Page 1 of 2

TECHNICAL BULLETIN
LTB00647NAS2
15 MAY 2014
© Jaguar Land Rover North America, LLC
NOTE: The information in Technical Bulletins is intended for use by trained, professional Technicians with the knowledge, tools,
and equipment required to do the job properly and safely. It informs these Technicians of conditions that may occur on some
vehicles, or provides information that could assist in proper vehicle service. The procedures should not be performed by 'do-ityourselfers'. If you are not a Retailer, do not assume that a condition described affects your vehicle. Contact an authorized Land
Rover service facility to determine whether this bulletin applies to a specific vehicle.

This reissue replaces all previous versions. Please destroy all previous versions. Only refer to the
electronic version of this Technical Bulletin in TOPIx.
Changes are highlighted in gray

SECTION: 414-00

Battery Charge Warning Indicator Illuminated
AFFECTED VEHICLE RANGE:
Range Rover Evoque (LV)
Model Year:
2014
VIN:
EH856580-EH881720

MARKETS:
NAS

CONDITION SUMMARY:
Situation: The battery charge warning indicator may be illuminated and a battery warning message displayed on
the Instrument Cluster. Diagnostic Trouble Code (DTC) B1404-13 may be stored.
Cause: This may be caused by an error in the battery diagnostic routines.
Action: Should a customer express this concern, follow the Service Instruction outlined below.

PARTS:
No Parts Required

TOOLS:

NOTE: This is an 'Active Bulletin' that will display a functional programming shortcut if accessed
within a diagnostic session using SDD.

SDD with latest DVD and Calibration File; first available on DVD137.03 v.166
Jaguar Land Rover-approved Midtronics battery power supply

WARRANTY:
NOTE: Repair procedures are under constant review, and therefore times are subject to change;
those quoted here must be taken as guidance only. Always refer to TOPIx to obtain the latest repair
time.
NOTE: DDW requires the use of causal part numbers. Labor only claims must show the causal part
number with a quantity of zero.
DESCRIPTION

SRO

TIME (HOURS)

CONDITION CODE

CAUSAL PART

Update GateWay Module software

86.90.97

0.20

42

LR059957

NOTE: Normal Warranty policies and procedures apply.

http://topix.landrover.jlrint.com/topix/service/document/477223

6/3/2014

Page 2 of 2

SERVICE INSTRUCTION:

CAUTION: A Jaguar Land Rover-approved Midtronics battery power supply must be connected to the
vehicle battery during SDD diagnosis / module programming.

CAUTION: Ensure all ignition 'ON' / ignition 'OFF' requests are carried out; failure to perform these
steps may cause damage to control modules in the vehicle.

NOTE: SDD must be loaded with DVD137.03 v.166 or later.

1. Connect the Jaguar Land Rover-approved Midtronics battery power supply to the vehicle battery.
2. Turn ignition 'ON' (engine not running).
3. Connect the Symptom Driven Diagnostics (SDD) system to the vehicle and begin a new session.
4. Follow the on-screen prompts, allowing SDD to read the VIN and identify the vehicle and initiating the data
collect sequence.
5. Select 'Diagnosis' from the Session Type screen.
6. Select the 'Selected Symptoms' tab, and then select:
Electrical - Instruments - Warning lamps - Battery and alternator lamp - Lamp illuminated

7. Select 'continue'.
8. Select the 'Recommendations' tab, and then select 'Run' to perform the 'Configure existing module – Gateway
module' option.
9. Follow all on-screen instructions to complete this task.
10. Exit the current session.
11. Disconnect the SDD and the battery power supply from the vehicle.

http://topix.landrover.jlrint.com/topix/service/document/477223

6/3/2014