PERFECT DELIVERY INSPECTION (PDI)

2014

A4/S4/allroad

Audi Technician Report

Stock No.

Dealer Number

R.O. No.

VIN

Road test mileage out

Road test mileage in

All items must be completed prior to customer delivery by an Audi
technician
**Refer to the Special functions tab of ODIS Diagnosis using GFF
for the PDI function tests
**Audi recommends using an Audi approved battery charger to
prevent excessive battery discharge during inspection

Trunk Inspection
FF     Install wheel bolt cover removal tool from PDI kit and wheel
lock key (if applicable) into trunk tool kit behind right side
cover
FF     Set spare tire pressure
FF     Verify operation of trunk emergency release handle (if equipped

Open Campaigns/Updates
FF     Check Elsa for open campaigns and updates. Perform
campaigns not requiring SVM if applicable. Campaigns
requiring SVM should only be performed after the vehicle has
been taken out of transport mode.
Battery Inspection
FF     Check battery clamps for proper torque. Re-torque if required
FF     Perform the A-battery test for new batteries using GFF in ODIS
Diagnosis –> Special functions –> Service work. Select option
2, the battery test for new batteries as part of the pre–delivery
inspection and act according to the test result (ok, recharge,
replace). Ensure diagnosis log is uploaded to the GFF paperless
server by selecting “ok” when tester wants to send the current
generated diagnosis protocol online. (Note: Do not use Guided
Function. The diagnosis log will not be uploaded to GFF paperless)
Transport Mode Deactivation, DTC check, set service reminder
FF     Deactivate vehicle transport mode (via Special functions –>
Service work –> 19-Transport mode activating/deactivating )
FF     Set service reminder (via Special functions –> Service work –>
17-PDI-resetting SRI at PDI, counter reset, etc.)
FF     For MMI3G+ vehicles, set adaptation channel (via Special
functions –> Service work –> : 5F–Activating/deactivating
storage of music)
FF     Perform an SVM specified /actual comparison (via Special
functions ->Software Version Management (SVM))
FF     Perform any campaign update requiring SVM at this time
(follow instructions listed in campaign documentation)

Exterior
FF     Test windshield washers and headlight washers (if equipped)
for aim and function
FF     Test exterior lighting functions
FF     Check key functionality including seat memory (if applicable),
verify vehicle starts and runs with the start/stop button, verify
all doors lock/unlock with remote and Advanced Key, including
door handle sensors (if equipped)
FF     Verify power rear lid/tailgate (allroad) is operational
Interior
FF     Check operation of all switches: locks, windows, seat adjustment, power rear sunshade (if equipped) and child safety
features
FF     Calibrate rear view mirror compass to proper zone and check
self-dimming function/lighting (if equipped)
FF     Verify operation of all interior lights
FF     Mirrors: Inspect folding, adjustments, RH tilt in reverse, and
memory (if equipped)
FF     Inspect operation of lighter, aux. outlet under armrest and rear
outlet
FF     Verify operation of all front and rear seat belts and latches
FF     Check horn operation
FF     Check sunroof operation (open/close/vent/deflector at edge)
FF     Passenger side airbag: Verify operation of Passenger Occupant
Detection System
Radio

Under the Hood Fluid Check and Inspection

FF     Verify operation of CD player

FF     Check all fluid levels and top off if necessary

FF     Verify operation of AMI or aux. input (if equipped)

FF     Check engine oil level using Special Tool T40178 on a flat and
level surface

FF     SD card slot: Insert SD card and test function (Test all SD card
slots as equipped)
FF     Verify HD Radio is turned “off” in Radio/Settings Menu
(USA ONLY)

Effective 10-1-2013
Version 1.0

1 of 2

PERFECT DELIVERY INSPECTION (PDI)

2014 A4/S4/allroad | Audi Technician Report

Stock No.

Dealer Number

R.O. No.

VIN

Road test mileage out

Road test mileage in

Audi MMI/Navigation

Road Test

FF     Verify and set Language and Measurement Units in Setup/
Settings menu

FF     Check for squeaks, rattles and wind noise
FF     Verify engine performance and acceleration

FF     Set Time source setting to “GPS” and set Auto daylight savings
time to “on.” Change time zone appropriate to the dealer
location

FF     Verify operation of rear view camera and rear parking sensors
(if equipped)

FF     Navigation location: Set dealership location (for following back
to dealership during road test)

FF     Verify Audi active lane assist functionality (if equipped)

FF     Set the “Music volume while parking” to 6 lines (accessed via
MMI rear view camera display:
Settings > Music volume while parking)(applies to vehicles with
park assist or rear view camera)
FF     Voice Activation (if equipped): Press the “Talk” button and
verify several commands

FF     Verify Audi side assist functionality (if equipped)
FF     Verify transmission operation, including shift paddles (if
equipped)
FF     Check steering/tire alignment
FF     Test drive vehicle, applying brakes at least 4 times at 20 mph
(35 km/h) to clean brake rotors Check for abnormal noise/
vibration/pulsation
FF     Parking brake: Apply and verify hold and release

Audi connect (if equipped) (USA ONLY)

FF     Verify quality of radio reception in AM/FM/SAT bands

FF     Verify Audi connect Information Packet is present, including
Audi brochure, T-Mobile brochure, customer SIM card, T-Mobile
Terms & Conditions (T&C)(if applicable)

FF     Verify cruise control/ACC (if equipped)

FF     Connect the dealer demo SIM card to the vehicle and make
sure the system fully connects to 2G or 3G (2G or 3G symbol
with arrows)(only applies if in a T-Mobile service area)

FF     Climate control: Check all functions and ensure proper A/C
cooling

FF     Enable Google Earth in the navigation settings and verify the
white Google Logo appears next to the 2G or 3G symbol
FF     Ensure the wireless network is turned on (TEL function button
> Settings Ctrl button > Wi-Fi settings > Wi-Fi active > select
“Visible”)
FF     Check Wi-Fi hotspot functionality is enabled and verify the
SSID is set to “AUDIXXXXX,” where XXXXX = the last five digits
of VIN that are automatically preset in the system.
On-Hoist Inspection
FF     Check underside of vehicle for fluid leaks and loose components
FF     Check steering, boots, brake system, hoses, tires and wheels
for damage
FF     Remove transport suspension blocks (if installed)
FF     Inspect wheel bolts for proper torque using torque wrench

FF     Seat heating (if equipped): Inspect for proper operation

FF     Navigation function (if equipped): Activate NAV and follow
directions back to dealership
Post-Road Test Inspection
FF     Interrogate fault memory using the Scan Tool and print
Diagnostic Log
FF     Record final mileage on checklist and sign checklist
FF     Ensure the yellow tire pressure tag is installed on steering
wheel
Showroom Display/Inventory Storage/Demo Vehicle
FF     Install showroom charger to ensure battery remains charged at
all times
FF     Apply Inventory Maintenance Sticker
FF     Install standard wiper blades (if not already installed)

FF     Install wheel bolt covers and center caps as supplied

Technician
I certify that all operations have been completed and this vehicle has been prepared in accordance with Audi Procedures and
Quality Standards, and has met the standards for Perfect Delivery.
Technician Signature
Effective 10-1-2013
Version 1.0

Completion Date

2 of 2