SB-16-17-008

R1

Tesla Motors, Inc.

June 10, 2016

Service Bulletin

Replace Key Batteries and Update Key Firmware
Classification

Campaign Bulletin

Section/Group

17 - Electrical

Country/Region

United States

Year

2016

Model

Model X

Version

All

Bulletin Classification: This campaign bulletin addresses a known non-safety-related condition and provides
recommended technical diagnosis and repair procedures. Apply this procedure to all vehicles in the affected VIN range
listed. These instructions assume knowledge of motor vehicle and high voltage electrical component repairs, and should
only be executed by trained professionals. Tesla Motors assumes no liability for injury or property damage due to a failure
to properly follow these instructions or repairs attempted by unqualified individuals.
This Service Bulletin supersedes SB-16-17-008, dated 3-Jun-16. Each content change is marked by a vertical line in the
left margin. Discard the previous version and replace it with this one.

Condition
An early version of key firmware might have caused the key battery to drain more quickly than normal.

Correction
Replace the key batteries and update the firmware on the keys.

Correction Description

Correction

Time

Replace 1 Key Battery And Update Key Firmware

S011617008

0.2

Replace 2 Key Batteries And Update Key Firmware

S021617008

0.3

Required Part(s): Part Number
1061712-00-A

Description
MODEL X KEY FOB BATTERY CR2354

Quantity
2

These part numbers were current at the time of publication. Use the revisions listed or later,
unless otherwise specified in the Parts Manual.
Special Tool(s):

1082355-00-A
1086799-00-A

MX BLE DONGLE
KEY FOB TOOL

Procedure
1. Replace both key batteries.
2. Install the Bluetooth low energy (BLE) drivers onto a laptop. Refer to Toolbox article 26985.

SB-16-17-008

Page 1 of 10

NOTE: If the following panels or options are unavailable, use Toolbox version Service Beta.
3. Connect the laptop to the vehicle.
4. Insert the BLE dongle into the laptop’s USB port (Figure 1).

Figure 1
NOTE: The keys interact with Toolbox via Bluetooth. Ensure that both keys are within a few feet of the BLE dongle.
5. In Toolbox, navigate to the Model X Keys Diagnostics panel.

SB-16-17-008

Page 2 of 10

6. In the “BCCEN Info” field, click the Refresh icon (Figure 2).

Figure 2
7. Press the brake pedal to turn the vehicle on.
NOTE: The vehicle must be on for the remainder of this procedure.

SB-16-17-008

Page 3 of 10

8. Click the Enable Key Fob Discovery checkbox (Figure 3).
NOTE: It might take up to 30 seconds for Toolbox to recognize the keys.

Figure 3

SB-16-17-008

Page 4 of 10

9. Right click the first key and select Connect To Device (Figure 4).

Figure 4

SB-16-17-008

Page 5 of 10

10. Right click the key and select Refresh Data (Figure 5).
NOTE: Information about the keys is displayed under “Key Fob Info” once Toolbox has established a connection with the
keys.

Figure 5
11. Click outside of the “Key Fob Info” section to deselect the key.

SB-16-17-008

Page 6 of 10

12. Check the color displayed below “Key App Version”:
•
•

If the color is green, skip to step 17.
If the color is red (Figure 6), continue to the next step.

Figure 6
13. Right click the key and select Verify Provisioning.
14. Right click the key and select Update Key App.

SB-16-17-008

Page 7 of 10

15. Right click the key and select Refresh Data (Figure 7).

Figure 7
16. Click outside of the “Key Fob Info” section to deselect the key.
NOTE: Ensure that the color displayed under “Key App Version” is green. If the color is still red, perform steps 13-16
again. Escalate a Toolbox session, as appropriate, if the color is still red after a second attempt.

SB-16-17-008

Page 8 of 10

17. Ensure that the key displays “Paired” in the “Security State” field (Figure 8).
NOTE: If the key does not display “Paired”, right click and select Pair Keyfob to BCCEN (Figure 9).

Figure 8

Figure 9

SB-16-17-008

Page 9 of 10

18. Perform steps 9-17 on the 2nd key, if available.
19. In the “BCCEN Info” field, click the Refresh icon (Figure 10).
NOTE: Ensure that the “BCCEN Info” section displays information for both keys. If the keys are not recognized, escalate a
Toolbox session, as appropriate.

Figure 10
20. Verify proper operation of both keys.
21. Disconnect the BLE dongle from the laptop.
22. Disconnect the laptop from the vehicle.

Affected VIN(s)

Affected keys that were delivered with Model X vehicles built before approximately May 20,
2016.
NOTE: This is a simplified summary of the affected VIN list. Refer to the VIN/Bulletin Tracker or
Customer/Vehicle profile to determine applicability of this bulletin for a particular vehicle.

For feedback on the accuracy of this document, email ServiceBulletinFeedback@tesla.com.

SB-16-17-008

Page 10 of 10