2 27-14

1 227-14

@ DETROIT

Service Information Bulletin

SUBJECT DATE
SPN 4335/FMI 7 - EPA10 February 2014

Additions, Revisions, or Updates

Publication Number / Title | Platform _ Section Title Change
DDC-SVC-MAN-0084 | DD Platform SPN 4335/FMI 7 - EPA10 The diagnostics have reer ee Graphics have also

DETROIT

DEMAND PERFORMANCE”

oO)

13400 Outer Drive, West, Detroit, Michigan 48239-4001
Telephone: 313-592-5000
www.demanddetroit.com

All information subject to change without notice. . 3
227-14 Copyright © 2014 DETROIT DIESEL CORPORATION
2 SPN 4335/FMI 7 - EPALO

2

SPN 4335/FMI 7 - EPA10

This diagnostic is typically DEF Metering Unit Air Pressure - Low.

Table 1.
SPN 4335/FMl 7
Description Diesel Exhaust Fluid (DEF) Metering Unit Air Pressure Low
Monitored Parameter Diesel Exhaust Fluid (DEF) Metering Unit Air Pressure
Typical Enabling Conditions Engine rpm greater than 500, Dosing Enabled
Monitor Sequence None
Execution Frequency Continuous when enabling conditions met
Typical Duration 6 seconds
Dash Lamps MIL
Engine Reaction Derate 25%
Verification SCR Air Pressure Test (test duration is 60 seconds)

NOTE: If there is ol present i in the air system, the cause of the.oil intrusion: needs to be corrected: Refer to
section "Inspection of the Diesel Exhaust Fluid Compressed Ait Flow System after Air Compressor Failure’.

| WARNING:ENGINEEXHAUST =
To avoid injury from inhaling engine exhaust, always operate the engine ina wellventilated area.

- Engine exhaust is toxic.

A | WARNING: PERSONAL INJURY oe -
To avoid injury before starting and running the engine, ‘ensure the vehicle i is parked ona level

_—

ok &

surface, parking b brake! is S Set, and the: wheels are blocked.

. Start engine and ensure vehicle air pressure is above 689 kPa (100 psi). Go to step 2.

Does the air pressure in the secondary air system reach and maintain 689 kPa (100 psi)?
a. Yes; Go to step 3.
b. No; diagnose and repair the cause of the low air pressure. Refer to air compressor diagnostic literature.
Connect DiagnosticLink™ . Go to step 4.
Turn ignition ON (key ON, engine OFF). Go to step 5.
Visually inspect air supply lines from air tank to pressure limiting unit, DEF pump module and DEF metering unit for
leaks, kinks or damage. Is there any damage found?

a. Yes; repair as necessary. Verify repair.
b. No; Go to step 6.

. Compare DEF metering unit air pressure to barometric air pressure (Baro) and DEF pressure. Is the DEF metering unit

air pressure within 28 kPa (4 psi) of barometric air pressure (Baro) and DEF pressure?
a. Yes; Go to step 10.
b. No; Go to step 7.

. Remove the DEF metering unit air pressure sensor, Refer to section "Removal of the Diesel Exhaust Fluid Metering

Unit Air Pressure Sensor"and reconnect the electrical harness to the sensor. Go to step 8.

. Compare DEF metering unit air pressure to barometric air pressure (Baro) and DEF pressure. Is the DEF metering unit

air pressure within 28 kPa (4 psi) of barometric air pressure (Baro) and DEF pressure?

All information subject to change without notice.
Copyright © 2014 DETROIT DIESEL CORPORATION 2 27-14

227-14

a. Yes; reinstall the DEF metering unit air pressure sensor. Refer to section "Installation of the Diesel Exhaust Fluid
Metering Unit Air Pressure Sensor". Go to step 9.

b. No; replace the DEF metering unit air pressure sensor. Refer to section "Installation of the Diesel Exhaust Fluid
Metering Unit Air Pressure Sensor". Verify repair.

9. Turn ignition OFF. Go to step 10.
10. Remove and inspect fitting (1) and (2) from the pressure limiting unit. Is there any oil, rust or other contamination
present?

a. Yes; diagnose and repair the cause of the contamination. Refer to section "Inspection of the Diesel Exhaust Fluid
Compressed Air Flow System after Air Compressor Failure" and Technical Service Letter 12TS16REV http://
ddesn-ddc. freightliner.com/cps/rde/xber/ddcesn/12TS16REV pdf (http://ddcsn-ddc.freightliner.com/ cps/rde/xber/
ddesn/12TS16REV.pdf). Verify repair.

b. No; Go to step 11.

2 AY) Lo
C )

ae

d140313

11. Disconnect the quick-connect air supply line (1) to the DEF metering unit. Go to step 12.

All information subject to change without notice. 5
2 27-14 Copyright © 2014 DETROIT DIESEL CORPORATION
2 SPN 4335/FMI 7 - EPA10

d140462

12. Connect a suitable air gauge 0 to 1,379 kPa (0 to 200 psi) to the end of the DEF metering unit air supply line. Go to
step 13.
13. Turn the ignition ON (key ON, engine OFF). Go to step 14.

NOTE: The vehicle air pressure should be above 689 kPa (100 psi) before performing the SCR Air Pressure Test.

14. While monitoring the air pressure gauge, perform Selective Catalytic Reduction (SCR) Air Pressure Test; Refer to
section "Selective Catalyst Reduction Air Pressure System Check". Is the air pressure between 537 to 586 kPa (78 to 85
psi)?

a. Yes; Go to step 15.
b. No; replace the Pressure Limiting Unit (PLU). Refer to OEM diagnostics. Verify repair.

15. Remove the metering unit. Refer to section "Removal of the Diesel Exhaust Fluid Metering Unit" . Go to step 16.

16. Remove the DEF metering unit air supply line fitting and the DEF metering unit compressed air supply screen (2).
Refer to section "Removal of the Diesel Exhaust Fluid Metering Unit Compressed Air Supply Screen". Go to step 17.

6 All information subject to change without notice.
Copyright © 2014 DETROIT DIESEL CORPORATION 2 27-14
2 27-14

d140234

140441

NOTE: Oil contamination.can be easily identified by dabbing the air channel inlet elbow (1) on a clean paper
towel. If an oil ring (2) is noticed, the air inlet screen will be contaminated as well. If inlet screen is contaminated,

continue diagnostics and repair the contamination source before installation of new inlet screen.

17. Inspect the DEF metering unit compressed air supply screen for debris. Is there oil or rust on the air inlet screen?

a. Yes; diagnose and repair the cause of the contamination. Replace the air inlet screen. Refer to section "Inspection
of the Diesel Exhaust Fluid Compressed Air Flow System after Air Compressor Failure" and TS letter
12TS-16REV http://ddcesn-ddc.freightliner.com/cps/rde/xber/ddcesn/12TS16REV.pdf (http://ddesn-
ddc.treightliner.com/cps/rde/xbcr/ddesn/12TS16REV.pdf). Verify repair.

b. No; Go to step 18.

All information subject to change without notice.
227-14 Copyright © 2014 DETROIT DIESEL CORPORATION
2 SPN 4335/FMI 7 - EPA10

18. Remove the DEF metering unit air pressure sensor; Refer to section "Removal of the Diesel Exhaust Fluid Metering
Unit Air Pressure Sensor". Go to step 19.

19. Remove the three screws (1) from the bottom of the metering unit; remove the diffuser heater. Refer to section
"Removal of the Diesel Exhaust Fluid Metering Unit Diffuser Heater". Go to step 20.

d140307

20. Inspect the diffuser heater. See the following figure for an example of plugged and clear diffusers. Is the Diffuser
plugged or restricted by DEF crystals?

a. Yes; flush the diffuser heater (1) using warm running water for several minutes to dissolve the DEF crystals. Go
to step 21.

b. No; flush the DEF metering unit air passage with warm running water for several minutes to dissolve the DEF
crystals. Go to step 21.

All information subject to change without notice.
Copyright © 2014 DETROIT DIESEL CORPORATION 2 27-14
227-14

Table 2.

d140442 4140443 d140444

Diffuser Outlet — Plugged Diffuser Outlet — Restricted Diffuser Outlet — 100% Clear

d140445 140446 140447

Diffuser Inlet — Plugged Diffuser Inlet ~ Partial Restriction Diffuser Inlet — 100% Clear

d140369

All information subject to change without notice. 9
227-14 Copyright © 2014 DETROIT DIESEL CORPORATION
2 SPN 4335/FMI 7 - EPA1O

140368

di 40377

_. | WARNING: EYE INJURY a ee ee
_ To avoid injury from flying debris when using compressed air, wear adequate eye protection (face
- shield or safety. goggles) and do not exceed 276 kPa (40 psi) air pressure. nce)

21. After the blockage is cleared, blow out any remaining water in the sensor connection and install all removed
components.

10 All information subject to change without notice.
Copyright © 2014 DETROIT DIESEL CORPORATION 2 27-14
227-14

Refer to section "Installation of the Diesel Exhaust Fluid Metering Unit Diffuser Heater".
Refer to section "Installation of the Diesel Exhaust Fluid Metering Unit".
Refer to section "Installation of the Diesel Exhaust Fluid Metering Unit Air Pressure Sensor". Go to step 22.
22. Perform the SCR air pressure test. Does the SCR air pressure test pass?
a. Yes; release the vehicle.
b. No; Go to step 23.
23. Remove the DEF metering unit outlet pressure line from the DEF metering unit. Go to step 24.
24. Use a 1/4 inch metal flare cap to block off the outlet port of the DEF metering unit. Go to step 25.

25. Perform the SCR air pressure test. Does the air pressure reach 537 kPa (78 psi)?
a. Yes; replace the DEF nozzle in the ATS. Verify repair.
b. No; re-clean the DEF metering unit using warm water. Verify repair. Go to step 26.
26. Is fault code SPN 4335 FMI 7 still present?
a. Yes; replace the DEF air pressure sensor. Refer to section "Removal of the Diesel Exhaust Fluid Metering Unit

Air Pressure Sensor". Verify repair.
b. No; release the vehicle.

All information subject to change without notice. 11
227-14 Copyright © 2014 DETROIT DIESEL CORPORATION