NUMBER

GROUP

(!@ HVU na R 11

nEW THlnKlnG .
nEW POSSIBILITIES.

Technical Service Bulletin

12-FL-010

FUEL SYSTEM

MODELS

DATE
DECEMBER 2012

VELOSTER (FS)
ACCENT (RB)

ECM UPDATE - MIL ON OTC P2192

SUBJECT

Description:
This bulletin provides information related to the ECM software update of some 1.6L vehicles that
may experience the following OTC:
-

P2192 : System too Rich at Higher Load(Bank1)

NOTE: There are no vehicle performance issues associated with this condition .
Applicable Vehicles:
• 2012-2013 MY VELOSTER (FS) with 1.6L GDI Engine and OCT.
• 2012-2013MY ACCENT (RB) with 1.6L GDI Engine and A/T.
GOS Information:
EVENT#

DESCRIPTION

294 (or later compatible event)*

295 (or later compatible event)*

"RB 1.6 AT P0456/0461/2192 OTC LOGIC
IMPROVEMENT"
"FS 1.6 OCT P0456/0461/2192 OTC LOGIC
IMPROVEMENT"

(*the latest event that shows up in the Engine Auto Mode event list for the particular vehicle/engine)

* IMPORTANT:
Veloster OCT Vehicles - Reset operation after ECU Update required :
• After ECU Update there is a prompt to turn OFF ignition for 30 seconds then back ON.
• This is required to reset the OCT and if not done the OCT may become inoperative.
Warranty Information:
Model

Op Code

Operation

Op Time

Causal P/N

Nature

Cause

ACCENT(RB),
VELOSTER(FS)
1.6L

39110F7V

ECM UPGRADE

0.3

(See NOTE)

N69

C40

NOTE: Use the applicable ECM P/N listed in the ROM ID Information Table from the following page.

Circulate To: Service Manager, Warranty Manager, Service Advisors, Technicians , Fleet Repair

ECM UPDATE - MIL ON OTC P2192

SUBJECT:

ROM ID INFORMATION TABLE:
Verify the ECM ROM ID before updating the vehicle's software. Refer to the table below.

.

.. ;~~r:t"'1 •

Model

Model
Year

... _q
-~

L ,-~

~

&

~

~.t:

. ·r~~

ECM P/N

...

~ '
i .

.,~

,,...

T/M

..,;

'i

~

Model
Year

~

ECM P/N

'' T/M

~

2012MY

Veloster
FS
1.6
GDI

J.,

i

1

I•

Yes

TSB #: 12-FL-010

GGRB-DNU6PS04COO

. ' 1i~. f,..
i.l

1,,,, ,,

.

•'

ROMID

,I
.

I

I

GGFS-BFU6FSOOHOO
GGFS-BFU6FS01 HOO
GGFS-BFU6FS02HOO
GGFS-BFU6FS03HOO
GGFS-BFU6FS04HOO
GGFS-8FU6FS05HOO
GGFS-BFU6FS06HOO
GGFS-BFU6FFOOHOO

New

.,

I

...

:

-

GGFS-DFUGFS03HOO

GGFS-DFU6FSOOHOO
GGFS-DFU6FS01 HOO
GGFS-DFU6FS02HOO

3911028887

391102BBC7
(13MY)

.
New

Previous

No
(Key
Start)

2013MY

ROMID

"'

391102BBHO

391102BBH3

'

IMMO

'

DCT

2012MY

I

GGRB-DNU6PSOOCOO
GGRB-DNU6PS01COO
GGRB-DNU6PS02COO
GGRB-DNU6PS03COO

(Push
Button
Start)
2013MY

r

Previous

I

:

.f '.

1

1-

GGRB-ANU6PSOOCOO
GGRB-ANU6PS01 COO
GGR8-ANU6PS02COO
GGR8-ANU6PS03COO
GGRB-ANU6PS04COO
GG RB-ANU6PSOOCOA
GGRB-ANU6PS01 CAO
GG R8-ANU6PS02CAO
GGRB-DNU6PS02COO

39110-28AS1

\ t'.

.

-.

~...,.

'I

AT

2013MY

..

'•

'

~

1.6
GDI

Model

..

'

39110-2BAD5
39110-2BAD7

2012MY

Accent
RB

lrf •

GGFS-BFU6ESOOHOO
GGFS-BFU6ES01 HOO
GGFS-BFU6ES02HOO
GGFS-BFU6ES03HOO
GGFS-BFU6ES04HOO
GGFS-8FU6ES05HOO
GGFS-8FU6ES06HOO
GGFS-BFUGEFOOHOO

GGFSDFUGES03HOO

GGFS-DFU6ESOOHOO
GGFS-DFU6ES01HOO
GGFS-DFU6ES02HOO

Page 2 of 5

ECM UPDATE- MIL ON OTC P2192
GENERAL PRECAUTIONS:
•

Connect the USB cable between the GOS and
the VCI.
Connect the 16-pin DLC connector from the VCI
into the DLC located under the driver's side dash .

•

*NOTE
Make sure the battery icon at the bottom right of the GOS laptop shows at least 50%; if not,
charge the GOS or attach a battery charger.
•

Turn off all lights (Do not leave the headlight switch in auto mode) and all accessories (including
heater/air conditioner/fan, audio, heated seats, rear defroster, etc) to ensure the battery will not
be discharged during the update.

•

Perform the update with the ignition key in the ON position.

•

Do not disconnect any cables connected to the vehicle or the GOS during the update.

•

Do not start the engine or turn the ignition switch OFF during the update.

*NOTE
Confirm your GOS has the most recent version. If not, connect the GOS to an Internet port, open
the GOS home page and select "Update". Refer to instructions on hmaservice.com if necessary.
If you encounter GOS related problems, call the GIT Helpline at 888-437-0308.

TSB #: 12-FL-010

Page 3 of 5

ECM UPDATE - MIL ON OTC P2192

SUBJECT:

SERVICE PROCEDURE:
GOS AUTO MODE ECM UPDATE PROCEDURE
1. From the GOS home page, select ECU Upgrade. If necessary, select the VIN .
2. Select Engine as the system and then select OK.
3. Select Auto Mode and then select Next.
4

From the System tab , select Engine and then select OK. The GOS will read the ROM ID.
Confirm the ROM is applicable as shown on Page 1, "ROM ID Information".

~· GOS ~

•

5 Select update event as listed on the GOS Event list of page-1. Select Upgrade.
)

Prepararlon

I

4ATAll'FY20CY.llG1 .J QGI£

•Mode
• L•te s lR Of.tlO

; System
U«''