PERFECT DELIVERY INSPECTION (PDI)

2014

Q5/Q5 hybrid/SQ5/Q5 TDI

Audi Technician
Report

Stock No.

Dealer Number

R.O. No.

VIN

Road test mileage out

Road test mileage in

All items must be completed prior to customer delivery by an Audi
technician (for Audi Q5 hybrid, only “Hybrid Aware” techs are able
to PDI the hybrid)
*Refer to the Special functions tab of ODIS Diagnosis using GFF
for the PDI function tests

Trunk Inspection
FF     Install wheel bolt cover removal tool from PDI kit and wheel
lock key (if applicable) into trunk tool kit behind spare tire.
Please note that in the hybrid it is located on the luggage
floor on the right side

**Audi recommends using an Audi approved battery charger to
prevent excessive battery discharge during inspection

FF     Verify operation of luggage cover

Open Campaigns/Updates

Exterior

FF     Check Elsa for open campaigns and updates. Perform
campaigns not requiring SVM if applicable.Campaigns
requiring SVM should only be performed after the vehicle has
been taken out of transport mode.

FF     Test windshield washers (front and rear) for aim and function

Battery Inspection
FF     Check battery clamps for proper torque. Re-torque if required
FF     Perform the A-battery test for new batteries using GFF in ODIS
Diagnosis –> Special functions –>Service work. Select option 2, the
battery test for new batteries as part of the pre–delivery
inspection and act according to the test result (ok, recharge,
replace). Ensure diagnosis log is uploaded to the GFF paperless
server by selecting “ok” when tester wants to send the current
generated diagnosis protocol online. (Note: Do not use Guided
Function. The diagnosis log will not be uploaded to GFF paperless)

FF     Turn on headlights and test headlamp washers (if equipped)
FF     Test exterior lighting functions
FF     Install the rubber strips to the top of the base carrier bars (do
not install the carrier bars on the vehicle unless customer has
requested). Repackage the bars into the box if they are not
being installed on the vehicle
FF     Retrieve the paper with the torque wrench key code from the
base carrier bar box. Insert the paper with the key code into the
owner’s literature wallet. Record torque wrench key code in the
VDF to ensure it’s documented in the event the paper with the
code is misplaced
FF     Check key functionality, including seat memory (if equipped);
verify vehicle starts and runs with the start/stop button; verify
all doors lock/unlock with remote and advanced key, including
all door handle sensors with the advanced key (if equipped)

Transport Mode Deactivation, DTC check, set service reminder
FF     Deactivate vehicle transport mode (via Special functions –>
Service work –> 19-Transport mode activating/deactivating )
FF     Set service reminder (via Special functions –> Service work –>
17-PDI-resetting SRI at PDI, counter reset, etc.)
FF     For MMI3G+ vehicles, set adaptation channel (via Special
functions –> Service work –> : 5F–Activating/deactivating
storage of music)
FF     Perform an SVM specified /actual comparison (via Special
functions ->Software Version Management (SVM))
FF     Perform any campaign update requiring SVM at this time
(follow instructions listed in campaign documentation)
Under the Hood Fluid Check and Inspection
FF     Check all fluid levels and top off if necessary
FF     Check engine oil level using Special Tool T40178 on a flat and
level surface

Effective 10-1-2013
Version 1.0

Interior
FF     Check operation of all switches: Locks, windows, seat adjustment, seat heating (if equipped) and child safety features
FF     Calibrate rear view mirror compass to proper zone and check
self-dimming function/lighting (if equipped)
FF     Verify operation of all interior lights
FF     Mirrors: Inspect folding, adjustments, RH tilt in reverse, and
memory (if equipped)
FF     Inspect operation of lighter, aux. outlet under armrest, and
rear outlet and cargo area (if equipped)
FF     Verify operation of all front and rear seat belts and latches
FF     Check horn operation
FF     Check sunroof and sunshade operation (open/close/vent/
deflector at edge)
FF     Passenger side airbag: Verify operation of Passenger Occupant
Detection System

1 of 3

PERFECT DELIVERY INSPECTION (PDI)

2014 Q5/Q5 hybrid/SQ5/Q5 TDI | Audi Technician Report

Stock No.

Dealer Number

R.O. No.

VIN

Road test mileage out

Road test mileage in

Interior (continued)

On-Hoist Inspection

FF     Start-Stop-System info (if applicable): Verify the velum sticker
is on the start/stop button. Remove the Start-Stop-System
information card from the car kit and place it in the glove box
with the owner’s manuals. Additional supply can be ordered via
the Brand Store on AccessAudi

FF     Check underside of vehicle for fluid leaks and loose components
FF     Check steering, boots, brake system, hoses, tires and wheels
for damage
FF     Remove transport suspension blocks (if installed)
FF     Inspect wheel bolts for proper torque using torque wrench

Radio

FF     Install wheel bolt covers and center caps as supplied

FF     Verify operation of CD player
FF     Verify operation of AMI or aux. input (if equipped)

Road Test

FF     SD card slot: Insert SD card and test function (Test all SD card
slots as equipped)

FF     Check for squeaks, rattles and wind noise

FF     Verify HD Radio is turned “off” in Radio/Settings Menu
(USA ONLY)
Audi MMI/Navigation
FF     Verify and set Language and Measurement Units in Setup Menu
FF     Set Time source setting to “GPS” and set Auto daylight savings
time to “on.” Change time zone appropriate to the dealer
location
FF     Navigation (if equipped): Set dealership location (for following
back to dealership during road test)
FF     Set the “Music volume while parking” to 6 lines (accessed via
MMI rear view camera display: Settings > Music volume while
parking) (applies to vehicles with park assist or rear view
camera)
FF     Voice Activation (if equipped): Press the “Talk” button and
verify several Commands
Audi connect (if equipped) (USA ONLY)
FF     Verify Audi connect Information Packet is present, including
Audi brochure, T-Mobile brochure, customer SIM card, T-Mobile
Terms & Conditions (T&C) (if applicable)
FF     Connect the dealer demo SIM card to the vehicle and make
sure the system fully connects to 2G or 3G (2G or 3G symbol
with Box surrounding it)(only applies if in a T-Mobile service
area)
FF     Enable Google Earth in the navigation settings and verify the
white Google Logo appears next to the 2G or 3G symbol
FF     Ensure the wireless network is turned on (TEL function button
> Settings Ctrl button > Wi-Fi settings > Wi-Fi active > select
“Visible”)
FF     Check Wi-Fi hotspot functionality is enabled and verify the
SSID is set to “AUDIXXXXX,” where XXXXX = the last five digits
of VIN that are automatically preset in the system.
Effective 10-1-2013
Version 1.0

FF     Verify operation of Audi parking system plus with rear view
camera (if equipped)
FF     Verify engine performance and acceleration
FF     EV button: Push the EV button at a speed below 65 mph and
check for lights on EV button and instrument cluster. EV mode
may or may not activate based on current operational criteria
as described in the owner’s manual
FF     Check MMI and instrument cluster for proper operation mode
indication (green lights while EV or electrical drive, orange
while combustion engine active, etc.)
FF     Check for state of charging increasing while braking within
recuperation range (see power meter for details)
FF     Verify transmission operation, including shift paddles (if
equipped)
FF     Check steering/tire alignment
FF     Test drive vehicle applying brakes several times (at least 4
times) at 20 mph (32 km/h) to clean brake rotors. Check for
abnormal noise/vibration/pulsation
FF     Parking brake: Apply and verify hold and release
FF     Verify quality of radio reception in AM/FM/SAT bands
FF     Verify cruise control/ACC (if equipped) functions
FF     Verify Audi side assist functionality (if equipped)
FF     Climate control: Check all functions and ensure proper A/C
cooling
FF     Seat heating/ventilation (if equipped): Inspect for proper
operation
FF     Navigation function (if equipped): Activate NAV and follow
directions back to dealership
Post-Road Test Inspection
FF     Interrogate fault memory using the Scan Tool and print
Diagnostic Log
FF     Record final mileage on checklist and sign checklist
2 of 3

PERFECT DELIVERY INSPECTION (PDI)

2014 Q5/Q5 hybrid/SQ5/Q5 TDI | Audi Technician Report

Stock No.

Dealer Number

R.O. No.

VIN

Road test mileage out

Road test mileage in

Post-Road Test Inspection (continued)
FF     Ensure the yellow tire pressure tag is installed on steering
wheel
Showroom Display/Inventory Storage/Demo Vehicle
FF     Install showroom charger to ensure battery remains charged at
all times
FF     Apply Inventory Maintenance Sticker
FF     Install standard wiper blades (if not already installed)

Technician
I certify that all operations have been completed and this vehicle has been prepared in accordance with Audi Procedures and
Quality Standards, and has met the standards for Perfect Delivery.
Technician Signature

Effective 10-1-2013
Version 1.0

Completion Date

3 of 3