GROUP

MODEL

BOD

2006-2014MY
Sedona (VQ)

NUMBER

DATE

107

August 2014

TECHNICAL SERVICE BULLETIN
SUBJECT:

COMBINED TSB/SERVICE ACTION: FRONT DOOR GLASS
RUN CHANNEL REPLACEMENT (SA 167)

This bulletin provides information on some Sedona (VQ) vehicles, produced from June 15, 2005 through
May 06, 2013, which may experience wind noise coming from the front door window/door frame area, at
highway speeds, and/or glass run channel deformation caused by improper sealing of the front windows.
To correct this concern , follow the procedure outlined in this bulletin to replace the left and right side front
door glass run channels. See the table below to properly identify the left and right hand run channels.
For vehicles not on the Affected Vehicles list, but with a customer concern as described above, perform
the following procedure outlined in this bulletin and submit a warranty claim per "customer concern"
(Standard TSB) claim information on page 5.
Left Hand (LH)
(P/N 82530 40001 QQK)

Right Hand (RH)
(P/N 82540 4D001QQK)

*NOTICE
Vehicles previously repaired using the service procedure and parts as outlined in TSB BOD
101 do not require any repairs under this TSB.

*NOTICE
A Service Action is a repair program without customer notification that is performed during
the warranty period. Any dealer requesting to perform this repair outside the warranty
period will require DPSM approval.
Repair status for a VIN is provided on WebDCS (Service> Warranty Coverage> Warranty
Coverage Inquiry> Campaign Information). Not completed Recall I Service Action reports
are available on WebDCS (Consumer Affairs> Not Completed Recall> Recall VIN> Select
Report), which includes a list of affected vehicles.
This issue number is SA167.

File Under:
Circulate To:

[J General Manager

Ci Service Advisors

Ci Technicians

Cl Service Manager

Cl Parts Manager

Ci Body Shop Manager Ci Fleet Repair

Page 2 of 5

Service Procedure:

1.

Lower the driver's side window.

2.

Remove the quadrant inner cover (A)
from the driver's door.

Exercise caution when removing
the quadrant inner cover as it can
be easily damaged.

3.

Remove the door panel (B) by referring
to the Service Information on KGIS.

4.

Remove three (3) bolts (C) securing the
side view mirror. Also, make sure to
remove two (2) screws (D) securing the
weatherstrip to the door frame and to
disconnect the side view mirror
connector.

5.

Remove the run channel from the
vehicle.

TSB: BOD 107 I SA 167 Sedona (VQ) August 2014

Page 3 of 5

~-~
COM~Q\~SB/SERVICE ACTION: FRONT DOOR GLASS
·~'.;;:.
.i~,~,~ - f H~NNEL REPLACEMENT (SA 167)
6.

Partially remove the moisture barrier
(E) from the door skin.

7.

Temporarily re-attach the window
switch connector to the door panel.
Then , raise the glass until the bolts
securing the glass are visible through
the mounting holes (F).

8.

Remove two (2) bolts (G) securing the
glass to the window mechanism (H)
and remove the glass from the door.
Tightening torque: 3.98 lb-ft (1.8 Nm)

TSB: BOD 107 I SA 167 Sedona (VQ) August 2014

Page 4 of 5

9.

Before installing the new run channel ,
make sure to cut-off the projection (I)
with a sharp blade, as shown.

Be careful not to damage the run
channel when cutting off the
projection (I).

10.

Carefully install the run channel (J)
around the window frame.

*NOTICE
Check the run channel for proper
installation in order to prevent
possib le water intrusion into the
vehicle.

11.

Install all other removed components
by reversing the order of removal.

When reinserting the glass (K) into
the door, avo id dropping the glass
or scratching the glass surface.
12.

Operate the window to verify proper
operation.

13.

Repeat the steps above to install the glass run channel on the opposite side of the vehicle.

TSB: BOD 107 I SA 167 Sedona (VQ) August 2014

Page 5 of 5

~~~~J$1~'s;B/S'ER.VICE ACTION: FRONT DOOR GLASS

•-!~

(:HANNEL REPLACEMENT (SA 167)

REQUIRED PART:
Part Name

Qty.

Part No. '
82540 4D001 QQK (RH)

Run Assy. Front Door
Window Glass

82530 4D001 QQK (LH)

AFFECTED VEHICLE PRODUCTION RANGE:

.

- '•-

·'

-·

Model

Production Date Range

_A.

L.

-~

I

=-=

From June 15, 2005 through May 06, 2013

Sedona (VQ)

SERVICE ACTION WARRANTY INFORMATION:
Claim
Type

Causal
PIN

Qty.

N
Code

c
Code

Repair
Description

IC

Labor Op '
Op
Time
Code ·'·t
, 1"

Replacement
Qty.
P/N
'

T

v

82540
4D001

0

N86

C09

(SA167)
Door Glass Run
Replace
(FRT/LH/RH)

0.7
M/H

140029RO*

82530
4D001QQK

1

82540
4D001QQK

1

* Includes R&R mirror and door trim panels

STANDARD WARRANTY CLAIM INFORMATION:
Use this information only to file a warranty claim for vehicles for which:
1. A customer compla ins of the same concern, as described on Page 1.
2. The VIN does not appear on the Affected Vehicles list for Service Action 167.
3. The vehicle model year and production date range are as identified in this bulletin
Claim
Type

Causal
P/N

Qty.

N
Code

c
Code

•

-i'.

J

Labor Op . Op
Repa ir
Descript ion . . ' Code l; Time

Replacement
P/N

£•

Qty.

~

~--

w

82540
4D001

0

N86

C09

(BOD 107)
Door Glass Run
Replace
(FRT /LH/RH)

82530FOO*

0.7
M/H

82530
4D001QQK

1

82540
4D001QQK

1

*Includes R&R mirror and door trim panels

*NOTICE
VIN inquiry data for this repair is provided for tracking purposes only. Kia retailers
should reference SA167 when accessing the WebDCS system.

TSB: BOD 107 I SA 167 Sedona (VQ) August 2014