PERFECT DELIVERY INSPECTION (PDI)

2015

Q7/Q7 TDI

Audi Technician Report

Stock No.

Dealer Number

R.O. No.

VIN

Road test mileage out

Road test mileage in

All items must be completed prior to customer delivery by an Audi
technician
**Refer to the Special functions tab of ODIS Diagnosis using GFF
for the PDI function tests
**Audi recommends using an Audi approved battery charger to
prevent excessive battery discharge during inspection
Open Campaigns/Updates
 Check Elsa for open campaigns and updates. Perform
campaigns not requiring SVM if applicable. Campaigns
requiring SVM should only be performed after the vehicle has
been taken out of transport mode
Battery Inspection
 Check battery clamps for proper torque. Re-torque if required
 Perform the A-battery test for new batteries using GFF in ODIS
Diagnosis –> Special functions –>Service work. Select option 2,
the battery test for new batteries as part of the pre–delivery
inspection and act according to the test result (ok, recharge,
replace). Ensure diagnosis log is uploaded to the GFF paperless
server by selecting “ok” when tester wants to send the current
generated diagnosis protocol online. (Note: Do not use Guided
Function. The diagnosis log will not be uploaded to GFF paperless)
Transport Mode Deactivation, DTC check, set service reminder
*It is advised to start ODIS with the engine running to enable all
5F Test Plans in GFF and also to ensure SVM sees all control units
during the SVM check vehicle configuration
 Deactivate vehicle transport mode (via Special functions –>
Service work –> 19-Transport mode activating/deactivating )
 Set service reminder (via Special functions –> Service work –>
17-PDI-resetting SRI at PDI, counter reset, etc.)
 For MMI3G+ vehicles, set adaptation channel (via Special
functions –> Service work –> : 5F–Activating/deactivating
storage of music). Also referred to as CD Ripping. Perform
hard reset of the MMI to complete the activation

Rear Compartment
 Verify inflatable spare tire and compressor are present
 Verify operation of retractable luggage cover
Exterior
 Test windshield washers for aim and function
 Turn on headlights and test headlamp washers
 Test exterior lighting functions, including that rear lighting
transfers between tailgate and bumper when tailgate is
operated
 Check key functionality, including seat memory (if applicable);
verify vehicle starts and runs with all keys; verify all doors lock/
unlock with remote and advanced key, including all door handle
sensors with the advanced key (if equipped)
 Install the cap for the hitch cover (the cap is located in the
cargo area)
 Adjust the trunk lid opening height to 75 inches (190 cm) from
the ground to the close button in the rear lid. Press and hold
the close button in the rear lid for at least four seconds to
program the opening height
Interior
 Check operation of all switches: Locks, windows, seat adjustment, and child safety features
 Calibrate rear view mirror compass to proper zone and check
self-dimming function/lighting
 Verify operation of all interior lights
 Mirrors: Inspect folding, adjustments, RH tilt in reverse, and
memory (if equipped)
 Inspect operation of power outlet(s) in center console, in rear
of center console, and in cargo area
 Check horn operation
 Verify the glove compartment opens and closes properly

 Perform an SVM specified /actual comparison (via Special
functions ->Software Version Management (SVM))

 Check panorama sunroof operation (open/close/vent/deflector
at edge) and sunshade operation (front and rear). Synchronize
if necessary

 Perform any campaign update requiring SVM at this time
(follow instructions listed in campaign documentation)

 Passenger side airbag: Verify operation of Passenger Occupant
Detection System

Under the Hood Inspection

Radio

 Check all fluid levels and top off if necessary

 Verify operation of CD player

 Remove the label stating AdBlue was completely filled at the
factory

 Verify operation of AMI

 Check engine oil level via the MMI – fill oil to the max level
when the vehicle is at operating temperature
Effective 4-28-2014-US
Version 1.0

 SD card slot: Insert SD card and test function (Test all SD card
slots as equipped)
 Verify HD Radio is turned “off” in Radio/Settings Menu
1 of 2

PERFECT DELIVERY INSPECTION (PDI)

2015 Q7/Q7 TDI | Audi Technician Report

Audi MMI/Navigation

On-Hoist Inspection (continued)

 Verify and set Language and Measurement Units in Setup Menu

 If a known “sold” unit, set to appropriate Normal Load Condition. See separate “2015 Normal Load Condition Tire Pressure
Table” posted on ServiceNet. If going to stock, set to maximum
recommended tire pressures listed on the B-pillar doorjamb,
and store tire pressure values in Car/System menu

 Set Time source setting to “GPS” and set Auto daylight savings
time to “on.” Change time zone appropriate to the dealer
location
 Navigation (if equipped): Set dealership location (for following
back to dealership during road test)
 Set the “Music volume while parking” to 6 lines (accessed via
MMI rear view camera display: Settings > Music volume while
parking)(applies to vehicles with park assist or rear view camera)
 Voice Activation (if equipped): Press the “Talk” button and
verify several commands

Road Test
 Check for squeaks, rattles and wind noise
 Verify operation of Audi parking system or Audi parking system
plus with rear view camera and top or corner view cameras (if
equipped)
 Verify engine performance and acceleration

Rear Seat Entertainment (RSE) (if equipped)

 Verify transmission operation

 Rear Seat Entertainment: Verify operation. Verify the wireless
headphones are present and the DVD units operate

 Check adaptive air suspension in all positions (if equipped)

Audi connect (if equipped) (USA ONLY)

 Test drive vehicle applying brakes at least 4 times at 20 mph
(35 km/h) to clean brake rotors. Check for abnormal noise/
vibration

 Verify Audi connect Information Packet is present including
Audi brochure, T-Mobile brochure, customer SIM card, T-Mobile
Terms & Conditions (T&C)(if applicable)
 Connect the dealer demo SIM card to the vehicle and make
sure the system fully connects to 2G or 3G (2G or 3G symbol
with Box surrounding it)(only applies if in a T-Mobile service
area)
 Enable Google Earth in the navigation settings and verify the
white Google Logo appears next to the 2G or 3G symbol
 Ensure the wireless network is turned on (TEL function button >
Settings Ctrl button > Wi-Fi settings > Wi-Fi active > select
“Visible”)
 Check Wi-Fi hotspot functionality is enabled and verify the
SSID is set to “AUDIXXXXX,” where XXXXX = the last five digits
of VIN that are automatically preset in the system

 Check steering/tire alignment

 Parking brake: Apply and verify hold and release
 Verify quality of radio reception in AM/FM/SAT bands
 Verify cruise control/ACC (if equipped) functions
 Verify Audi side assist functionality (if equipped)
 Climate control: Check all functions and ensure proper heating
and A/C cooling
 Seat heating/ventilation: Inspect for proper operation (if
equipped)
 Navigation function (if equipped): Activate NAV and follow
directions back to dealership
Post-Road Test Inspection
 Interrogate fault memory using the Scan Tool and print
Diagnostic Log

On-Hoist Inspection
 Check underside of vehicle for fluid leaks and loose
components
 Check steering, boots, brake system, hoses, wheels and tires
for damage

 Record final mileage on checklist and sign checklist
 Ensure the yellow tire pressure tag is installed on steering
wheel

 Remove suspension blocks (if installed)

If Vehicle is for Showroom Display/Inventory Storage or Demo Use

 Inspect wheel bolts for proper torque using torque wrench

 Install showroom charger to ensure battery remains charged at
all times

 Install wheel bolt covers and center caps as supplied

 Apply Inventory Maintenance Sticker
 Install standard wiper blades (if not already installed)

Technician
I certify that all operations have been completed and this vehicle has been prepared in accordance with Audi Procedures and
Quality Standards, and has met the standards for Perfect Delivery.
Last 8 of VIN
Effective 4-28-2014-US
Version 1.0

Technician Signature

Completion Date
2 of 2