install USB Drive into vehicle’s USB slot {there will be a short pause while the software version is
read).

5. An “Update software from X.X.X to 2.2.0?" Figure 4.
message will be displayed.

Update saftware from 2.1.0. to 2.2.0?

a

6. Press “Yes”.

7. A “Please do not interrupt the software update Figure 5.
once it has started. The engine must be
running during software update.” message will be

; Please do not interrupt the soft
displayed. pt the software update

once it has started. The engine must be

running during software update.

Confirm

— oS a

8. Press “Confirm” (the engine must be running or hybrid system in Ready ON mode during
software update).

9. The Software update will begin and the screen Figura &.
will show a “Package 7 of 8” message, and
continue through 8 of 8. It will take approximately
5 minutes for the update to complete.

© 2013 Toyota Motor Sales, USA
€PTOYOTA T-SB-0026-12 Rev2 January 24, 2012 Page 5 of 5

Entune/Navigation Software Update Process for Display Audio (Non-HDD Type)

Software Update Procedure (Continued)

10. When finished, a "Software update complete"
message is displayed.

11. Remove the USB Drive.
12. Turn the vehicle OFF.

13. Confirm the software version was updated
by performing the Software Version Check
Procedure.

Figure 7.

RUC Mh] (4 else
Remove the USB stick to activate tad

Br te

Figure 8.

System Information

Device ID / Product ID:

BT ike tel areal ||

Ema sari] Copy to ey

ow a

© 2013 Toyota Motor Sales, USA