T-SB-0023-13

February 8, 2013

C&P) TOYOTA

Floor Mat Installation During PDS

Service
Category General

Section Pre-Delivery Service

Market USA

Technical Service Bulletin

Toyota Supports
ASE Certification =>;

Applicability

YEAR(S)

MODEL(S) ADDITIONAL INFORMATION

2014

4Runner, Avalon,
Avalon HV, Camry,
Camry HV, Corolla, FJ
Cruiser, Highlander,
Highlander HV, Land
Cruiser, Prius, Prius
C, Prius PHV, Prius
V, RAV4, Sequoia,
Sienna, Tacoma,
Tundra, Venza, Yaris

Introduction

2014 model year vehicles are equipped with driver's side floor mat retaining clips to secure the floor
mat in the correct position. In addition, some models may utilize retaining clips for passenger side
and rear seat floor mats as well. Follow the appropriate installation procedure to attach the driver's
side, and if applicable, the passenger’s side and rear seat floor mats to the vehicle carpet using the
floor mat retaining clips during Pre-Delivery Service (PDS).

© 2013 Toyota Motor Sales, USA

Page 1 of 9

GPTOYOTA T-SB-0023-13 February 8, 2013 Page 2 of 9

Floor Mat Installation During PDS

Introduction (Continued)

CAUTION

Always verify the floor mat to assure it is designed specifically for the model and model year it
is being installed in.

ONLY use floor mats that can be retained using the retaining clips. All OEM Toyota floor mats
are specifically designed to fit correctly and be retained using the retaining clips.

Make sure the floor mat is properly placed on the vehicle carpet and secured with the retaining
clips. If the driver side floor mat is NOT properly placed and secured, it could slip and interfere

with the movement of the pedals during driving and may cause an accident.

Verify the operation of the accelerator, brake, and clutch {if equipped) pedals and clearance
to the mat.

NEVER install more than one floor mat at a time in the driver's seating position.

if applicable, any secondary set of floor mats (based upon customer preference, such as the
all weather floor mats or other floor mats) MUST be placed in the trunk with all the packaging
material intact. Do NOT install the secondary mat on top of the primary floor mat already
installed in the driver’s seating position.

Warranty Information

OP CODE DESCRIPTION TIME OFP uu | 12
N/A Not Applicable to Warranty S a -f-

© 2013 Toyota Motor Sales, USA.

QPTOYOTA T-SB-0023-13 February 8, 2013 Page 3 of 9

Floor Mat Installation During PDS

Installation Procedure: Hook Style

1. Verify that the driver, and if applicable, passenger side and rear seat, floor mats are for the
correct model and model year they are being installed in.

2. Attach the driver, and if applicable, passenger side and rear seat, floor mats to the vehicle
carpet using the retaining clips. Secure the mat by inserting the retaining clips through the
grommet holes. ;

Figure 1.

1 | Retaining Clips [ 3. [correct instattation ]
2 | Grommets

© 2013 Toyota Motor Sales, USA

TOYOTA T-SB-0023-13 February 8, 2013 Page 4 of 9

Floor Mat Installation During PDS

Installation Procedure: Hook Style (Continued)

3. Verify proper installation.

NOTE

If applicable, DO NOT remove the beige “Caution” tag from the floor mat. This should only be
removed by the customer.

Figure 2.

A Caution / Precaucién / Attention /_psda5 A

NOTICE: THIS TAG TO BE REMOVED BY CUSTOMER ONLY.
To aveid interference wath pedul operation:

+ Ewch mal must be secured with relention hooks (clipa}

= Da nat install a floor mat on tap of an existing ‘oor mat

AVISO: SOLAMENTE EL CLIENTE OEBE REMOVER ESTA ETIQUETA,
Para guitar irlerferencza con la operacdn dal pedal:

oO = Cage tapete debe sujetarse con seguros de ratencidn (proches)

= No instale wn tapate ce pisa encima ne un lnpele de piso oxisenie

REMARQUE : CETTE ETIQUETTE NE PEUT ErRe ENLEVEE QUE PAR LE CLIENT,
Pour éviler dus inter'érences avec |e lonchannement de lo

+ Chaque tapis coit dire fixé 4 Taide des crochels de ante (ogra'es)
+ Ninslaller pas un taps pardescus un taps déja an place

And Syaadt Sud Cpe Abus! 03a & 55 Gey slant}
Sepia he 5 fall OS by ye clea lis y Ue Gad
GAs Le SoS AY

Tewr-ooo1revt [1]

© 2013 Toyota Motor Sales, USA

TOYOTA T-SB-0023-13 February 8, 2013 Page § of 9

Floor Mat Installation During PDS

Installation Procedure: Hook Style with Locking Clip

1. Verify that the driver, and if applicable, passenger side and rear seat, floor mats are for the
correct model and model year they are being installed in.

2. Attach the retention clip to the floor by inserting the retention clip claws into the floor eyelet.

Figure 3.
O=>
1 | Retention Clip § | Cross-sectional Diagram
2 | Front of Vehicle A | Retention Clip Claw
3 | Retention Clip Eyelet on Vehicle Floor B | Locking Clip
4 Seat