Classification:

Reference:

EC13-014e

Date:

NTB13-097e

March 30, 2017

ALL MODEL YEAR 2012 AND NEWER NISSAN VEHICLES;
EVAP LEAK DTC P0442, P0455, P0456 INFORMATION
This bulletin has been amended. The bulletin now includes vehicles in production as of the date of
this update. No other changes have been made. Please discard all previous versions of this bulletin.

APPLIED VEHICLES:

All model year 2012 and newer Nissan vehicles
except LEAF and Titan XD with V8 diesel engine

SERVICE INFORMATION
Example
All model year 2012 and newer Nissan vehicles have a warning
indicator in the instrument area to alert the driver of a loose fuel
filler cap (see Figure 1 example).
Figure 1




If a vehicle displays a Loose Fuel Filler Cap warning light or message, the driver
should safely stop the vehicle and make sure the fuel filler cap is installed correctly.
Make sure the customer is informed of the proper fuel filler cap installation.
Customers should refer to their vehicle’s Owner’s Manual for specific details on the
“LOOSE FUEL CAP” warning system and fuel filler cap installation.

If a fuel filler cap is left loose for multiple trips, DTCs will be stored and the MIL will
illuminate.



If one or more of these EVAP leak DTCs are stored (P0442, P0455, P0456),
a loose fuel filler cap may be the cause.
If P0442, P0455, and/or P0456 is found stored, begin vehicle EVAP system
diagnosis using the FLOW CHART on the next page.
 A test drive is not part of the DTC confirmation or diagnostic procedures for
these DTCs.
 Test driving the vehicle for these DTCs will only waste time.
 The diagnostic procedure in this bulletin must be used for these DTCs for an
effective repair.
NOTE: Any parts replaced under warranty for repair of these DTCs are on automatic
parts return to NNA for inspection. Any part found to be functional will cause a
charge-back to the dealer.

Nissan Bulletins are intended for use by qualified technicians, not 'do-it-yourselfers'. Qualified technicians are
properly trained individuals who have the equipment, tools, safety instruction, and know-how to do a job
properly and safely. NOTE: If you believe that a described condition may apply to a particular vehicle, DO
NOT assume that it does. See your Nissan dealer to determine if this applies to your vehicle.
1/3

FLOW CHART
Connect CONSULT-III plus
(C-III plus) to the vehicle

Were any of the following DTCs
found stored:
No
• P0442
• P0455
• P0456

This bulletin
does not apply

Yes

NOTE: A “smoke” leak
detection machine may
be used. Follow the
manufacturer’s operating
instructions.

1. Confirm fuel filler cap is
secure
2. Connect Essential Tool
J-42909 to EVAP service
port
3. Using Active Test, close
vent control valve
4. Apply pressure using
J-42909 until bar graph
reaches about halfway
5. Monitor the bar graph for
10 minutes

Did bar graph remain stable?

•

NO EVAP LEAK
detected at this time

•

MIL ON due to fuel
filler cap not being
properly secured
(loose)

•

Erase DTC(s)

•

Advise customer fuel
filler cap ALWAYS
needs to be properly
secured

•

DO NOT REPLACE
FUEL FILLER CAP
OR ANY OTHER
EVAP RELATED
PARTS

•

See CLAIMS
INFORMATION
on page 3

Yes

No

EVAP leak detected
This bulletin does not apply
Refer to ASIST and the
applicable Service Manual for
further diagnosis
2/3

NTB13-097e

EVAP System Operation


Fuel vapor flows from fuel tank into canister (light blue area)



Vapor flows from canister through purge control valve (red line)



Fresh air flows into canister (green line)

Figure 2

CLAIMS INFORMATION
Submit a Primary Part (PP) type line claim using the following claims coding:
DESCRIPTION
PFP
OP CODE SYM DIA FRT
EVAP System Leak Test

(1)

FX47AA

ZE

32

0.4

(1) Refer to the electronic parts catalog (FAST or equivalent) and use the Fuel Cap
part number (17251-xxxxx) as the primary failed part.

3/3

NTB13-097e